ページ1に含まれる内容の要旨
OWNER’S MANUAL
For Household Use Only
ページ2に含まれる内容の要旨
TABLE OF CONTENTS Technical Details 2 Important Safety Instructions 3 Special AIRBELT D Product Features 4 ET Power Heads Product Features 5 Optional DISCO Floor Polisher Product Features 6 Optional Attachments, Accessories, Bags and Filters 6 Identification of Parts 7 Standard Attachments 7 Optional Attachments 7 Assembly 7 Operating Instructions 8 Starting the machine with a non-power head attached 8 Additional Instructions for starting the machine with a power head attached 8 Suction Control
ページ3に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE ! When using an electrical appliance, basic precautions must always be followed. To reduce the risk of electric shock, this vacuum cleaner has a polarized plug; one blade is wider than the other. This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the p
ページ4に含まれる内容の要旨
SEBO AIRBELT D4 PRODUCT FEATURES The SEBO AIRBELT D4 is equipped with many extras that will make Comfortable Ergonomic Handle – The AIRBELT handles are your life easier! Its “suction-optimized” airflow pathway, together ergonomically designed and positioned to reduce wrist and arm with its one-of-a-kind tapered-hose technology, provides ultra- fatigue. For extra comfort, an additional swivel is built into the quiet operation and amazing suction power. And the ergonomically handle-to-hose connect
ページ5に含まれる内容の要旨
S u p e r q u i e t a i r e SEBO AIRBELT D4 PRODUCT FEATURES Liberation from Bagless! SEBO Bags are ET Power Heads - Designed for All Floor Hygienic – The three-layer filter bag is an Surfaces. integral part of SEBO’s filtration system because it effectively contains nearly all Deep clean your carpet with a SEBO ET dirt captured by the vacuum. SEBO bags power head. SEBO power heads are virtual- can be sealed when full, so no dust can ly maintenance free, and their electronic escape into the air
ページ6に含まれる内容の要旨
SEBO DISCO FLOOR POLISHER - OPTIONAL FOR THE AIRBELT D4 Polish your hard floor with a SEBO DISCO Ultra-High-Speed floor polisher! 3 The SEBO DISCO (13” wide, 11 ⁄4” polishing width) – It’s never been easier to make hard floors shine! The SEBO DISCO floor pol- isher can both vacuum and polish, for a super-gloss finish. It can be attached to the FELIX uprights or to the AIRBELT canisters. Its suction removes fine dust (dust from fully dried floor polishing product) during polishing, and the 2,000
ページ7に含まれる内容の要旨
IDENTIFICATION OF PARTS 1. Handle grip 14. Hose neck 1 2. Power control slider 15. Cover release catch 3. Handle release button 16. Carrying handle 2 4. Slide Button 17. AIRBELT shock absorber 5. Telescopic tube 18. Filter bag cover 6. On/Off button 19. Suction opening 3 7. Cable rewind button 20. Parking groove 11 8. LED suction-power indicator 21. Power cable 9. Tool release button 22. Dusting brush 4 10. Kombi nozzle (optional) 23. AIRBELT clip 5 11. Hose 24. Upholstery nozzle 12. Bag full or
ページ8に含まれる内容の要旨
0 OPERATING INSTRUCTIONS Starting the machine with a non-power-head attached - Figures 1, 2 & 3 6 Before turning on your canister, make sure that you have a firm hold on the handle grip to keep the 8 machine from moving forward. 1. With the canister On/Off button (6) in the OFF position, and the power control button (2) on the han- dle grip (1) in the OFF (-) position, grasp the plug and pull the power cord (21) out from the power cable recess (figure 3). The power cord (21) should be unwound fr
ページ9に含まれる内容の要旨
0 max. Suction Control - Figure 7 The suction power will automatically increase from standby to maximum power after the 2 machine is switched on. You can override this process by pressing the plus (+) or minus (-) on the power control button (2) conveniently located on the handle grip (1). Press the plus on the button for maximum suction or press the minus to reduce suction for vacuuming curtains or delicate fabrics. You may adjust the suction control with the power control button (2) as you 1 v
