ページ1に含まれる内容の要旨
INSTRUCTION BOOK
CHIMNEY HOOD
CH120
cod. 4329622 03 - 010925
ページ2に含まれる内容の要旨
Thank you for buying an Electrolux product. To enable you to use your application effectively and safely, please read this instruction book carefully before using the appliance and retain for future reference. If you require guidance in the use of the appliance or require further information on Electrolux Products, please contact our Customer Care Department. Customer Care Department Electrolux 55 - 77 High Street Slough Berkshire SL1 1DZ Tel: 08705 950 950 To register ownership, please ensure y
ページ3に含まれる内容の要旨
IMPORTANT SAFETY INFORMATION These warnings are provided in the interests of safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. • The ducting system for this appliance must • Installation not be connected to any existing ventilation • Any installation work must be undertaken system which is being used for any other by a q
ページ4に含まれる内容の要旨
150 490 YOUR APPLIANCE OPERATING INSTRUCTIONS The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. The appliance can be installed to recirculate or extract contaminated air. Cooker Hood Controls The cooker hood functions are controlled by three switches located to the right on the underside of the hood immediately in front of the metal grease filters. Worktop Lighting The switch (L) marked with the lamp symbol operates the worktop lighting. 0 1
ページ5に含まれる内容の要旨
To Operate Select the required fan speed and light if required. Recirculation In the recirculation mode the contaminated air enters the cooker hood through the grease filters. The air is cleaned by passing through the charcoal filters before being passed back into the kitchen through the grilles in either side of the chimney stack. Extraction In the extraction mode the contaminated air enters the cooker hood passing through the grease filters and is passed out through the ducting into the atmosp
ページ6に含まれる内容の要旨
MAINTENANCE AND CLEANING Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. The cooker hood must be kept clean, as a build up of grease or fat can be a fire hazard. External Cleaning Wipe the cooker hood frequently with warm soapy water using a mild detergent. Never use scouring pads or abrasive cleaners. Never use excessive amounts of water when cleaning particularly around the control panel. Metal Grease Filters The grease filters absorb grease and d
ページ7に含まれる内容の要旨
Charcoal Filters In the recirculation mode the charcoal filters absorb smells and unwanted odours. The charcoal filters cannot be cleaned, we recommend they should be replaced approximately every three months or more often if the hood is used for more than three hours per day. To Remove/Replace the Charcoal Filters 1. First remove the metal grease filters. 2. Rotate the charcoal filter anti-clockwise (B) and remove. 3. To replace the charcoal filters, remove the metal grease filters. 4. Place th
ページ8に含まれる内容の要旨
SOMETHING NOT WORKING If, having followed these instructions carefully, your cooker hood fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start • Check the hood is connected to the electricity supply. • Make sure the switch is in the ‘ON’ position. The cooker hood is not working effectively • The fan speed is set high enough for the task • The grease filter is clean. • The kitchen is adequately vented to allow the entry of fresh air. • If se
ページ9に含まれる内容の要旨
GUARANTEE CONDITIONS We, Electrolux, undertake that if within twelve months of the date of the purchase this Electrolux built-in product or any part thereof is proved to be defective by reason only of faulty workmanship or materials, the company will, at our option repair or replace the same FREE OF ANY CHARGE for labour, materials or carriage on condition that: • The appliance has been correctly installed and used only on the electrical supply stated on the rating plate. • The appliance has bee
ページ10に含まれる内容の要旨
INSTALLATION INSTRUCTIONS It is dangerous to alter the specifications or attempt to modify this product in any way. Technical Information DIMENSIONS HEIGHT OF CANOPY: 24cm HEIGHT OF CHIMNEY: (UPPER SECTION) 40cm (LOWER SECTION) 36cm WIDTH OF CANOPY: 120cm DEPTH OF CANOPY: 49cm GROSS: 20kg NET: 16,8kg ELECTRICAL SUPPLY: VOLTAGE: (50Hz) 220-240 V POWER CONSUMPTION: 225W FAN MOTOR: 145W LIGHT BULB: (2 x 40 W) 80W SUITABLE FOR INSTALLATION ABOVE: ELECTRIC HOB: 7KW (max) GAS HOB: 10KW (max) SLOT-IN G
ページ11に含まれる内容の要旨
INSTALLING THE COOKER HOOD Please ensure that when the appliance is The manufacturer disclaims any responsibility for installed it is easily accessible to an damage due to incorrect installation of the cooker engineer in the event of a breakdown. hood or if the hood is not installed in compliance with relevant regulations controlling this type of All installations must comply with the local installation. authorities requirements for the discharge of exhaust air. Unpacking The cooker hood is supp
ページ12に含まれる内容の要旨
Clearance Height The cooker hood is designed to be fitted over a cooking appliance at the clearance heights stated, providing the maximum output of the appliance beneath does not exceed the maximums quoted in the Technical Specifications. If the output of the appliance below the cooker hood exceeds the maximum outputs quoted, please refer to the cooker manufacturer’s Hob installation instructions. A minimum clearance height of 650mm (25 1/2 ”) is required when installed above a A: Built-in Elect
ページ13に含まれる内容の要旨
4. Draw a horizontal line through the vertical line at X. X is a distance between the centre of the top and bottom fixing holes on the upper chimney stack. Mark the centre positions for the middle bracket fixing screws (3) at 95mm either of the vertical line (screws not supplied). 5. Drill the holes for the fixing screws using an 8mm masonary drill and fix the wall brackets using the plastic rawl plugs and 44mm screws provided. Ensure the lower bracket (1) is fitted with the lugs at the bottom.
ページ14に含まれる内容の要旨
Venting The hood is more effective when used in the extraction mode (ducted to the outside). Venting kits may be purchased through your retailer or DIY store, and must be ducted to an outside vent of 125mm (5”). The 120÷125mm collar should be fitted onto the ducting spigot to suit UK diameter ducting, and held in position by a jubilee clip (not supplied) used to secure the flexible hose. Where flexible duting is fitted the length should be no more than: 3 metres with one 90º bend, or 2metres w
ページ15に含まれる内容の要旨
Fitting the Chimney Stack The chimney stack consists of two sections. 1. Fit the upper section (S) first. Expand the chimney slightly to allow it to be fitted over the brackets (1) and (2), and then secure the chimney stack to bracket (2) using two self tapping screws provided in the fitting kit. 2. Fit the lower chimney section (I) by expanding the chimney slightly to allow it to be fitted over the brackets (1), and the upper chimney section and bracket (3). 3. Ensure the bottom edge of the chi
ページ16に含まれる内容の要旨
16
ページ17に含まれる内容の要旨
17
ページ18に含まれる内容の要旨
18
ページ19に含まれる内容の要旨
19
ページ20に含まれる内容の要旨
55 - 77 High Street - Slough BERKSHIRE SL1 1DZ © Electrolux Household Appliances Limited 2001
