ページ1に含まれる内容の要旨
HC 3360
User manual Cooker Hood
ページ2に含まれる内容の要旨
Contents Safety warnings ................................................................................ 2 For the user ........................................................................................ 2 For the installer ................................................................................... 3 Description of the Appliance ........................................................... 4 Extraction mode .............................................................................
ページ3に含まれる内容の要旨
Safety warnings For the user • The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. • Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. • Also, when frying, keep the deep frying pan on the cooker top/cooker under careful control. • The hot oil in the frying pan might ignite due to overheating. • The risk of self-ignition increa
ページ4に含まれる内容の要旨
For the installer • When used as an extractor unit, the hood must be fitted with a 150mm diameter hose. Should there already be a pipe of diameter 125 or 120 mm that ducts to the outside through the walls, it is possible to use the 150/125- 120 mm reduction flange provided. In this case the hood will be slightly noisier. • When installing the hood, make sure you observe the follow- ing minimum distance from the top edge of the cooking hob/ ring surfaces: electric cookers 500 mm gas cookers 650 m
ページ5に含まれる内容の要旨
• When the hood is used in its extraction mode, the following rules must be followed to obtain optimal operation: - short and straight outlet hose - keep bends in outlet hose to a minimum - never install the hoses with an acute angle, they must always follow a gentle curve. - keep the hose as large as possible (preferably the same diameter as the outlet hole). - the length should be no more than: 3 metres with one 90° bend 2 metres with two 90° bends Bends of more than 90° will reduce the effici
ページ6に含まれる内容の要旨
Recirculation mode • The air is filtered through a charcoal filter and returned to the kitchen. • You will need an original charcoal filter for the recirculation mode. (See Special Accessories). • Fix the deflector using 2 screws Ø 2,9x13 mm. Fig. 2. • Optionally, the position of the chimney elements can be changed. When using the hood in the recirculation mode the chimney must be fixed at the top, with the air outlet grill at the side. Fig. 2 6
ページ7に含まれる内容の要旨
Control Panel • Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the hood’s front panel: • the light switch switches the hood lamp on and off • the motor switch switches the motor off • Speed 1: Speed 1 push-button • Speed 2: Speed
ページ8に含まれる内容の要旨
Maintenance and Care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood • Clean the outside of the hood using a damp cloth and a solution of water and mild washing up liquid. • Never use corrosive, abrasive or flammable cleaning products or products containing bleach. • Never insert pointed objects in the motor’s protective grid. • Only ever clean the switch panel and filter grill using a damp cloth and mild washing up liqu
ページ9に含まれる内容の要旨
Charcoal filter • The charcoal filter should only be used if you want to use the hood in recirculation mode. • To do this you will need an original charcoal filter (Available from your local Service Force Centre). • Cleaning/replacing the charcoal filter Unlike other charcoal filters, the LONGLIFE charcoal filter can be cleaned and reactivated. With normal use the filter should be cleaned every second month (when using the hood 2.5 hours per day,on avarage). The best way to clean the filter is i
ページ10に含まれる内容の要旨
Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb • Disconnect the cooker hood from the mains supply. • Press (1) the lamp cover (2) and open it. Fig. 6
ページ11に含まれる内容の要旨
What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply. Check that a fan speed has been selected The cooker hood is not working Check that: effectively.. The fan speed is set high enough for the task. The grease filters are clean. The kitchen is adequately vented to allow the entry of fresh air. If set up for recirculation, check that the ch
ページ12に含まれる内容の要旨
Special accessories Charcoal filter TYPE 150 LONG LIFE Technical assistance service (not for UK) You are welcome to telephone our technical assistance service (see list of technical assistance centres) whenever you need information or in the unlikely event of a fault. For service in Australia call 1300 650 020. When calling, please be ready to specify: 1. The model code number 2. The serial number (E-Nr.) 3. The manufacturing number (F-Nr.) This information is shown on the registration plate ins
ページ13に含まれる内容の要旨
CUSTOMER CARE DEPARTMENT For general enquiries concerning your AEG appliance or for further information on AEG products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.aeg.co.uk Customer Services Department Major Appliances AEGElectrolux Addington Way Luton Bedfordshire LU4 9QQ 08705 350 350 (*) * calls to this number may be recorded for training purposes. If you require Customer Service in the Republic of Ireland please contac
ページ14に含まれる内容の要旨
Technical Details Dimensions (in cm): Height (extraction): 75 - 113 Height (recirculation): 75 - 122 Width: 59,8 Depth: 47 Maximum absorbed power: 200 W Motor: 1x 170 W Lighting: 2 x 20W (G4) Electrical connection: 220-240 V Length of the cable: 150 cm Mounting accessories included 6 wall plugs Ø 8 mm (brick fixing only) 6 wood-screws 5 x 45 mm 2 metal screws 2,9 x 13 4 metal screws 2,9 x 6,5 5 metal screws 3,5 x 9,5 2 hooks 1 chimney support 2 clamps 1 deflector 1 reduction flange Ø 150-125 mm
ページ15に含まれる内容の要旨
Electrical connection (not for UK) Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary to provide a fixed connection, the hood must only be installed by an electrician authorised by the local electricity board. When installing, an omnipolar
ページ16に含まれる内容の要旨
Wall unit mounting - Fig. 7 • Position the template on the wall (1) and mark the position, and drill (2) the holes (2 x Ø 8 mm). • Mount the two wall plugs with the hooks (3). • Hang the hood on the hooks and level it with the adjustment screws (4). • Remove the grease filters (5) and mark for the two screws (6). Remove the hood and drill the holes (2 x Ø 8 mm). Insert the rawl plugs (7) and hang the hood on the wall again. Adjust it with the screws (8) and secure it with the screws (9). • Moun
ページ17に含まれる内容の要旨
13 K 11 10 16 10 12 12 14 3 16 15 17 4 2 2 * 6 4 4 6 7 1 6 7 9 6 9 18 5 18 *Ø 125-150 mm Fig. 7 17 8 8
ページ18に含まれる内容の要旨
22 240 60 Exhaust tube X Power outlet 20 105 105 105 530-550 Electric hob 500 mm Gas hob 650 mm = = Wall bracket 270 330 Electric hob 500 mm Gas hob 650 mm 18 265 59,8 59,8 100
ページ19に含まれる内容の要旨
19
ページ20に含まれる内容の要旨
LI25YA Ed. 03/07