ページ10に含まれる内容の要旨
Retracting the Cord - Figure 13 To retract the cord, switch the vacuum off, unplug it from the outlet, then press the cord rewind button (#7, figure 13) and the mechanism will automatically rewind the cord. You must hold the button down until the cord is fully rewound. Hold plug while rewinding into the cord wheel. Do not allow the plug to whip while rewinding. The rewind mechanism will stop automatically 7 when you release the button. Before rewinding the cable, always switch off and unplug
ページ11に含まれる内容の要旨
VACUUM MAINTENANCE Always unplug vacuum from outlet ! before dismantling any part of machine! 18 15 Changing the Filter Bag - Figures 22, 23, 24, 25 & 26 To change the filter bag (40), switch off the power and unplug the vacuum. Lift the cover release catch (#15, figure 22) and raise the filter bag cover (18). Seal the filter bag with the sealing cap (49). Lift the filter bag out of the holder by tilting the green collar (50) up and pulling it out of the holder as shown in figure 23. Figure 22 I
ページ12に含まれる内容の要旨
Changing the Motor Filter - Figures 28 & 29 18 The motor filter (42) needs to be changed when it becomes extremely dirty or clogged. 15 To remove the motor filter, switch off the power and unplug the vacuum. Lift the cover release catch (#15, figure 28) and raise the filter bag cover (18). Pull the filter (42) out by grasping the rubber rim (#57, figure 29) of the filter and pulling it out of the groove (#56, inset, figure 29) that holds it. Fit the new filter into the groove and push the rub- b
ページ13に含まれる内容の要旨
CLOG REMOVAL Always switch off power and unplug vacuum from outlet 64 ! before removing any clogs! NOTE! D4 users with ET-1, ET-2 or DISCO power heads, please refer to your power head user’s manual for more detailed instructions for removing clogs in your power 9 head. 63 If the “bag full or clog” warning indicator (12) remains orange after the filter bag has been changed and the filters are in good condition, there is likely a clog in the sys- tem. Figure 34 Clogs in the Head or Brush - Figure
ページ14に含まれる内容の要旨
TROUBLE-SHOOTING GUIDE Always unplug vacuum from outlet before dismantling any part of the machine! ! PROBLEM REASON SOLUTION Does not turn on 1. Telescopic tube not inserted properly. 1. See page 7. 2. Not plugged into working outlet. 2. Use another outlet. 3. Cable worn. 3. Replace cable. 4. The power control button 4. Set power control button to “+” switch is set to “-” (“off” position). position. See page 9. Bag full or clog light on 1. Bag full. 1. Replace filter bag. See page 11. Bag full
ページ15に含まれる内容の要旨
AIRBELT D4 SCHEMATIC AND PARTS LIST Canister with Handle/Hose 90640AM Premium D4 - Black (Onyx) 90630AM D4 - Red 90641AM Premium D4 - White 90641AM Premium D4 - White Machine 26 Pos. Part # Description 47 1 8001WEER Bottom casing (2) 28 45 2 8086 Castor cpl 23 25 24 3 8065ER Micro filter seal 4 8191AM a) Hospital-grade micro filter & 27 47 b) Motor filter = Microfilter set 53 5 8084ER Micro filter holder 6 8120AM Filter bag 38 7 8045ER Motor support 8 8091AM Internal cable set 9 8048ER 1200W Vac
ページ16に含まれる内容の要旨
SEBO VACUUM CLEANER WARRANTY 1. Your authorized SEBO dealer or SEBO will provide the 7. The Wear Parts excluded from warranty coverage original product purchaser with replacement of Non- include filter bags, motor filters, micro filters, the Wear Parts which fail due to a material or workman- cable (external cord), the attachment hose, the brush ship defect for a period of five (5) years from the orig- rollers, the front bottom plate, the rear bottom plate, inal date of purchase of new product.
