ページ1に含まれる内容の要旨
TVCR
CC13B1MG
CC19B1MG
Color TV with built-in VCR
Color TV with built-in VCR
Owner’s Manual
Owner’s Manual
ページ2に含まれる内容の要旨
N I H T I W D E D E E N N O I Return your Warranty Registration Card today to ensure you receive all the you’re entitled to. benefits Once your purchase is registered, you’re eligible to receive all the privileges of owning this prod- uct. So complete and return the Warranty Registration Card enclosed with your purchase at once. And take advantage of these important benefits. Warranty Owner Model Verification Confirmation Registration Registering your product within Your completed Warranty Retur
ページ3に含まれる内容の要旨
Introduction 3 Welcome to your TV/VCR owner’s manual. This manual describes two models: CC13B1MG and CC19B1MG. Although the models may have a differ- ent appearance, both models operate exactly the same. The features described in this manual apply to both models unless otherwise specified. The CC13B1MG is illustrated in this manual, but the CC19B1MG has a similar appearance. This manual has seven sections: Setting Up Your TV/VCR; Description of Controls; Basic Operations; Recording Options;
ページ4に含まれる内容の要旨
4 Table of Contents Setting Up Your TV/VCR Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Before Using the TV/VCR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Hooking Up the TV/VCR . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ページ5に含まれる内容の要旨
Before Using the TV/VCR 5 Putting Batteries in the Remote Control 1 Remove the battery compartment lid on the bottom of 1 the remote control by sliding it in the direction of the arrow. 2 Place two AA batteries inside the battery compartment 2 with their and ends aligned as indicated. + – 3 Replace the battery compartment lid. 3 Recording Prevention Video cassette tapes have record tabs to ensure that recordings are not accidentally erased. 1 1 To prevent accidental recording, break off the tab
ページ6に含まれる内容の要旨
6 Hooking Up the TV/VCR 1 Hook up your TV/VCR using one of the connections shown. Connect a Cable signal A. or an antenna to the ANT(enna) Jack. Hooking Up Your TV/VCR With a Cable Signal or Outdoor Antenna ANT. ANT. Connect the Cable signal to the IN Jack on the Cable Box. B. Connect an RF coaxial cable (75- Hooking Up Your TV/VCR ohm, not supplied) to the OUT Jack With a Cable Box on the Cable Box and to the To view any channel, set the IN ANT(enna) Jack on the TV/VCR. OUT TV/VCR to the Cable
ページ7に含まれる内容の要旨
Hooking Up the TV/VCR (cont’d) 7 D. Hooking Up Your TV/VCR to Another Video Source (VCR or Camcorder) You may need this connection if you want to copy tapes. Details are on page 31. Use an Audio cable to connect the AUDIO OUT Jack on the VCR to the AUDIO In Jack AUDIO/VIDEO OUT on the front of the TV/VCR. Jacks on VCR 3CH IN 4CH AUDIO VIDEO OUT ANT. OUT IN AUDIO VIDEO AUDIO VIDEO STOP REW PLAY F.FWD REC CHANNEL VOLUME POWER EARPHONE EJECT OTR 3CH IN 4CH AUDIO VIDEO ANT. OUT AUDIO/VIDEO In Jacks
ページ8に含まれる内容の要旨
