ページ1に含まれる内容の要旨
Basic Operation
Initial Setup TV Operation Advanced Operation For Your Information
Timer Operation
LSQT0711A
Combination VCR
Operating Instructions
Model No. PV-C2063A
• Initial Setup and Connection Procedures are on pages 8 and 9.
®
As an ENERGY STAR Partner,
Matsushita Electric Corporation of America has
determined that this product or product model meets
®
the ENERGY STAR guidelines for energy efficiency.
Please read these instructions carefully before attempting to connect,
operate, or adju
ページ2に含まれる内容の要旨
Important Safeguards and Precautions READ AND RETAIN ALL SAFETY AND OUTDOOR ANTENNA INSTALLATION OPERATING INSTRUCTIONS. HEED ALL 1 SAFE ANTENNA AND CABLE CONNECTION WARNINGS IN THE MANUAL AND ON UNIT An outside antenna or cable system must be properly grounded to provide some protection INSTALLATION NEC - NATIONAL against built up static charges ANTENNA LEAD ELECTRICAL CODE IN WIRE and voltage. Section 810 of ANTENNA GROUND 1 POWER SOURCE CAUTION DISCHARGE UNIT CLAMP (NEC SECTION 810-20) t
ページ3に含まれる内容の要旨
Safety Precautions/Mesures de sécurité Warning : To prevent fire or shock hazard, do not expose this equipment to rain or moisture. Caution : To prevent electric shock, match wide blade of plug to wide slot, fully insert. Avertissement : Afin de prévenir tout risque d’incendie ou de chocs électriques, ne pas exposer cet appareil à la pluie ou à une humidité excessive. Attention :Pour éviter les chocs électriques, introduire la lame la plus large de la fiche dans la borne correspondante de la pri
ページ4に含まれる内容の要旨
Unit Information Specifications Head Cleaning Display Playing older or damaged tapes may eventually Picture Tube: 20 inch measured diagonal cause video heads to become clogged. 90° deflection Picture Tube Head Clog Sensor VCR During playback this screen Video Recording 4 rotary heads helical appears if clogging is V I DEO HEADS MAY System: scanning system detected. To remove screen, NEED CLEAN I NG PL EASE I NSERT HEAD Audio Track: 1 track press PLAY on the remote CLEAN I NG
ページ5に含まれる内容の要旨
Basic Operation Initial Setup TV Operation Timer Operation Advanced Operation For Your Information Table of Contents Important Safeguards and Precautions / Safety Precautions ... 2,3 Before Using....................................................................................... 4 Unit Information ................................................................................. 4 Table of Contents ............................................................................... 5 Location of Co
ページ6に含まれる内容の要旨
Location of Controls Remote Control Buttons (Light Tower™ Illuminated Remote Control) EJECT COMBO Ejects tape. Returns to COMBO mode. POWER LIGHT See below. Turns on or off. FM/TV DSS/CABLE Receives FM radio signal. Sets the remote to control some basic DSS or Cable box MUTE functions. Mutes the sound instantly. RAPID TUNE CHANNEL UP/DOWN Displays the last channel Selects a channel. you were watching. SELECT UP/DOWN VOLUME UP/DOWN Controls navigation around Adjusts volume. on-screen menu. SET/BA
ページ7に含まれる内容の要旨
Front View of the Unit and Indicators POWER POWER VOL VOL CH CH STOP/EJECT STOP/EJECT REW/ REW/ PLAY/REPEAT PLAY/REPEAT FF/ FF/ REC REC TIMER/FM TIMER/FM R RE EC C ON TIMER ON TIMER PROG TIMER PROG TIMER VIDEO IN VIDEO IN AUDIO IN AUDIO IN ACTION ACTION Built-In Speaker PHONES Jack Connect an AUDIO VIDEO IN Jack earphone or For dubbing. REWIND/SEARCH headphones. See previous page. POWER ACTION PROG TIMER See previous page. Press together with STOP. Indicator Lights when the VOLUME UP/DOWN PLAY
ページ8に含まれる内容の要旨
VHF/UHF VHF/UHF Connections/ Initial Setup (Ready to Play) Please make all cable or antenna connections before powering on. How to Connect Connecting For ANT./Cable Connect the cable from IN from Antenna/Cable to the VHF/UHF ANT./CABLE terminal on the unit. VHF/UHF For DSS/Cable Box VHF/UHF UNIT Connect the OUT jack on your cable box to the VHF/UHF Cable TV terminal on the unit with a RF Converter Box cable. VHF/UHF WARNING: Overtightening "Nut type" RF coaxial cables may damage jacks. Finger ti
ページ9に含まれる内容の要旨
Initial Setup *Important: If a remote control button does not work when pressed, press the COMBO button on the remote and try the button again. Manual Clock Set Reset all unit Memory Functions If AUTO CLOCK SET was incomplete, manually When moving unit to a new location, or if a set the clock as follows. mistake was made in the Initial Setup section. • Make sure a tape is not inserted in the unit. Press ACTION on the remote to display SET CLOCK Menu screen. 1 SET CLOCK : 1 / / DST : ON SE S
ページ10に含まれる内容の要旨
Reset Language, Channels, Clock, M A I N MENU Press ACTION* to display MAIN MENU. 1 T V VCR LANGUAGE C H CLOCK EX I T SELECT : SET : ACT I ON Language Channels Clock 2 1) Press to 1) Press to 1) Press to select “CH.” select “CLOCK.” select language icon. M A I N MENU M A I N MENU M A I N MENU VCR T V LANGUAGE T V VCR LANGUAGE T T V V VCR LANGUAGE EX I T C H CLOCK C C H H CLOCK EX I T SELECT : SELECT :
