ページ1に含まれる内容の要旨
SM-CMD3005
MULTIMEDIA DVD/CD/MP3 RECEIVER WITH BUILT-IN 3.5” TFT DISPLAY AND TV
TUNER
Instruction manual
DVD/CD/MP3- 3.5” TFT-
ページ2に含まれる内容の要旨
Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents..............................................................................................................................2 Important safeguards .......................................................................................
ページ3に含まれる内容の要旨
Important safeguards - Using the device at temperature below -10º may cause the breakage of the device. Before using please heat up the passenger compartment to the recommended temperature! - Read carefully through this manual to familiarize yourself with this high-quality car stereo system. - Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. - When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher ampera
ページ4に含まれる内容の要旨
Installation/Connection Installation 4
ページ5に含まれる内容の要旨
5
ページ6に含まれる内容の要旨
Electrical connection Caution: Do not interchange the connection of the wiring! For some car models you may need to modify wiring of the supplied power cord. Contact your authorized car dealer before installing this unit. 6
ページ7に含まれる内容の要旨
Using the ISO Connector 1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated. 2. For connections without the ISO connectors, check the wiring in the vehicle carefully before connecting, incorrect connection may cause serious damage to this unit. 3. Cut the connector, connect the colored leads of the power cord to the car battery as shown in the color code table below for speaker and power cable connections. Function Connector A Connector B 1 7 Rear
ページ8に含まれる内容の要旨
Panel controls Front panel 1. POWER/MU (mute) button 2. ANG (i.e. TILT) button 3. REL (Release) button 4. MOD button 5. TA button 6. VOL/SEL knob 7. AF button 8. TFT display 9. IR remote sensor 10. BD button 11. UP and DN buttons 12. APS button 13. EJECT button 14. 1/PLAY/PAUSE button 15. 2/INT button 16. 3/RPT button 17. 4/RDM button 18. 5/-10 button 19. 6/+10 button 20. USB slot 21. RET (reset) button 22. AUX IN 8
ページ9に含まれる内容の要旨
Description of the Unit Chassis Facet After removing the Front Panel Description of the Unit Chassis Facet After Sliding Down the Front Panel 9
ページ10に含まれる内容の要旨
Remote control 1. EQ button – press to select the corresponding equalizer preset modes to adjust the sound quality. 2. PWR button - press it to turn the power on, press again to turn the power off. 3. MODE button - press it to select the mode: => TUNER => DISC (the type of disc in the unit) => USB => SD/MMC => AUX => TV =>. 4. MU button - press it to cut down the volume output, press it again or press +/- buttons to resume volume. 5. SEL button - press SEL button repeatedly to select the modes:
ページ11に含まれる内容の要旨
21. MENU button - In DVD mode press it to enter the disc menu. 22. cursor buttons/OK button - Use these buttons to navigate through menus and lists. Use OK to confirm. 23. / buttons – In Disc mode press these buttons to go to previous/next track. Press and hold for 2 seconds to start fast backward/forward playing. In TUNER mode press these buttons to start manual stations searching. Press them and hold for 2 seconds to start automatic stations searching. 24. PLAY/PAUSE button – In Disc mode pres
ページ12に含まれる内容の要旨
Changing the battery 1. Press the catch and at the same time pull out the battery tray. 2. Insert the 1 x lithium battery, type CR 2025 3V battery with the stamped (+) mark facing upward. Insert the battery tray into the RC. Warning: Store the battery where children cannot reach. If a child accidentally swallows the battery, consult a doctor immediately. Do not recharge, short, disassemble or heat the battery or dispose it in a fire. Do not expose or bring into contact the battery with other met
ページ13に含まれる内容の要旨
General operation Reset the unit Operating the unit for the first time or after replacing the car battery, you must reset the unit. Press the RESET button on the panel to restore the unit to the original factory settings. Power on/off Press POWER button on the panel or PWR button on the RC to turn the unit on. Long press the POWER button on the front panel or briefly press the PWR button on the RC to turn the unit off. Note: After the unit is off, the volume level and radio current settings will
ページ14に含まれる内容の要旨
Loud mode Press the LOUD button on the RC to turn on/off LOUD mode. When turning on LOUD mode, it will enhance bass level immediately when the bass is not enough. Equalizer mode Press the EQ button on the RC to select the preset music equalizer curves: => POP => ROCK => CLAS => FLAT =>. The sound effect will be changed. Panel angle adjusting Press the TILT button on the RC or ANG button on the panel repeatedly to select an optical angle: => ANGLE0 => ANGLE1 => ANGLE2 => ANGLE3 => ANGLE4 =>. 14
ページ15に含まれる内容の要旨
Digital tuner Note: RDS (Radio Data System) service availability varies with areas. Please understand if RDS service is not available in you area, the following service is not available, either. Band selection Press the MOD button on the panel or MODE button on the RC to select the TUNER mode. Press P/N/BAND button on the RC or BD button on the panel once or more to select: FM1, FM2, FM3, AM1, AM2. Display will show the wave band, frequency and preset station number if already stored. Manual/aut
ページ16に含まれる内容の要旨
Local radio station search Press the LOC button on the RC shortly to turn the LOCAL function ON or OFF. When the LOCAL function is on the local stations (stations with weak radio signal) can be played. When the LOCAL function is off both local and distant stations (stations with strong radio signal) can be played. Press the button again to turn it of. RDS function There are the PI, PS, TP, PTY, TA, AF, DATA. PI: Program Identification Code – for identifying code. PS: Program Service Name Broadca
ページ17に含まれる内容の要旨
Disc operations Disc glossary PBC (PlayBack Control) PBC is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PBC, it can playback interactive software with the menu displayed on TV. And if the disc contains still images, it can playback high definition of still image. Title The title is the important part of DVD disc. The memory volume of the disc is rather big, that makes possible to record several films on one disc. For example, if a disc contains three films, th
ページ18に含まれる内容の要旨
Supported sampling frequency for MP3 disc: 8 KHz – 48 KHz (44.1 KHz preferably) Supported bit-rates of MP3 disc are: 32 - 320 kbps (128 kbps preferably). Following formats are not supported *.ACC, *.DLF, *.M3U, *.PLS, MP3 PRO, files with DRM. Open session discs are not supported. USB/SD/MMC notes USB functions (flash memory type) MP3 music play. 1. SD/MMC card support, 2in1 (SD/MMC) support. 2. USB flash memory. 3. FAT 12/ FAT 16/ FAT 32 is possible - FAT 12/16 (dir: 200 support, file: 500 s
ページ19に含まれる内容の要旨
Loading a disc 1. Turn the power on. 2. Press the EJECT button on the panel to flip it down. Insert the disc with the printed side facing upward into the slot. Press EJECT button on the panel to eject the disc. The panel will be closed automatically. 3. Playback will start automatically. Inserting the SD/MMC card/USB device Insert the MMC/ SD card or USB device into MMC/SD compartment or USB socket (When you want to insert a Card, you need to tilt the front panel to an appropriate degree). Then
ページ20に含まれる内容の要旨
to play 34-th track, firstly press the 10+ button for 3 times, then press the 4 button (the 0/10 button is used as the 0 button). Note: In MP3/WMA mode, long pressing the +10 or –10 button can play the next 10 or last 10 track. Scanning forward and backward Press and hold for 2 seconds the UP/DN buttons on the panel or the / on the RC to select the speed of fast playing in forward or backward direction: X2 => X4 => X8 => X16 => X20 => Normal. Press the PLAY/PAUSE button to return to normal playb
