ページ1に含まれる内容の要旨
Amplifiers & Preamplifiers
INSTALLATION INSTRUCTIONS
RC68+
PROGRAMMER / REMOTE CONTROL
The RC68+ programmer is a 55 key hand-held device that generates all the IR
codes necessary for the set up and operation of Xantech IR remote controlled
A
A B C ADJ-OFF
products. Such products include models ZPR68, RAT1, MIRV1, GATEKEEP-IR,
80 48 10 90 01
12 3 4
etc. The RC68+ is an upgrade of the previous 32 key RC68. While providing
00 C0 50 D0 41
INPUT
additional key-code command capabilities, it retains
ページ2に含まれる内容の要旨
F F F F F F E E E E E E D DD D D D C C C C CC B B B B B B A A A A A A 9 9 9 9 9 9 COMMAND DEFINITIONS • For detailed information that defines the button commands relating to each overlay, refer to the Installation Instructions that come with each specific Xantech model. • The only exception to this is for the model ZPR68; complete command definitions for it are included on the pages that follow. 1 1 The following list itemizes and de- scribes the full set of button commands 18 2 A for operation
ページ3に含まれる内容の要旨
Amplifiers & Preamplifiers 9. BALANCE buttons. When the BALANCE "arrow" buttons are pressed, the audio output will move to the left or right (with a 2 dB/step reduction in the attenuated channel) with each left or right press. NOTE: No change will occur if the BALANCE buttons are held down continuously! 10. Balance "Center" button. This button, when pressed (identified by a "—" mark), will instantly return the balance to the center position (equal volume in each channel) from any previous s
ページ4に含まれる内容の要旨
F F F F E E E E D D D D C C C C B B B B A A A A 9 9 9 9 CODE GROUP SETTING PROCEDURES Use these procedures to: a) Select the Code Group Number on the RC68+ to match the Code Group Number internally preset at the factory for the specific Xantech model you wish to control. b) Change the Internal Code Group Number of a Xantech model. You would do this to avoid mutual interaction when using two or more of the same model on the same IR network (bus). Setting the RC68+ Code Group Number 1. Using the
ページ5に含まれる内容の要旨
F F F F F F F F E E E E E E E E D D D D D D D D Amplifiers & Preamplifiers C C C C C C C C B B B B B B B B A A A A A A A A 9 9 9 9 9 9 9 9 RC68+ RC68+ (rear (rear panel) panel) CODE GROUP CODE GROUP 2nd Digit 1st Digit 2nd Digit 1st Digit (Right) (Left) (Right) (Left) FIG. 6 Setting the code switches to the newly changed FIG. 5 Switches set to FF for Code Group changes. code. Refer to step 6. (30 shown for MIRV1/RAT1). Refer to step 2. 2. Using a small blade screwdriver, rotate each of the tw
