ページ1に含まれる内容の要旨
uniden@
40 Channel AM/SSB
GRANT
Mobile CB Radio
OWNERS MANUAL
~----
ページ2に含まれる内容の要旨
-~ I' INTRODUCTION UNIDEN CORPORATION OF AMERICA has combined superb workmanship and modern styling with the very latest state-of-art circuitry to bring you the GRANT Citizens Band Trasoceiver. It has been especially designed to give you maximum performance and reliability. Your GRANT is completely factory aligned and quality assurance tested. To obtain the maximum benefit and pleasure from your GRANT, please read very carefully the contents of this manual before attempting to install or operate
ページ3に含まれる内容の要旨
INSTAllATION MOBILE STATION INSTALLATION Plan the location of the transceiver and microphone bracket before starting the installation. Select a location that is convenient for operation and does not interfere with the driver or passenger in the vehicle. The radio should be securely fastened to some solid face, using the mounting bracket and self-tapping screws which are provided. MOBILE STATION ANTENNA Since the maximum allowable power output of the transmitter is limited by the F.C.C., the ante
ページ4に含まれる内容の要旨
- - ..- -,...-..--- r POWER CORD CONNECTION: POSITIVE GROUND SYSTEM If you are operating on a positive ground system, connect the black DC power cord from the transceiver to the negative, or (-), battery terminal or other convenient point, and connect the red power lead to the chassis or vehicle frame, or (+) battery terminal. NOTE: With regard to the connection of the power cords, it may be possible or desirable to connect the (red lead for negative ground system) or (black lead for positive gr
ページ5に含まれる内容の要旨
- ... ===-- --= OPERATING PROCEDURE TO RECEIVE: The G RANT operates on 40 AM channels, 40 Upper Side Band channels and 40 Lower Side Band channels. When you receive the SSB signal in the proper mode (USB or LSB), audio sound may be either too high pitched or Iow pitched, indicating that your receiver may not be tuned to the exact same frequency as the transmitter to which it is listening. The G RANT is equipped with a Clarifier. By tuning the Clarifier, you can slightly change the frequency of t
ページ6に含まれる内容の要旨
- ". "'-' . ~- - = I CONTROLS AND THEIR FUNCTIONS @ (J) @ @ @ @ @ VOLUME SQUELCH - MOD NB/ANL BRITE - CH9 0 F . o"Q) GRANT CD @ CID @ @ @ @ (jJ) @ 1. OFF/ON VOLUME: To turn the transceiver on, rotate this control clockwise past click. To turn the transceiver off, rotate the control counterclockwise past click. Rotate the control clockwise for a comfortable audio level. 2. SQUELCH: The Squelch control is normally set to a position which eliminates undesired background noise with no signal present
ページ7に含まれる内容の要旨
- - - - --- 5. MIC GAIN: This control is used to adjust, as required, microphone input sensitivity for optimum amount of modulation in transmit. UNIDEN CORPO- RATION OF AMERICA citizen's band transceivers have been designed to permit the user to attain levels of modulation up to 100% depending on the setting of the microphone gain control, using the microphone provided with the unit. UNIDEN's automatic compression and peak limiting circuits assure maximum modulation with minimum distortion. 6. R
ページ8に含まれる内容の要旨
-- - ----.--. 13. CHANNEL INDICATOR: Light Emitting Diode(LED) indicates the channel number in use. 14. CHANNEL SELECTOR KNOB: This knob selects the desired channel for transmission and reception. All channels, except channel 9, may be used for communications between stations. Channel 9 has been reserved by the F.C.C. for emergency communications involving the immediate safety of individuals or immediate protection of property. Channel 9 also may be used to render assistance to a motorist. This
ページ9に含まれる内容の要旨
--- - <--=====0 -==== 1= 19. EXTERNAL SPEAKER JACK: The External Speaker Jack is used for remote receiver monitoring. The external speaker should have 8 ohm impedance and be rated to handle at least 4.0 watts. When the external speaker is plugged in, the internal speaker is automatically disconnected. 20. POWER JACK: This jack permits connection of the D.C. power to the trans- ceiver. A power cord is supplied with the radio. -8- -~ T +
ページ10に含まれる内容の要旨
- =-- ---= r SPECIFICATIONS GENERAL 1005002 F.C.C. Type Number Channels 40AM, 40LSB, 40USB Frequency Range 26.965 to 27.405 MHz Frequency Control Phase Locked Loop(PLL) synthesized circuitry. Frequency Tolerance 0.005% 0.001% Frequency Stability -20°C to +50°C Operating Temperature Range Microphone Plug-in type; dynamic with push-to-talk switch and coiled cord. Input Voltage 13.8V DC nominal, 15.9V max., 11.7V min. (positive or negative ground). Current Drain Transmit: AM full mod., 3A maximum.