ページ11に含まれる内容の要旨
Basic Operation Time Zone Adjust *Important: If a remote control button does not POWER work when pressed, press the COMBO button on the remote and try the button again. SELECT/SET :CH UP :CH DOWN Time Zone Adjust ACTION :VOL UP (Only when Auto Clock is set.) :VOL DOWN 1) Press to select “CLOCK.” NUMBER Keys M A I N MENU ADD/DLT VCR LANGUAGE T V C C H H CLOCK EX I T SELECT : SET : ACT I ON 2) Press ACTION. SET CLO
ページ12に含まれる内容の要旨
Playback a Tape Record On a Tape Insert a cassette with record tab. Ready Check List • The unit power comes on automatically. All connections are made. 1 Your unit is plugged in. Press CH or number keys Insert a cassette. to select a channel. • The unit power comes 2 1 • For “LINE” input, see bottom of next page. on automatically. Record tab Press SPEED to select recording speed (see page 4). 3 To prevent tape jam, SP = Standard Play remove loose or peeling LP = Long Play labels from tapes. SLP
ページ13に含まれる内容の要旨
Basic Operation Copy Your Tapes (Dubbing) *Important: If a remote control button does not work when pressed, press the COMBO button on the remote and try the button again. Recording (Editing) unit Connections you’ll need to make. Playing (Source) VCR AUDIO VIDEO IN FROM ANT. OUT VIDEO IN AUDIO IN AUDIO IN IN OUT TO TV Playback (Source) Recording (Editing) unit Insert pre- Insert blank tape with record tab. recorded tape. 1 Our Vacation • Dubbing tapes protected with Copy Gua
ページ14に含まれる内容の要旨
TV Operation *Important: If a remote control button does not work when pressed, press the COMBO button on the remote and try the button again. Press POWER* on the remote or unit. Ready Check List 1 All connections are made. Your unit is plugged in. Use CH or 0 8 number keys to ABC 2 select a channel. Press VOL + or VOL - to adjust volume. 3 VOL + / VOL- 24 POWER POWER VOL VOL CH CH STOP/EJECT STOP/EJECT REW/ REW/ PLAY/REPEAT PLAY/REPEAT FF/ FF/ REC REC TIMER/FM TIMER/FM NIGHT (
ページ15に含まれる内容の要旨
TV Operation MTS Broadcast/TV Stereo System ® Equipped with -TV Noise Receivable Broadcast Types Reduction for true MTS ® The following are possible audio broadcast types and reproduction. -TV Noise on-screen displays. The signal being received is indicated with Reduction is required for good an “ ” mark while the selected audio mode is indicated with an stereo separation and audio arrow. To change the audio mode for these broadcasts, see the ® fidelity. is a registered “Select Audio Mode fo
ページ16に含まれる内容の要旨
TV Timer Features Ready Check List ON-TIMER with Alarm The clock is set to the correct time. This unit can be set to automatically power on in one of 2 modes (TV, Playback, or FM radio). You can also combine the On-Timer with a one minute alarm that gradually increases in volume. Press PROG* to display SET PROGRAM screen. 1 SET T I MER 1)Press to select ON T ON T I MER MER “ON TIMER.” 2 S LEEP T I MER : 00 2)Press to display ON TIMER screen. SELECT : SET : SET
ページ17に含まれる内容の要旨
TV Operation *Important: If a remote control button does not work when pressed, press the COMBO button on the remote and try the button again. Sleep Timer This unit can be set for auto power off. Press SLEEP repeatedly SLEEP TIMER 30 to set SLEEP TIMER. • Pressing DISPLAY with SLEEP TIMER 60 SELECT/SET sleep timer set displays :CH UP remaining time. SLEEP TIMER 90 :CH DOWN Press SLEEP repeatedly :VOL UP until “SLEEP TIMER 00” SLEEP TIMER 00 :VOL DOWN appears to cancel. PROG ADD/DLT DISPLAY I
ページ18に含まれる内容の要旨
Closed Caption System Closed Caption is ... This multi-use system not only allows the hearing impaired to enjoy selected programs, but also makes useful information from TV stations available to everyone. Closed Caption Mode Feature Closed Caption Mode Selections Press ACTION* Caption Mode: CAP C1 or C2 to display MAIN MENU. 1 A narration of selected TV programs is displayed. Check TV program listings for M A I N MENU 1)Press to CC(Closed Caption) select “TV.” 2 T V VCR LANGUAGE broadcasts. 2
ページ19に含まれる内容の要旨
TV Operation *Important: If a remote control button does not work when pressed, press the COMBO button on the remote and try the button again. Caption On Mute Feature Closed Caption narration, if available, is displayed when MUTE button is pressed for silence. Press ACTION to display MAIN MENU. 1 MUTE M A I N MENU 1)Press to select “TV.” 2 T V VCR LANGUAGE 2)Press ACTION to SELECT/SET display SET UP TV :CH UP C H CLOCK EX I T :CH DOWN screen. SELECT : SET
ページ20に含まれる内容の要旨
*Important: If a remote control button does not work when pressed, press the COMBO button on the remote and try the button again. FM Radio FM Radio is ... This unit has an FM radio with built-in antenna, 9 station preset, and a band range of 87.5 ~ 108.1 MHz. You can even set the On-Timer (page 16) to wake up to your favorite radio station. FM Radio Setup FM ANTENNA Setup Make sure FM tuning is done Press FM/TV* on the remote or press TIMER/FM twice on the unit correctly (see FM Radio Setup). 1
