ページ1に含まれる内容の要旨
General Mobile Radio Service (GMRS)
Model: GMRS100
Owner's Manual
HILO
MODE
128-XXXX
Released: 3-10-03
1 of 24
ページ2に含まれる内容の要旨
CAUTION NEVER ATTEMPT TO CHARGE ALKALINE OR DRY CELL BATTERIES, AS BATTERIES MAY BURST CAUSING PERSONAL INJURY AND DAMAGE TO THE PRODUCT. WHEN RECHARGING NICKEL METAL HYDRIDE (Ni- MH) BATTERIES WITH THE SUPPLIED AUDIOVOX CHARGER AND WALL ADAPTER, USE ONLY AUDIOVOX-APPROVED RECHARGEABLE BATTER- IES. USE OF THE AUDIOVOX CHARGER WITH OTHER BRANDS OF BAT- TERIES IS NOT RECOMMENDED, AS BATTERY CHARGING TIMES WILL VARY WITH DIFFERENT BRANDS. REFER TO THE MANUFACTURER’S INSTRUCTIONS FOR CHARGING OTHE
ページ3に含まれる内容の要旨
ページ4に含まれる内容の要旨
Model GMRS100 DISPLAY 6 1 7 2 HILO 8 3 9 4 10 11 5 1. Roger Beep Tone Indicator: This icon appears when the Roger Beep tone is on, and disapppears when the tone is not in use. 2. Transmit Indicator: Icon appears when the unit is in the transmit mode (PTT button activated or VOX mode active). 3. Busy Indicator: This icon appears when the unit is receiving a transmission. 4. Large Segment Display: Indicates the channel number in use between 1 and 22. 5. Scan Indicator: This function allows th
ページ5に含まれる内容の要旨
Equipment and Accessories Supplied 1. Radio (4) GMRS100 2. Owner’s Manual (1) 128-XXXX Optional Accessories 1. Rechargeable Batteries (4) NiMH, P/N GMRS1222BAT 2. Boom Microphone/Headset GMRSBHST4 3. Leather Carrying Case GMRS1502LC Powering the transceiver: Your GMRS100 radio transceiver operates on four rechargeable batteries. Only approved rechargeable batteries can be recharged in the GMRS4WM wall mount charger. This will ensure optimum performance for the GMRS100. Battery charging time is
ページ6に含まれる内容の要旨
ページ7に含まれる内容の要旨
The following guidelines will improve performance and provide longer operating times for the GMRS100: 1. Do not mix old and new batteries. 2. Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries. 3. If the unit is not to be used for an extended period of time, remove the batteries. Old or leaking batteries can cause damage to the unit and will void the warranty. MIC/CHG/ SPK JACK HILO MODE GMRS100 NOTE : Only Audiovox approved rechargeable batteries (P/N GMRS1222BAT) can be rec
ページ8に含まれる内容の要旨
GMRS100 OPERATIONAL MODES GMRS/FRS CHANNEL (MODE) (1-22) SELECT CTCSS (oF, 01-38) SELECT POWER (GMRS channels only) SELECT ROGER (on or oF) BEEP NOTE: To differentiate between operating modes, look for HI or LO indication below the battery power level indicator when in GMRS mode.Refer to the appropriate section of this manual for de- tailed operating instructions for each mode. Channels 1 through 7 are shared GMRS/FRS. Channels 8 through 14 are FRS only, and channels 15 through 22 are GMRS only.
