ページ1に含まれる内容の要旨
Assembly Instructions for Model: JFBD1
Thank you for choosing the Java Furniture Line from Sanus Systems. The JFBD1
joins to Java Furniture Model JFV65 and serves as a backdrop for mounting
Sanus Wall Mount models VMPL50, VMPL250, VMPL, VMPL2, or VMPL3.
wARNINg
Do not use this product for any purpose that is not explicitly
specified by Sanus Systems. Improper installation may cause
property damage or personal injury. If you do not understand these
directions or have any doubts about the sa
ページ2に含まれる内容の要旨
Step 1: Attach Backboard Joining Plates to Bottom Backboard NoTe Do not fully tighten the ¼-20 x 0.5″ Screws (E) until assembly is complete. Attach the four Backboard Joining Plates (C) to the Bottom Backboard (B) with eight ¼-20 x 0.5″ Screws (e) and eight ¼″ Lock Washers (F). See Figure 1. Figure 1 Bottom Backboard (B) Backboard Joining Plate (C) Lock washer (F) Screw (e) Step 2: Attach Bottom Backboard to JFV65 Lowboy CAUTIoN The Bottom Backboard (B) is heavy. To avoid injury or product da
ページ3に含まれる内容の要旨
NoTe Do not fully tighten the ¼-20 x 0.5″ Screws (E) until assembly is complete. Attach the Bottom Backboard (B) and Backboard Joining Plates (C) to your JFV65 and the Mounting Rails with eight ¼-20 x 0.5″ Screws (e) and eight ¼″ Lock Washers (F). See Figure 3. Figure 3 Lock washer (F) Bottom Backboard (B) Screw (e) Backboard Joining Plate (C) Lock washer (F) Screw (e)
ページ4に含まれる内容の要旨
Step 3: Attach Top Backboard to JFV65 CAUTIoN The Top Backboard (A) is heavy. To avoid injury or product damage, two people must lift the Backboard. Position the Top Backboard (A) on the Bottom Backboard (B). Make sure the dowels on the Top Backboard fit into the holes on the Bottom Backboard. Push the Backboards together so there is no gap between them. Use eight ¼-20 x 0.5″ Screws (e) and eight ¼″ Lock Washers (F) to fasten the Top Backboard to the Backboard Joining Plates (C), and the Mou
ページ5に含まれる内容の要旨
Step 4: Attach wall Plate Provided with VMPL50, VMPL250, VMPL, VMPL2, or VMPL3 Decide where you would like the Wall Plate and mark the position of the two bottom holes through the slots in the Mounting Rails. Use Table 1 below to correctly locate the position of the two upper slots in the Mounting Rails. Table 1: Vertical(↕) Distance Between Wall Plate Slots VMPL50 VMPL250 VMPL VMPL2 VMPL3 4.5 in (114.3 mm) 4.5 in (114.3 mm) 6.5 in (165.1 mm) 6.5 in (165.1 mm) 6.0 in (152.4 mm) NoTeS Place a p