8 Turning On the TV/VCR Before you turn on the TV/VCR, make sure batteries are in the remote control and the TV/VCR is hooked up correctly. The instructions on this page work only when you turn on the TV/VCR for the first time. 1 3 Press the POWER button. The TV/VCR will come on and the POWER STATUS/EXIT CLEAR MENU screen shown below will appear. 1 2 3 MEMORY 1 SELECT LANGUAGE 4 5 6 > ENGLISH ON CHANNEL ESPAÑOL 7 8 9 5 SELECT KL OR 0 ALT.CH PRESS MENU TO CONTINUE SLEEP/WAKE UP VOLU
ページ9に含まれる内容の要旨
Language Selection 9 Follow the steps below to change the language of the on-screen displays and menus. 2-4 1 5 Press the MENU button. 1 PRESS B > PRIM. SETUP POWER MENU STATUS/EXIT CLEAR VCR PROGRAM VCR SETUP 1 2 3 MEMORY CAPTION REMINDER BRIGHTNESS 4 5 6 CHANNEL 7 8 9 0 ALT.CH 2 SLEEP/WAKE UP Press the PLAY/s button or the STOP/t button to select VOLUME MUTE SPEED PRIM. SETUP. Then, press the FF/SEARCH/B button. PRIMARY SETUP REW/SEARCH PLAY/ FF/SEARCH > SELECT LANGUAGE REC/OTR STOP/ PAUSE/ST
ページ10に含まれる内容の要旨
10 Automatic Channel Setup Although the TV/VCR may automatically memorize the channels you receive when you turn it on for the first time, you may set up channels again by following the steps below. 2-3 1 Press the MENU button. PRESS B > PRIM. SETUP VCR PROGRAM VCR SETUP 1 CAPTION REMINDER POWER MENU STATUS/EXIT CLEAR BRIGHTNESS 1 2 3 MEMORY 4 5 6 CHANNEL 7 8 9 2 Press the PLAY/s button or the STOP/t button to select 0 ALT.CH PRIM. SETUP, then press the FF/SEARCH/B button. SLEEP/WAKE UP PRIMARY
ページ11に含まれる内容の要旨
Automatic Channel Setup (cont’d) 11 Adding/Deleting Channels 1 Press the MENU button. TO ADJUST PRESS { / B CH123 SAVED > CHANNEL 1 5 SMARTLOCK POWER MENU STATUS/EXIT CLEAR REVIEW EXIT PRIM. SETUP 1 2 3 MEMORY VCR PROGRAM 4 5 6 CHANNEL 7 8 9 3 2 0 ALT.CH Press the PLAY/s button or the STOP/t button to select SLEEP/WAKE UP CHANNEL. VOLUME MUTE SPEED 4 TO ADJUST PRESS { / B CH123 REW/SEARCH PLAY/ FF/SEARCH SAVED > CHANNEL STOP/ SMARTLOCK REC/OTR PAUSE/STILL REVIEW EXIT PRIM. SETUP VCR PROGRAM 2 3
ページ12に含まれる内容の要旨
12 Setting the Clock There are three ways to set the clock: Manually, with Automatic PBS Channel Selection, or with Manual PBS Channel Selection. With manual clock setting, you tell the TV/VCR the current time. With Automatic or Manual PBS Channel Selection, the TV/VCR gets the time from your local PBS station. If you use either Manual PBS Channel Selection or Automatic PBS 2-3 Channel Selection, follow the steps on page 19 to have the TV/VCR maintain the clock according to your Time Zone. Cabl
ページ13に含まれる内容の要旨
Setting the Clock (cont’d) 13 4 Press the PLAY/s button or the STOP/t button to select SET MANUAL CLOCK, then press the FF/SEARCH/B button. SET MANUAL CLOCK TIME – – : – – DATE – – / – – / – – – – 7 POWER MENU STATUS/EXIT CLEAR 1 2 3 MEMORY TO END PRESS EXIT 4 5 6 CHANNEL 7 8 9 0 ALT.CH 5 SLEEP/WAKE UP Press two Number buttons for the hour(s) and two Number buttons for the minute(s). Then press 1 for AM VOLUME MUTE SPEED or 2 for PM. For example, for 9:30 PM, press 09, 30, 2. REW/SEARCH PLA
ページ14に含まれる内容の要旨
14 Setting the Clock (cont’d) Automatic PBS Channel Selection 1 Press the MENU button. 1,4 > PRIM. SETUP PRESS B VCR PROGRAM VCR SETUP CAPTION REMINDER BRIGHTNESS POWER MENU STATUS/EXIT CLEAR 1 2 3 MEMORY 2 Press the PLAY/s button or the STOP/t button to select 4 5 6 PRIM. SETUP. Then, press the FF/SEARCH/B button. CHANNEL 7 8 9 PRIMARY SETUP 0 ALT.CH > SELECT LANGUAGE AUTO PROGRAMMING SLEEP/WAKE UP CH MEMORY REVIEW VOLUME BAR [ON] VOLUME MUTE SPEED SET CLOCK SELECT KL CHOOSE B REW/SEARCH PLAY/