ページ9に含まれる内容の要旨
volume. The display will indicate the current volume level (VL) followed by the number (0-7). As volume is increased upward, the unit will beep at each step, and vice-versa. When the minimum and maximum volume settings are reached, a unique tone will sound. Monitor/Display Backlight Button (2) This button is used to to check activity on the current frequency before transmitting. Check activity by pressing the Monitor (M) Button longer than 2 seconds; the icon will apppear on the display a
ページ10に含まれる内容の要旨
Up Channel/Volume Button (10) In the standby mode, pressing this button will increment the listening volume. When in function edit mode this button will be used to adjust the unit’s settings. Down Channel/Volume Button (11) In the standby mode, pressing this button will decrement the listening volume. When in function edit mode this button will be used to adjust the unit’s settings. MODE Button (12) This button is used to select various feature settings in the GMRS and FRS modes. External Speake
ページ11に含まれる内容の要旨
Operating Modes and Features GRMS/FRS Operation: - Press and hold the Power On/Off button for 2 seconds to turn on power. - Press the MODE button so the Channel number flashes. - Select the desired channel with the Up (10) and Down (11) Buttons. When receiving a call, the icon appears to indicate an incoming call. - Press and hold the PTT button (4) to transmit, then speak into the microphone clearly and slowly. The Transmit icon ( ) appears on the display while the button is pressed. - Re
ページ12に含まれる内容の要旨
To change the channel: - From GMRS/FRS standby mode, press the MODE button (12) once the channel number flashes. - Press the Up Button (10) briefly to move to the next higher main chan- nel number. - Press the Down Button (11) briefly to move to the next lower main channel number. - Press the PTT button momentarily to confirm selection. CTCSS Mode (Sub-Channel) Selection The Coded Tone Controlled Squelch System (CTCSS) has 38 Sub-Frequencies. This feature allows you to utilize the coded squelch
ページ13に含まれる内容の要旨
Transmit Power Selection Mode (GMRS Channels Only) This feature permits selection of the transmitting power level to high or low when using channels 1-7 and 15-22. Using low power, the unit will have a lower transmit range, but battery life will be increased. NOTE: You will find that for the majority of your needs, the low-power setting will provide adequate communications on all channels; there should seldom be any need to use high power, except in situations where you need absolute maximum ran
ページ14に含まれる内容の要旨
To enable and disable the Roger Beep tone: - From GMRS/FRS standby mode, press the MODE Button 4 times (in FRS mode, 3 times) until the flashing Roger Beep icon ( ) appears with On or oF. - Press the Up or Down Button to select the tone on or off as desired. - When enabled, the tone icon ( ) appears steady on the display. - Press the PTT button momentarily to confirm selection. VOX Selection Mode This option enables you to have hands-free conversation. When using the internal microphone/speaker
ページ15に含まれる内容の要旨
Channel Scan Operation This feature allows you to monitor all channels automatically for valid signals. While scanning, you can transmit and receive. When a signal is received, the scan is interrupted and will return to scan mode approxi- mately 5 seconds after reception is terminated. NOTE: While the SCAN mode is active, the MODE button is inopera- tive. In addition, the scan mode will reduce the overall battery life since the battery save function is overridden. To enable the channel scan mo
ページ16に含まれる内容の要旨
Battery Alert When the battery icon ( ) blinks steadily on the LCD panel, recharge the unit or install fresh batteries. NOTES FOR GOOD COMMUNICATION 1 . The GMRS100 22 channels are shared on a ‘take turns’ basis. This means other groups may be talking on any of the channels. A common code of ethics/courtesy is to switch to another vacant channel and not to attempt to talk over someone who is already using the channel you first selected. 2. The GMRS100 has been designed to maximize performance an
ページ17に含まれる内容の要旨
Do not attempt to modify or in any way increase the output of this transceiver. Its output is designed to meet the legal limits set by the FCC. Do not use this device or change its batteries in potentially explosive atmospheres as sparks in such areas could result in an explosion. Turn your transceiver off wherever posted notices restrict the use of radios or cellular telephones. Facilities such as hospitals may use equipment that is sensitive to RF energy. Turn your transceiver off on b
ページ18に含まれる内容の要旨
Troubleshooting Problem Possible cause Correction No transmission Weak batteries Charge or replace batteries while pressing Incorrect battery polarity Install the batteries the PTT Button following the directions in paragraph Installing the Batteries. Weak or no Weak batteries Charge or replace batteries signal received Channel and privacy Adjust the transceiver’s code not set the same settings to match those as target transceiver settings of the target transceiver Volume level too low Increase
ページ19に含まれる内容の要旨
T T T T Tec ec ec ec echnical Specif hnical Specif hnical Specif hnical Specif hnical Specifica ica ica ica ications: tions: tions: tions: tions: General General General General General Frequency Range: Channels 1 through 7 are shared with FRS radios. Refer to frequency chart on next page. Channels 8 through 14 are FRS only. Refer to frequency chart on next page. Channels 15 through 22 are GMRS only. Refer to frequency chart on next page. Channel Spacing 12.5kHz Privacy Codes 38 for eac
ページ20に含まれる内容の要旨
This transceiver complies with FCC regulations for use in the United States of America. Use in other countries may be prohibited or restricted by local regulation. Please check with the local regulating agency be- fore using this device outside the United States of America. Main Channel Frequencies: C) HANNEL/TYPEFE REQ (MHzC) HANNEL/TYP FREQ (MHz 15 GMRS/FRS4S 62.56215 2 FR 467.662 25 GMRS/FRS4S 62.58715 3 FR 467.687 35 GMRS/FRS4S 62.61215 4 FR 467.712 45 GMRS/FRS4S 62.63710 5 GMR 462.550 55
