ページ1に含まれる内容の要旨
®
TURRET REPLACEMENT KIT RP-RM46
INSTALLATION INSTRUCTIONS
for CRANK-UP SATELLITE ANTENNAS
(Except Combination Mounts - RM-4610, etc.)
Be sure turret turns freely on mount. Be
Directions for Turret Replacement
sure the handle lock is in the rotate
1. Crank antenna to vertical position.
position before checking turret
2. Remove crank assembly inside vehicle movement.
using #2 Phillips screw driver.
11. Rotate square shaft with shaft pin, until
3. Is there a nut in the center hole of the pin faces
ページ2に含まれる内容の要旨
FIGURE 1 PLASTIC PLUG O-RING WORM SHAFT SPRING SPACER SCREWS (TURRET) BACKUP FRAME SHAFT PIN ASSEMBLY (Referred to in #11.) TURRET ASSEMBLY CLAMP ELEVATE SHAFT GEAR SCREWS (CLAMP) OUTER BEARING TURRET BASE HUB ROOF EXTENSION, DIRECTIONAL HANDLE DIRECTIONAL HANDLE THREADED ROD CRANK ASSEMBLY FLAT WASHER HEX NUT 2
ページ3に含まれる内容の要旨
Instructions for Cutting Directional Handle Length 1. Place nut on threaded rod. FIGURE 2 2. Measure and cut threaded rod with hack Roof Directional Threaded Worm Gear saw. Use the chart, Figure 2, to deter- Thickness Handle Length Rod Length Shaft Length (Figure 3) (Figure 4) mine the length. 3. Remove the nut over cut end of threaded 1-1/2”.......... 2-7/8” ............ 2-3/4” ...........2-7/8” rod. This cleans the threads after cutting. 1-3/4”.......... 3-1/4” ............ 3” ................
ページ4に含まれる内容の要旨
Refer to drawing to identify parts. STEP 1. Release spring at base of feed arm. (This allows you to remove elevating shaft and spring without the dish popping up.) Next, lower antenna to travel position. STEP 2. Loosen set screw on elevating crank handle. Remove crank, #1, directional handle, #2 and extention, #3 (if used). STEP 3. On roof of vehicle, unscrew plug, #4, from top of gear housing. Use 1/4” hex head nut driver and turn elevating shaft counter- clockwise to remove. Carefully pull out
