ページ1に含まれる内容の要旨
NV70
Owner’s Guide
www.sharkclean.com
NV70_26_IB_E_130228_1.indd 1 13-02-28 1:48 PM
ページ2に含まれる内容の要旨
This manual covers model number: NV70 26 TECHNICAL SPECIFICATIONS Voltage: 120V. Watts: 1200W Amps: 10A Hertz: 60Hz Euro-Pro, Shark and Navigator are trademarks of Euro-Pro Operating LLC. All other brand names may be trademarks of their respective owners. TOLL FREE: 1-800-798-7398 NV70_26_IB_E_130228_1.indd 2 13-02-28 1:48 PM
ページ3に含まれる内容の要旨
Contents Important Safety Instructions 2 Thank you for purchasing Getting Started 4 ® the Shark Using the Vacuum 6 ™ Navigator Cleaning with the Vacuum Accessories 7 DLX. Emptying the Dust Cup Assembly 8 Proper Care of Your Vacuum 9 Troubleshooting 10 Checking for Blockages 11 Maintenance 12 Warranty and Registration 13 www.sharkclean.com 1 NV70_26_IB_E_130228_1.indd 1 13-02-28 1:48 PM
ページ4に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS For Household Use Only WARNING: ® WHEN USING YOUR SHARK TO REDUCE THE RISK OF FIRE, ELECTRIC ™ NAVIGATOR DLX VACUUM, BASIC SHOCK OR INJURY: SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE GENERAL ELECTRICAL SAFETY: FOLLOWING: 1. U nplug from electrical outlet when not in use and before servicing. READ ALL INSTRUCTIONS BEFORE USING ® ™ YOUR SHARK NAVIGATOR DLX 2. DO NOT use vacuum with a damaged cord or plug. If appliance is not working as it VA
ページ5に含まれる内容の要旨
DUST CUP/FILTERS/ACCESSORIES: HOSE ATTACHMENTS: 1. DO NOT use if air flow is restricted; if the air Before turning on the vacuum: paths, the hose, or the accessories become 1. M ake sure that all filters are thoroughly dry blocked, turn the vacuum cleaner off. Remove after routine cleaning. all obstructions before you turn on the 2. M ake sure that dust cup and all filters are in unit again. place after routine maintenance. 2. K eep the end of the hose and accessory 3. M ake sure accessor
ページ6に含まれる内容の要旨
Getting Started 8 C D 4 A 5 7 E B 2 3 F G H ® ™ Your Shark Navigator DLX 5 Secure the handle assembly in is easy to assemble: place with included nut/bolt (shipped attached to handle WHAT’S IN THE BOX YOU JUST 1 L ay your vacuum body on a assembly). OPENED: level surface. 6 P lace the vacuum in the upright A Vacuum Body 2 Slide the electrical connection position. B Floor Power Nozzle from the power nozzle into the main body to click into place. 7 I nsert the Cleaning Wand into C Hand
ページ7に含まれる内容の要旨
9 10 c a d b 9 Attach the Super Stretch Hose: 10 To store the vacuum: 11 To carry the vacuum: a) S nap hose into swivel W hen storing your vacuum, With the unit in the standing connector wind the cord around the two position, lift by the Dust Cup cord holders and secure with Assembly Handle (carry handle). b) Route under anti-tip hook cord clip: to prevent vacuum from CAUTION: When lifting or tipping • Q u i c k C o r d r e l e a s e a t t h e carrying, DO NOT press Dust top of
ページ8に含まれる内容の要旨
Using the Vacuum IMPORTANT: To protect your Release suction for carpets, the brushroll will only easier push and pull 4 turn on when you have pulled on high pile carpets the handle back towards you and and area rugs. released the Floor Power Nozzle. 3 Power Switch Settings OFF Suction Release 6 Bare Floors / Tools Carpets 2 ® ™ Your Shark Navigator DLX 5 Press the On/Off switch to the“I" IMPOR T ANT : Vacuum can be used to clean bare position to vacuum bare floors or Your Brus
ページ9に含まれる内容の要旨
Cleaning with the Vacuum Accessories 1 2 3 4 5 3 4 2 Using the Cleaning Wand: 5 Stand the vacuum into upright position. Remove the Cleaning Wand (with hose attached) from the unit. Vacuum Accessories Before cleaning with your Push the selected tool into the accessories: Your vacuum comes with a Super end of the Cleaning Wand. Stand vacuum into upright position. Stretch Hose and Cleaning Wand. 3 P et Hair Power Brush Use one or the other to attach your Secure Super cleaning acce
