ページ1に含まれる内容の要旨
15-2155a.fm Page 1 Wednesday, April 26, 2000 7:55 PM
VU-160XR VHF/UHF/FM Antenna with Matching Transformer
OWNER’S MANUAL — Please read before using this equipment.
Your RadioShack VHF/UHF/FM Antenna performs better than 2. Use the supplied hardware to loosely attach one of the sup-
standard antennas because of its special design features. plied mast clamp assemblies to the main boom, as shown.
U-Bolt
UHF Bowtie — delivers more of the UHF signal to your TV.
Mast Clamp
Since UHF signals are mo
ページ2に含まれる内容の要旨
15-2155a.fm Page 2 Wednesday, April 26, 2000 7:55 PM Note: If you prepare your own coaxial cable, be sure to slide UNFOLDING THE ANTENNA’S ELEMENTS the supplied matching transformer’s weather boot onto the ca- 1. Hold the main boom’s elements near the pivot points and ble before you attach the F-connector. pull them away from the boom until they snap into the self- locking plastic support insulators. Using Coaxial Cable Caution: To avoid damage to the elements, do not pull Main Lead-In Termi
ページ3に含まれる内容の要旨
15-2155a.fm Page 3 Wednesday, April 26, 2000 7:55 PM 1 the crossover wires to provide at least /2 inch of clearance ROUTING THE CABLE TO YOUR between parts. TV/VCR/FM RECEIVER If you use coaxial cable: Crossover Wires • Use plastic tape or mast standoff insulators to secure the coaxial cable to the mast at about 3-foot intervals. Continue down the roof and the side of the house using roof and wall standoff insulators. • Use coaxial cable nail-in clips every few feet to secure the cable betwee
ページ4に含まれる内容の要旨
15-2155a.fm Page 4 Wednesday, April 26, 2000 7:55 PM Make connections as shown if you have: TV To VHF/UHF FM Receiver • Coaxial antenna lead-in • Combined coaxial VHF/UHF terminal • Coaxial FM antenna terminal RadioShack Hybrid Splitter/Combiner Cat. No. 15-1141 Coaxial Lead-In from Antenna Make connections as shown if you have: UHF VHF 300 Ohm 75 Ohm • Twin-lead antenna lead-in • Twin-lead UHF terminals • Coaxial VHF terminal RadioShack • Twin-lead FM antenna terminals To FM Splitter with
