ページ1に含まれる内容の要旨
™
®
ENGLISH pp. 1-17
™
ESPAÑOL pág. 18-27
FRANÇAIS p. 28-37
Deep Cleaner
The Easy to Use Deep Cleaner
SteamVac™ Dual V™ Deep Cleaner cleans carpet fibers
by applying hot tap water and cleaning solution.
www.hoover.com
ページ2に含まれる内容の要旨
Grounding Important Safeguards! Instructions When using an electrical appliance, always follow basic precautions, including the following: A READ ALL INSTRUCTIONS BEFORE USING APPLIANCE. B WARNING: To reduce the risk of fire, electric shock, or injury: • Use indoors only. • Do not use with damaged cord or C • Use only on surfaces moistened by plug. If appliance is not working as it the cleaning process. Do not immerse should, has been dropped, damaged, This appliance must be grounded. If it prod
ページ3に含まれる内容の要旨
Thank you for choosing a HOOVER product. Contents Important safeguards . . . . . . . . . . 2 If you need any assistance: Parts needed for assembly. . . . . . . 3 Visit our website at www.hoover.com. Click on the “Service” button to find Assembling deep cleaner . . . . . . 4-6 the service outlet nearest you OR Deep cleaner description . . . . . . . . 7 Call 1-800-944-9200 for an automated referral of service outlet locations (U.S. General operation . . . . . . . . . . . . 7-9 only) OR Filling
ページ4に含まれる内容の要旨
The assembled cleaner will look like this 1-2 1-3 C drawing. Model with SpinScrub™ hand tool is shown. B A NOTE: If the cord protector (A) on back Attach upper handle of handle should become dislodged Remove clean water tank (upper tank) during unpacking, make sure it is repo- from deep cleaner. sitioned properly before continuing with assembly of your deep cleaner. With the arrow (B) on the cord protector pointing down, press groove (C) in the cord protector into slot in the lower handle. 1-5
ページ5に含まれる内容の要旨
1-9 1-10 1-11 I H G I J Rotate top of caddy toward cleaner Identify the hose parts before storing Storing hose and handle. Slide caddy down so notch (G) hose. tools on caddy rests in hook (H) on cleaner. I. Nozzle connector end Press hose, a few inches from nozzle J. Solution tube connector end (I), into caddy. Bring hose up and over top of caddy. 1-12 1-13 1-14 M J L K Press hose into opposite side of caddy. Loop hose over top of caddy again. Repeat on other end of hose. Loop hose at bottom of
ページ6に含まれる内容の要旨
1-18 1-19 Pull tool down and outward. How to reattach tool To reposition the tool, reverse this proce- cover dure. The tool cover is designed with a break- away feature which allows it to snap free if it is pushed open too far. To reattach, align hinges of cover with holes on sides of tool storage area. Snap door into place. 6
ページ7に含まれる内容の要旨
2. How to use The assembled deep cleaner will look like the drawing. Deep Cleaner Description Model with SpinScrub™ hand tool is shown. 1. Hand grip 2-1 2. Solution trigger: press to release cleaning solution 1 3. ON/OFF switch 3 2 4. Wash/Rinse switch 4 5. SpinScrub™ hand tool (not included with all 17 models) 6. Carrying handle 7. Clean water tank handle 19 5 8. Clean water tank 18 9. Detergent container 10. Recovery tank handle 6 20 11. Recovery tank: holds dirty solution 7 9 12. Recovery
ページ8に含まれる内容の要旨
2-6 2-7 2-5 B Automatic shut off Brush setting selector Carrying handle When the recovery tank (lower tank) is full Your ‘SteamVac’ deep cleaner has two The deep cleaner may also be lifted by the automatic shutoff mechanism will shut agitator brush settings. placing a hand above the upper clean off the deep cleaner suction (suction will ON - for cleaning of carpet and bare solution tank handle as shown. be noticeably reduced). floors At that time, the yellow float disk will rise OFF - for cleani
ページ9に含まれる内容の要旨
2-12 2-13 2-11 E F Carry tank to a sink. Fill tank (E) (1 gallon) with hot tap water. To fill detergent container (F), turn cap counterclockwise and remove cap. CAUTION: Do not fill with water above Turn tank cap counterclockwise and 140˚F (60˚C). remove cap. Replace tank cap and tighten. NOTE: Use only HOOVER detergents. 2-14 2-15 They are specially formulated for use with your ‘SteamVac’ deep cleaner. CAUTION: Detergents contain Anionic and Nonionic Surfactants. Avoid contact with eyes and ski
