ページ1に含まれる内容の要旨
Preparation Cordless Telephone Answering System Useful Information
9
3
1 2
4 5 6
7 8
0
INT
R
C
ALL
ON
OFF
TCD420NZ_e.book Page 1 Tuesday, June 17, 2003 2:07 PM
Digital Cordless Answering System
Operating Instructions
Model No. KX-TCD420NZ
Contents
Preparation
Before Initial Use ......................... 2
Important Information .................. 3
Setting up .................................... 4
Cordless Telephone
Using the Telephone ................... 9
Making Calls........................
ページ2に含まれる内容の要旨
TCD420NZ_e.book Page 2 Tuesday, June 17, 2003 2:07 PM Before Initial Use Thank you for purchasing your new Panasonic digital cordless telephone. Dear purchaser, You have acquired a KX-TCD420NZ, which is a product made in regard with the Digital Enhanced Cordless Telecommunications (DECT). DECT technology is characterized by high-security protection against interceptions as well as high-quality digital transmission. This telephone was designed for a wide range of applications. For example,
ページ3に含まれる内容の要旨
Preparation TCD420NZ_e.book Page 3 Tuesday, June 17, 2003 2:07 PM Important Information Only use the power supply included with Battery Caution the product. Use only specified batteries. Do not connect the AC Adaptor to any AC Only use rechargeable batteries. outlet other than the standard AC230 V. Do not mix old and new batteries. The apparatus is approved for use with Do not dispose of batteries in a fire, they PQLV19AL power supply. may explode. This apparatus is unable to make Check l
ページ4に含まれる内容の要旨
LINE TCD420NZ_e.book Page 4 Tuesday, June 17, 2003 2:07 PM Setting up Connection Plug in the AC adaptor and the telephone line cord in order 1, 2, 3, 4. Hooks 1 2 4 Fasten the AC adaptor cord to prevent it from being disconnected. 3 The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use.) • Never install telephone wiring during a lightning storm. Battery Installation Please ensure the batteries are inserted as shown. part should be inser
ページ5に含まれる内容の要旨
Preparation TCD420NZ_e.book Page 5 Tuesday, June 17, 2003 2:07 PM Setting up Battery Charge Battery Life At the time of shipment, the batteries are Battery life is dependent on use and not charged. To charge, place the conditions but in general when using fully handset on the base unit. Please charge charged Ni-MH batteries (700 mAh): the batteries for about 7 hours before Talk time: 10hrs approx. initial use. During charging, the battery Standby time: 120hrs approx. icon is as shown below.
ページ6に含まれる内容の要旨
TCD420NZ_e.book Page 6 Tuesday, June 17, 2003 2:07 PM Setting up Symbols Used in This Operating Instructions Symbol Meaning To search the desired item, press UP or DOWN. To select the desired item, press RIGHT. To search and then to select the desired item, press UP or DOWN then RIGHT. To move the cursor to the right or to the left, press RIGHT or LEFT. To go to the next step. " " The words in " " indicate the words in display. Replacing the Batteries If the icon flashes after a few telepho
ページ7に含まれる内容の要旨
Preparation 9 3 1 2 4 5 6 7 8 0 INT R C ALL ON OFF LINE TCD420NZ_e.book Page 7 Tuesday, June 17, 2003 2:07 PM Setting up Location of Controls Handset 1 - : PHONEBOOK Button 2 - TALK Button Receiver 3 - Navigator Key Display 4 - REDIAL/PAUSE Button 1 6 2 R 5 - RECALL Button 7 3 4 8 6 - :MENU/OK Button 7 - OFF/POWER Button 5 Charge 9 C C 8 - CLEAR Button Contact Charge Microphone INT 9 - INTERCOM Button Contact Base unit PAGE Button and Indicator Handset Display Within range of a base unit Ca
ページ8に含まれる内容の要旨
TCD420NZ_e.book Page 8 Tuesday, June 17, 2003 2:07 PM Setting up Wall Mounting This unit can be mounted on a wall. - Insert screws into the wall. The centre of the screw hole should be 8 cm horizontally apart. - Connect the AC adaptor and the telephone line cord. - Arrange the wires as shown, then mount the unit. 8 cm Screws Hooks Wall Template 8 cm 8
ページ9に含まれる内容の要旨
Cordless Telephone TCD420NZ_e.book Page 9 Tuesday, June 17, 2003 2:07 PM Using the Telephone Power On/Off Power on Power off Press for more than 1 second.*1 Press for more than 2 seconds.*2 *1 When button is released, the display changes to the standby mode. *2 The display goes blank. Making a Call Pre-dialling Post-dialling Phone Number 11 Phone Number*1 2 2 Press TALK. Press TALK. *1 If you need correction, press CLEAR. Digit is cleared to the left, then enter numbers. Answering a Call Ter
ページ10に含まれる内容の要旨
TCD420NZ_e.book Page 10 Tuesday, June 17, 2003 2:07 PM Making Calls Redialling The last 10 numbers dialled are stored in the redial list automatically. Dialling with the Redial List Dialling the Last Number Dialled 11 23 2 Press REDIAL. Press Search the desired Press Press TALK. REDIAL.*1 dialled item. TALK. Editing the Dialled Number in the Redial List The 1st digit of 1 23 the desired dialled Search/Select the Search/Select Press REDIAL.*1 number blinks. desired dialled item. "EDIT CALL NO
ページ11に含まれる内容の要旨
