ページ1に含まれる内容の要旨
uh047sx
Operating Guide
To bring outstanding wireless communication products
to people's lives throughout the world.
ページ2に含まれる内容の要旨
CONTROL & INDICATORS INCLUDED IN YOUR PACKAGE: • uh047sx Radio • Charging Cradle with AC Adaptor TORS • Operating Guide • NiMH Battery Pack • Belt Clip • External Speaker Mic OPTIONAL ACCESSORIES • VOX Earset • Carry Case • VOX Headset 21 13 14 22 23 15 2 4 16 25 17 26 18 2 7 19 28 20 10 11 12 29 1 Antenna 16 DCS ON Indicator 2 PTT(Push-To-Talk) Key 17 Scan Indicator 3 Monitor Key 18 Memory Indicator 4 Keylock/Call Key 19 Priority Channel Indicator
ページ3に含まれる内容の要旨
GETTING STARTED Uniden does not represent this product to be waterproof. Do not expose this product to Rain or Moisture. BATTERY INSTALLATION Your uh047sx unit uses the included NiMH battery pack for power. The unit can be powered with optional 4 AAA ALKALINE batteries. If you don't use the uh047sx for long periods, Uniden recommend removing the batteries. The uh047sx is designed to retain the previous user settings. This feature will continue to use a small amount of battery power while th
ページ4に含まれる内容の要旨
INSTALLING THE CHARGE CRADLE 1. Plug the AC adaptor into the rear of the charge cradle and into the mains power. 2. Place the uh047sx into the charge cradle. The charge light will come on to indicate the unit is charging. 3. Before operating the uh047sx, charge the battery pack for 16 hours. Do not charge alkaline or non rechargeable batteries. USER LICENCE INFORMATION The citizen band radio service is licenced in Australia by ACMA Radio-communications (Citizen Band Radio Stations) Class Li
ページ5に含まれる内容の要旨
BELT CLIP To attach the belt clip: Slide the belt clip until it snaps into place. To remove the belt clip: To remove the belt clip, press and hold belt clip locker, slide the belt clip at the same time until released. LOW BATTERY ALERT If the battery level becomes low, the battery indicator icon on the display begins flashing. When the batteries in the unit are low, the unit will go into a battery Low mode. The Transmit mode is disabled. Replace the alkaline batteries immediately or if yo
ページ6に含まれる内容の要旨
OPERATION POWER ON/OFF 1. Press and hold select/ key to turn the radio on. A channel number will appear on the display. 2. Press and hold select/ key to turn the radio off. VOLUME 1. Press or key to increase or decrease the volume level. ‘VOL’ icon appears on the display while volume is being adjusted. There are 8 volume levels. Level 0 (No Audio) to Level 7 (Maximum Volume). ADJUSTING THE KEY BEEPS Your radio emits a beep each time one of the keys (except for the PTT key
ページ7に含まれる内容の要旨
SELECTING A CHANNEL 1. Press ch/hi/lo key momentarily to activate channel select mode. The displayed channel will flash. 2. Press or key to select the desired channel. For your reference a list of the available channels, corresponding frequencies and guidelines for their use is printed on page 12. For Australia, Channels 05 and 35 are reserved for Emergency Calls. 3. Press ch/hi/lo key momentarily to exit channel select mode. If no key is pressed within 5 sec the uh047sx will
ページ8に含まれる内容の要旨
AUTOMATIC SQUELCH FEATURE The uh047sx is equipped with an Automatic Squelch System which shuts off weak transmissions and unwanted noise. MONITOR This feature enables users to listen for weak signals on the current channel at the press of a key. To use monitor: 1. Press mon key. The ‘RX’ icon will flash. 2. Release within 1.5 seconds and the unit exits Monitor mode. 3. Press and hold mon key for 2 seconds for continuous listening. The receiver circuit will stay open, letting in both the nois
ページ9に含まれる内容の要旨
REPLY DELAY While scanning, the uh047sx stops at a busy channel and receives a transmission. When the received signal is over, the unit will wait for 2 seconds for the return of the signal, otherwise, the radio resumes scanning. TO OPERATE IN DUPLEX MODE (REPEATERS) The Duplex function enables you to access local repeater stations. You can only activate Duplex from CH01-CH08. UHF CB Repeaters are used to retransmit or relay your signal. Repeaters will extend the range of your radio and ove
ページ10に含まれる内容の要旨
CTCSS & DCS (Continuous Tone Coded Squelch System) & (Digital Coded Squelch) CTCSS is a feature that allows a group to talk to each other without hearing other users on the same channel. 1. Press select/ key momentarily to enter CTCSS mode. The current selected CTCSS tone flashes. 2. Press key to select the required CTCSS tone (OFF or 1-38). 3. Press select/ key six times to confirm the selected setting and exit to standby mode. For channels with a CTCSS tone setting, the
ページ11に含まれる内容の要旨
VOX VOX is the automatic transmitting function by inputting voice into the optional VOX headset mic without pressing the PTT key. 1. Press select/ key momentarily twice while in standby mode to enter VOX Sensitivity mode. The current selected VOX setting will flash on the display. 2. Press or key to adjust the VOX sensitivity. 1 is the highest sensitivity and 4 is the lowest sensitivity. VOX can be turned off by selecting ‘oF’ icon. 3. Press select/ key five times to
ページ12に含まれる内容の要旨
PRIORITY SCAN CHANNEL To set a priority scan channel: 1. Press select/ momentarily four times while in standby mode to enter Priority Scan Channel mode. The current priority channel will be indicated. 2. Press or key to increase or decrease the desired channel number. 3. Press select/ three times to confirm and exit to standby mode. PRI will be displayed when a priority channel has been selected. BCL (Busy Channel Lockout) ON/OFF BCL is used when CTCSS or DCS is sele
ページ13に含まれる内容の要旨
UHF CB CHANNELS & FREQUENCIES Please follow these guidelines for channel use in Australia: • Channels 05 and 35 are Emergency Channels. • Channel 11 is a Calling Channel. • Channels 22 and 23 are for telemetry and telecommand applications and TX is inhibited on these channels. General communication is accepted on all other channels with these guidelines: • Channel 40 - road channel (Australia). • Channels 01-08 (and 31-38) are repeater channels. Simplex Mode Duplex Mode Simplex Mode CH No
ページ14に含まれる内容の要旨
CTCSS & DCS Code List (o0) (o1) (o2) (o3) (o4) (13)
ページ15に含まれる内容の要旨
WARRANTY UNIDEN UH047SX UHF CB TRANCEIVER RADIO Limited One Year Warranty Please keep your sales docket as it provides evidence of warranty. Warrantor: Uniden Australia Pty Limited ABN58 001 865 498 Uniden New Zealand Limited. Warranty only available in original country of purchase. Elements of Warranty: Uniden warrants to the original retail owner for the duration of this warranty, its uh047sx UHF CB Transceiver Radio (hereinafter referred to as the Product) to be free from defects in materi
ページ16に含まれる内容の要旨
© 2007 Uniden Australia Pty Limited/Uniden New Zealand Limited Printed in China UTZZ01929BA(0)