ページ10に含まれる内容の要旨
d. When cleaning entire floor, move f. To prevent staining, use plastic or alu- furniture out of area to be cleaned minum foil to protect wood or metal sur- 3. How to clean (may not be necessary if only high traf- faces from possible water spray. fic areas are to be cleaned). For furni- g. To avoid wetting and possible damage Before you begin ture too heavy to move, place aluminum to wood floors underneath area rugs/car- foil or wax paper under legs. This will cleaning pet, either move area rugs
ページ11に含まれる内容の要旨
To clean nozzle 3-4 If lint or other debris becomes lodged in A nozzle, it can be removed for cleaning. B 3-3 To replace nozzle, line up tabs (A) on nozzle with holes (B) in cleaner. Slide tabs into holes. Slide nozzle completely onto cleaner. Unplug deep cleaner from electrical Press down on nozzle to secure it. outlet. Replace recovery tank (Fig. 2-17). Remove both tanks as described in Fig. The nozzle must be in the proper 2-16. With handle in upright position, tilt position in order for th
ページ12に含まれる内容の要旨
R B O A T R E A T F L E O O O R N 6. Set Wash/Rinse switch to WASH. Turn 3-9 Cleaning bare floors cleaner ON. 7. To release solution, press trigger. How to attach bare floor Slowly move deep cleaner forward and attachment backward over area to be cleaned. (Available at additional cost if not includ- 8. To pick up dirty solution, release trig- ed with your cleaner.) ger and slowly move deep cleaner over area where solution has just been dis- Unplug deep cleaner from electrical persed. Use both fo
ページ13に含まれる内容の要旨
Select tool How to attach tools Your model includes some combination G. SpinScrub™ hand tool has rotating 3-14 of the following tools, but may not brushes for extra scrubbing action on include them all. J small carpet areas, carpeted stairs and upholstery. For some models, the 3-13 brushes can be removed for converting to the scrub module. H. Stair/upholstery nozzle has a built-in H brush to help provide the scrubbing action some spots may need for G removal. I. Scrub module with detachable K s
ページ14に含まれる内容の要旨
After using scrub tool 3-18 To clean scrub pad, pull it off module. Wash it in water with mild detergent. Rinse and let air dry. Pad must be com- pletely dry before reattaching to module. Replacement pads may also be pur- chased. Ask for HOOVER part no. 40308001. Using the scrub tool With a little solution, test the scrub tool on a hidden area before using on the desired surface. If no surface change is visible, continue to use as described below. 1. Attach hose and solution tube as instructed i
ページ15に含まれる内容の要旨
3-21 3-22 Cleaning upholstery Read “Before you begin cleaning” instructions on page 9. Be sure to check the cleaning code on your upholstery. Use your deep cleaner only on upholstery marked “W” or “W/S”. 1. Attach hose and solution tube as instructed in Figs. 3-10 to 3-12. 2. Place handle in upright position. Agitator brushes will not rotate while 8. Gently press the tool onto the fabric. Make no more than 2 passes with the handle is in upright position. Press the trigger and slowly pull the
ページ16に含まれる内容の要旨
Possible cause 5-1 Storage 5. If you have a A Possible solution Before storing: • Recovery tank full/automatic problem • Empty clean water tank and let air If a minor problem occurs, it usually can A dry. Replace on deep cleaner. be solved quite easily when the cause is • Unused detergent can be stored in found by using the check list below. the detergent container. • Empty recovery tank, rinse tank Problem: Machine won’t run and lid thoroughly with clean water Possible cause and let air dry.
ページ17に含まれる内容の要旨
Full One Year Service To obtain approved HOOVER service Warranty and genuine HOOVER parts, locate the (Domestic Use) nearest Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot) by: Your HOOVER® appliance is warranted •checking the Service section of The in normal household use, in accordance Hoover Company on-line at with the Owner’s Manual against original www.hoover.com OR defects in material and workmanship for a period of one full year from date of pur- • chec
