ページ1に含まれる内容の要旨
Heavy Duty
Upright
Vacuum Cleaner
Household Type
Owner’s Guide
600 Series
Index
Important Safeguards ...................... 2
Service Information .......................... 4
Assemble ......................................... 5
Use ................................................... 7
Dust Bag .......................................... 8
Brush Roll Belt ................................. 9
Brush Roll ...................................... 10
Headlight .........................................11
F
ページ2に含まれる内容の要旨
IMPORTANT SAFEGUARDS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. WARNING To reduce the risk of fire, electric shock, or injury: Do not use outdoors or on wet surfaces. Do not leave vacuum cleaner when plugged in. Turn off the switch and unplug the electrical cord when not in use and before servicing. Do not allow to be used as a toy. Close attention is necessary when used b
ページ3に含まれる内容の要旨
CONSEILS DE SÉCURITÉ Lors de l’utilisation d’un appareil électrique, quelques précautions élémentaires doivent être observées, incluant les suivantes: LISEZ TOUTES LES INSTRUCTIONS AVANT D’UTILISER VOTRE ASPIRATEUR. AVERTISSEMENT Pour réduire le risque de feu, de choc électrique, ou de blessure: Ne pas utiliser à l’extérieur ou sur des surfaces mouillées. Fermez le commutateur et débranchez l’appareil lorsque vous ne l’utilisez pas ou avant le nettoyage ou l’entretien. Ne permettez pas qu’
ページ4に含まれる内容の要旨
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. Afin de réduire le risque de choc électrique, cet appareil est muni d’une fiche polarisée (une des lames est plus large). Cette fiche ne peut être
ページ5に含まれる内容の要旨
HOW TO ASSEMBLE CAUTION: Completely assemble vacuum cleaner before using. Assembly Packet is with owner’s guide. A B C D 2-Part Upper Lower Bag Bolt Cord Hook Cord Hook Screws Step 1 Attach the Handle Push the handle sections together. Note: Check to be sure slots in handle are correct, see Detail A. Align the holes in the handle. Insert a 2-part bolt (A) in the center of the handle and tighten. B Push handle into the handle socket so handle grip curves away from the cleaner. Align the hole
ページ6に含まれる内容の要旨
Step 2 Attach Upper Cord Hook Pull the flexible cord support up toward the top of the handle. Insert the lower half of the cord support into the B upper cord hook. Check to be sure slots in handle are correct, Flexible see Detail A. Place inner tab of cord hook into Bag Cord handle slot as shown (1) and press hook handle Support Support (2) SNAPPING opposite inner tab into place (3). Hook 1. Place inner tab 2. Press hook 3. SNAP opposite inner into slot around handle tab into place St
ページ7に含まれる内容の要旨
HOW TO USE The upright vacuum cleaner is designed to be used on multiple types of carpeting. Do not attempt to use the upright vacuum cleaner on bare floors, as damage to the floor covering may result. Above the floor cleaning tools are available (optional). 1. Store 2. Use Handle Adjustment With the tip of the foot, press down to release the handle lock located at the left rear side of the cleaner. Move the handle and adjust it to the desired position for (1) storing upright, (2) operating the
ページ8に含まれる内容の要旨
THROAT HOW TO MAINTAIN The instructions given in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the bag, belt and brush roll often. Disposable Dust Bags Paper bags play a very important role in the efficiency of a vacuum cleaner. The purpose of a paper bag is to trap dirt. But at the same time the paper bag must be porous enough to allow air to pass through. If the paper bag becomes clogged, no air can pass through the cleaner and no cleaning can
ページ9に含まれる内容の要旨
Brush Roll Belt The brush roll belt on the upright vacuum cleaner drives the brush to agitate, sweep, and comb the carpet nap. The belt should be checked regularly to be sure it is in good condition. Replace the belt if it is stretching, cracking, or slipping. Cut away any hair or thread wound around the brush roll or the belt pulley because the buildup could cause the belt to rotate unevenly. How To Replace A Worn Belt NOTE: Turn off the switch and unplug the electrical cord before replacing
ページ10に含まれる内容の要旨
Brush Roll The rotating brush roll sweeps and combs the carpet nap. Keep the brush roll free from hair and threads so it will continue brushing. When the bristles of the brush roll no longer touch a straight edge held across the bottom plate, the brush roll is ineffective because the bristles no longer touch the carpet nap. To maintain the most effective cleaning, replace the wood brush roll. Install new brush strips on the chromed steel brush roll (refer to instructions). How To Replace Worn Br
ページ11に含まれる内容の要旨
Headlight Bulb (Standard on most models) NOTE: Turn off the switch and unplug the electrical cord before replacing headlight bulb. Headlight style varies by model. Locate the notches that release the tabs at either (1) top, (2) side, or (3) bottom of the lens, as illustrated. Place a screwdriver into one notch; twist or pry the screwdriver to release the lens. Repeat for the second notch on the opposite side. Rotate the bulb socket forward. Push bulb in and turn to remove. Secure
ページ12に含まれる内容の要旨
©1999 White Consolidated, Ltd. Part No. 57825A (4/02) Printed in U.S.A.
