Peerless Industries Peerless In-Wall Mount IM740P-Sの取扱説明書

ページ1に含まれる内容の要旨

Installation and Assembly:
In-wall Mount for up to 40" Flat Panel Screens
Models: IM740P, IM740P-S
This product is intended for use with UL
Listed products and must be installed by a

qualified professional installer.
Maximum UL Load Capacity:
80 lb (36.3 kg)
ISSUED: 12-04-07 SHEET #: 095-9280-3 03-25-10
1 of 6
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-865-2112 or 708-865-8870.

ページ2に含まれる内容の要旨

Note: Read entire instruction sheet before you start installation and assembly. WARNING • Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please call Peerless customer care at 1-800-865-2112. • This product should only be installed by someone of good mechanical aptitude, has experience with basic building construction,

ページ3に含まれる内容の要旨

Before you begin, make sure all parts shown are included with your product. Parts may appear slightly different than illustrated. Parts List IM740P IM740P-S Description Qty. Part # Part # A in-wall box 1 095-P1536 095-C4536 B #10 x 1.5" wood screw 2 500-2002 500-2002 C mounting cover plate 2 095-P1533 095-C4533 D ribbed rivet 4 590-1296 590-1296 E cable bushing 2 590-1295 590-1295 F cable management clips 4 590-1166 590-1166 G plastic finishing cap 2 590-1123 590-1123 H cable tie 4 590-1168 590

ページ4に含まれる内容の要旨

Installation to Wood Stud Wall WARNING • Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached hardware and components. • T ighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power. • Never tighten in excess of 80 in. • lb (9 N.M.). • Make sure that mounting screws are anchored into the center of the stud. The use of an "ed

ページ5に含まれる内容の要旨

Installing Articulating Arm to In-wall Box Choose hole pattern on interior mounting plate of in-wall box (A) which align with hole pattern on the wall plate of 2 PA740 articulating arm (AA). Mounting hole alignments may be selected for different height installations. Note: Consider position of screen center or routing of cables before securing arm to in-wall box. Drill two 5/32" (4 mm) holes 2.5" (65 mm) deep using interior mounting plate holes of in-wall box (A) as a guide. Attach PA740 artic

ページ6に含まれる内容の要旨

Cable Management For optional installation of electrical gang box, access plates located on the bottom or top of in-wall box can be 4 temporarily removed to install electrical gang box as shown in figure 4.1. ACCESS PLATE fig. 4.1 SCrEEN NOT ShOWN fOr CLArITy Insert up to four cable management clips (F) into the desired positions in the in-wall box as shown in figure 4.2 4-1 for routing cables. Refer to instruction included with PA740 articulating arm (AA) for cable management with arm. Inse