ページ11に含まれる内容の要旨
<:::::C AM and SSB: 350 to 2500 Hz. Frequency Response Output Impedance 52 ohms, unbalanced. SSB Filter 7.8 MHz, crystal lattice type 6 dB @2.2 kHz 60 dB @4.6 kHz RECEIVER Sensitivity SSB: Less than 0.25 pV for 10 dB (S+N)/N at greater than Y2watt of radio output. AM: Less than 0.5 pV for 10 dB. (S+N)/N at greater than % watt of audio output. SSB 6 dB @2.2 kHz, AM 6 dB @7.5 kHz. Selectivity More than 55 dB. Cross Modulation More than 60 dB. Image Rejection AM: 455 kHz SSB: 7.8 MHz I.F. Frequency
ページ12に含まれる内容の要旨
r~ SERVICING YOUR TRANSCEIVER The technical information, diagrams and charts will be supplied upon request. It is the user's responsibility to see that this radio is operating at all times in accordance with the F.C.C. Citizens Radio Service regulations. We highly recommend that you consult a qualified radiotelephone technician for the servicing and alignment of this CB radio product. Please refer to the WARNING information contained in the 1st page of this Owner's Manual. (NOTE: When ordering p
ページ13に含まれる内容の要旨
.---- r OPERATOR TROUBLESHOOTING Should be unit malfunction or not perform properly, the operator should perform the procedures il.dicated below: 1. If the transceiver is completely inoperative. * Check the power cord and fuse. 2. If trouble is experienced with receiving. * Check ON/OFFVOLUMECONTROLsetting. * Be sure SQUELCH is adjusted properly. Is the radio over-squelched? * Check to see that the radio is switched to an operational mode. 3. If trouble is experienced with transmitting. * Check
ページ14に含まれる内容の要旨
-==::: r=- NOTES -13 - -- I -.------- r f , -- -----
ページ15に含まれる内容の要旨
'--'== - r NOTES I . .) -14 - -~ r f
ページ16に含まれる内容の要旨
CIRCUIT DIAGR~M FOR GRANT [- I .c.- ""., ' r ~--------------------------------------------------------------------------- I TR' ZSCI615L TRZZ$CI615LTR! ZSCI13OL 1ROZSC94- TR5ZSC94- TR6ZSC90SAQ TRT 2SA"3PTReZSC94SAO TR9ZSCl615L FET1 !S"SB TRIO ZSC.OSAO ! ,,- L ~ I !.. = l_ -; __-;;;..; , ..~ ~' ~~~fi] . ~ F t:-"lil I~ I I : ,'.' -a : 1 , . . , 1 , I I ~ J~ : I I L ~ ,. ""'TAo<' "LUES A",.,,"'" ,.O- U""" OTH""'" NOTEO "'",,0 OH.. .' .,. OH. 1 , RE""OR .ATT..ES A" ",. UN"" OTH""'" 'P"""O. A. """"'A
ページ17に含まれる内容の要旨
BLOCK DIAGRAM FOR GRANT r ~ , I I I I I I I z '" ~ DIMMER ~-t: u I ~:i I I I I I -- ..J ANT I I I 5; ... I I )( ..., I I I I I I ,-+ : 1 I I r-- --1 ~ I DC 13.8V i ~--- I I I' - L_- d'-°~ n - + t - -- - ,I! I I I ~'" ,. I -+-_.J g ~ I ---~ ~ -- - - TX t:. - I u; J -RX Printed in Taiwan
ページ18に含まれる内容の要旨
- ---=== r~ I ~ uniden TWO-YEAR LIMITED WARRANTY WARRANTOR. UNIDEN CORPORATION OF AMERICA ("UNIDEN") ELEMENTS OF WARRANTY. UNIDEN warrants, for the duration of this warranty, its UNIDEN CB Product to be free from defects in materials and craftsmanship with only the limitation or exclusions set out below. WARRANTY DURATION. This Warranty shall terminate and be of no further effect Two (2) years after the date of original purchase of the Product or at the time the Product is (a) damaged or not mai
