RocketFish RF-TVMLPT01の取扱説明書

ページ1に含まれる内容の要旨

QUICK SETUP GUIDE
RF-TVMLPT01
1 Install locking screw
Option 2: If the back of the TV is curved or to make room for cables
Install the TV bracket locking screw (G) into the TV bracket (A) using the hex key (H).
Attach the TV bracket [A] to the back of the TV using the washers (E), the spacers (F), and the screws (D).
Do not screw in more than three or four turns.
Note: If the hole pattern on your TV is 75mm x 75mm the washers(E) will not be used.

Thank you for choosing the
Ro

ページ2に含まれる内容の要旨

3 Install the wall plate Option 1: Installing to a wood stud wall Option 2: Installing to a solid concrete or concrete block wall 5 Adjust the tilt angle (if necessary) Caution: Avoid potential injuries or property damage! Caution: Avoid potential injuries or property damage! DO NOT over-tighten the lag bolts. You can adjust the tilt angle of the screen ± 12°. DO NOT over-tighten the lag bolts. Any material covering the wall must not exceed 5/8 in. (16mm). If necessary, the tilt tension can be a