ページ15に含まれる内容の要旨
Setting the Clock (cont’d) 15 Wait for the TV/VCR to find 5 the time. Press the PLAY/s button or the STOP/t button to 6 select SET PBS CH. AUTO. Then, press the FF/SEARCH/B button. SET AUTO CLOCK TIME – – : – – DATE – – / – – / – – – – NOW SEARCHING TO END PRESS EXIT POWER MENU STATUS/EXIT CLEAR 7 1 2 3 MEMORY 4 5 6 6 CHANNEL NOW SEARCHING flashes on the TV/VCR screen. 7 8 9 0 ALT.CH SLEEP/WAKE UP 7 VOLUME MUTE SPEED When the TV/VCR finds the PBS channel, the time will appear on the screen. Pre
ページ16に含まれる内容の要旨
16 Setting the Clock (cont’d) Manual PBS Channel Selection 1 1,4 Press the MENU button. > PRIM. SETUP PRESS B VCR PROGRAM VCR SETUP CAPTION REMINDER BRIGHTNESS POWER MENU STATUS/EXIT CLEAR 1 2 3 MEMORY 4 5 6 2 Press the PLAY/s button or the STOP/t button to select CHANNEL 7 8 9 PRIM. SETUP. Then, press the FF/SEARCH/B button. 0 ALT.CH PRIMARY SETUP SLEEP/WAKE UP > SELECT LANGUAGE AUTO PROGRAMMING VOLUME MUTE SPEED CH MEMORY REVIEW VOLUME BAR [ON] SET CLOCK REW/SEARCH PLAY/ FF/SEARCH SELECT KL
ページ17に含まれる内容の要旨
Setting the Clock (cont’d) 17 5 Press the PLAY/s button or the STOP/t button to Wait for the TV/VCR to select SET PBS CH. MANUAL. Then, press the find the time. 7 FF/SEARCH/B button. AUTO CLOCK (PBS) CH 02 TIME – – : – – DATE – – / – – / – – – – SELECT CHANNEL NUMBER TO END PRESS EXIT POWER MENU STATUS/EXIT CLEAR 8 1 2 3 MEMORY 4 5 6 6 Use the Number buttons to select your PBS station. CHANNEL 7 8 9 6 AUTO CLOCK (PBS) CH 12 0 ALT.CH TIME – – : – – SLEEP/WAKE UP DATE – – / – – / – – – – VOLUME M
ページ18に含まれる内容の要旨
18 Daylight-Savings Time When the Daylight-Savings Time feature is ON, the TV/VCR clock will automatically move forward one hour on the first Sunday in April and move back one hour on the last Sunday in October. 2-4 To turn Daylight-Savings Time ON or OFF, follow the steps below. 5 1 Press the MENU button. 1 POWER MENU STATUS/EXIT CLEAR 1 2 3 MEMORY > PRIM. SETUP PRESS B VCR PROGRAM 4 5 6 VCR SETUP CAPTION REMINDER CHANNEL 7 8 9 BRIGHTNESS 0 ALT.CH SLEEP/WAKE UP 2 VOLUME MUTE SPEED Press the PL
ページ19に含まれる内容の要旨
Time Zone 19 When you set the clock using AUTO CLOCK, specify your time zone. The TV/VCR will maintain the clock according to your time zone. 1 Press the MENU button. 2-5 > PRIM. SETUP PRESS B VCR PROGRAM VCR SETUP 6 CAPTION REMINDER BRIGHTNESS 1 POWER MENU STATUS/EXIT CLEAR 2 1 2 3 MEMORY Press the PLAY/s button or the STOP/t button to select PRIM. SETUP. Then, press the FF/SEARCH/B button. 4 5 6 PRIMARY SETUP CHANNEL 7 8 9 > SELECT LANGUAGE AUTO PROGRAMMING 0 ALT.CH CH MEMORY REVIEW VOLUME
ページ20に含まれる内容の要旨
20 Front Panel Cassette Compartment Insert a video cassette tape here. Wireless Remote Sensor Receives a signal from your remote control so you can operate the TV/VCR from a distance. STOP/EJECT Button Press once to stop the tape. When playback is stopped, press to eject the tape. Press to select an item in the menu. VIDEO In Jack Connect this jack to the video out jack of a camcorder or a VCR. Details are on page 31. AUDIO In Jack Connect this jack to the audio out jack of a camcorder or a VCR