Cordless Telephone TCD420NZ_e.book Page 11 Tuesday, June 17, 2003 2:07 PM Caller ID Caller ID Service Caller ID is a service of your Network provider and will only operate if you have subscribed to this feature. After subscribing to Caller ID, this phone will display the caller information. If your unit is connected to a PBX or a telephone line that does not support this service, you will not be able to use it. Caller ID does not display caller information while using the handset for an int
ページ12に含まれる内容の要旨
TCD420NZ_e.book Page 12 Tuesday, June 17, 2003 2:07 PM Caller ID Caller ID Display When receiving a call, the display shows its phone number. For example, a caller whose phone number is 01234567890 has been received. If you store a phone number with a name in the phonebook, the display shows caller’s name when receiving a call. If the caller has requested not to display his/her information, the display shows "PRIVATE". If the caller dialled from an area which does not provide Caller ID
ページ13に含まれる内容の要旨
Cordless Telephone TCD420NZ_e.book Page 13 Tuesday, June 17, 2003 2:07 PM Caller ID Caller ID List Information up to 50 different callers is stored from the most recent call to the oldest call in the caller list. When the 51st call is received, the oldest caller information is cleared. If you receive a call from the same phone number you stored with a name in the phonebook, the display will show the caller’s name. Calling Back 12 Search the desired Press TALK. received item.*1 Editing the R
ページ14に含まれる内容の要旨
TCD420NZ_e.book Page 14 Tuesday, June 17, 2003 2:07 PM Answering Calls Auto Talk If you set Auto Talk to on, you can answer the phone by lifting the handset off the base unit. 12 3 4 5 Press Search/Select Search/Select Search/Select Search/Select MENU. "SETTING HS". "OTHER OPT". "AUTO TALK". "ON" or "OFF". • To exit the operation, press any time. Temporary Bell Off When an external call is incoming, you can temporarily turn off the handset ringer. This function will not work when the hand
ページ15に含まれる内容の要旨
Cordless Telephone TCD420NZ_e.book Page 15 Tuesday, June 17, 2003 2:07 PM Phonebook You can store up to 20 caller information in the phonebook. If you received a call from the same phone number you stored with a name in the phonebook, the display will show the caller’s name. Storing a Caller Information Phone Number 1 23 4 Press MENU. Select Enter phone number. Press OK. "NEW PHONE". (max. 24 digits)*1 Name 56 Enter name. Press OK.*2 (max. 9 characters)*1 • To exit the operation, press any
ページ16に含まれる内容の要旨
TCD420NZ_e.book Page 16 Tuesday, June 17, 2003 2:07 PM Phonebook Editing a Caller Information The 1st digit of the 1 23 desired phone Press Search/Select Select "EDIT". number blinks. PHONEBOOK.*1 desired item. AND/ C Number 6 4 5 OR Edit the phone Move cursor. Press CLEAR.*2 Press OK. number.*3 AND/ C Name 78 9 OR Move cursor. Edit the name.*4 Press CLEAR.*2 Press OK. Clearing a Caller Information 12 3 4 Search/Select Search/Select Search/Select Press desired item
ページ17に含まれる内容の要旨
Cordless Telephone TCD420NZ_e.book Page 17 Tuesday, June 17, 2003 2:07 PM Phonebook Storing the Phone Number into the Phonebook When Pre-dialling Phone Number*1 Name 1 23 4 Enter name.*2 Press OK to Press OK twice. store the number. 5 Press OK. • To exit the operation, press any time. *1 If you need correction, press CLEAR. Digit is cleared to the left, then enter numbers. *2 To enter characters, see Character Selection on page 15. Storing the Number from the Redial/Caller List into the Ph
ページ18に含まれる内容の要旨
TCD420NZ_e.book Page 18 Tuesday, June 17, 2003 2:07 PM Phonebook Hot Key You can assign the dialling buttons 1 through 9 as hot keys. You can choose 9 phone numbers from the phonebook. Registering a Phone Number as a Hot Key 1 23 4 Press Search/Select Search/Select Search/Select PHONEBOOK.*1 desired item. "HOT KEY REG". desired dialling button number.*2 5 Search/Select "YES". Dialling with Hot Key Press and hold the dialling button registered as a hot key. 12 Press TALK. Clearing the Hot
ページ19に含まれる内容の要旨
Cordless Telephone TCD420NZ_e.book Page 19 Tuesday, June 17, 2003 2:07 PM Handset Settings : Time Alarm Before programming, please follow steps 1 to 3. You must set the clock before setting the time alarm. 12 3 Press MENU. Search/Select Search/Select "SETTING HS". "TIME ALARM". Setting Alarm Time Time 45 6 7 Search/Select Enter time. Press OK. Search/Select "SET TIME". 4-digit "OFF", (24 hour clock) "ONCE" or "REPEAT DAILY". Setting Time Alarm On/Off 45 Search/Select Search/Select "SET AL
ページ20に含まれる内容の要旨
TCD420NZ_e.book Page 20 Tuesday, June 17, 2003 2:07 PM Handset Settings : Ringer Option Before programming, please follow steps 1 to 3. 12 3 Press MENU. Search/Select Search/Select "SETTING HS". "RINGER OPT". Setting the Ringer Volume The choices are 6 levels and off. 45 Search/Select Search/Select "RINGER VOL". desired ringer volume. • If "RINGER OFF" is selected, is displayed. Setting the Ringer Pattern for External Call/Internal Call/Paging/Alarm There are 20 patterns available on each