ページ10に含まれる内容の要旨
Maintenance CAUTION: For best results empty the Dust Cup Unplug the vacuum; failure to do Assembly after each use, as needed so might result in electric shock. during prolonged usage or when it reaches the MAX fill line. DO NOT OVERFILL. Turn vacuum off before emptying. 2 1 3 To empty the Dust Cup: 3 Option B: For Allergy Sufferers: Note: Some dust and debris Wrap a trash bag around the may remain in the top of your 1 Grip carry handle and press Dust Cup leaving space at the dust cu
ページ11に含まれる内容の要旨
COMPONENT MAINTENANCE SCHEDULE 1 Dust Cup Empty each time you vacuum. Pre-Motor Foam Filter Rinse and air dry every month under normal use. 2 Pre-Motor Felt Filter Rinse and air dry every month under normal use. 3 4 Post-Motor HEPA Filter Clean once a year under normal use. DO NOT operate the vacuum without ALL the filters in place. IMPORTANT: Loss of Suction may occur if foam filter is not cleaned DO NOT operate the vacuum with WET filters. every month. Rinse and allow to air dry compl
ページ12に含まれる内容の要旨
Troubleshooting WARNING: to reduce the risk of electric shock, the power cord must be disconnected before performing maintenance/troubleshooting checks. PROBLEM POSSIBLE REASONS & SOLUTIONS Check filters to see if they need cleaning. Follow instructions for rinsing and drying the filters before re-inserting back into the vacuum. (See “Maintenance” sections for instructions.) Vacuum is not Dust cup may be full; empty dust cup. picking up dirt. Check hose and hose connections for blockages; c
ページ13に含まれる内容の要旨
Checking for Blockages 2 1 4 3 1 Dust Cup Air Duct: 3 Floor Power Nozzle Hose Unplug the vacuum before Connector: checking for blockages. Stand vacuum into upright position. Lay vacuum flat. Remove Dust Cup Assembly and Remove Nozzle Hose and check Reassemble all parts securely empty Dust Cup if necessary. for clogs. before operating vacuum. Disconnect the Super Stretch Push the Hose Connector back Hose. onto the Floor Power Nozzle. Blockages may cause your vacuum Check Air
ページ14に含まれる内容の要旨
Maintenance a Rotating Brush Cleaning The Pet Hair Brush 1 Slide the locking latch (a) forward and tilt the bottom cover upward to remove. 2 C arefully remove any blockage or debris and cut away any build-up of hair or string wrapped around the rotating Cleaning The Motorized Floor Resetting the Motor Thermostat bristle brush with scissors. Brush ® Your Shark Navigator™ 3 To reassemble, insert the tabs When your motorized floor brush DLX Vacuum is equipped with on the front edge of th
ページ15に含まれる内容の要旨
Euro-Pro Five-Year (5) Limited Warranty EURO-PRO Operating LLC warrants this product to be free from defects in material and workmanship for a period of five (5) years from the date of the original purchase, when utilized for normal household use, subject to the following conditions, exclusions and exceptions. If your appliance fails to operate properly while in use under normal household conditions within the warranty period, return the complete appliance and accessories, freight prepaid to:
ページ16に含まれる内容の要旨
Euro-Pro Operating LLC USA: Newton, MA 02459 CAN: 4400 Bois Franc, St-Laurent, QC H4S 1A7 English: 1-800-798-7398 www.sharkclean.com Copyright © Euro-Pro Operating LLC 2013 Euro-Pro, Shark and Navigator are trademarks of Euro-Pro Operating LLC. All other brand names may be trademarks of their respective owners. Printed in China Illustrations may differ from actual product. NV70.E.130228.1 NV70_26_IB_E_130228_1.indd 14 13-02-28 1:48 PM
