ページ1に含まれる内容の要旨
4289 Bonny Oaks Drive • Chattanooga, TN 37406
TEL: (800) 426-3738 • FAX: (800) 325-8871
Email: claritycs@plantronics.com Website: www.clarityproducts.com
ページ2に含まれる内容の要旨
E N G L I S H JV-35 ™ The Talking Phone JV F R A N Ç A I S Operating Instructions Ameriphone products are manufactured by ® Clarity , a Division of Plantronics, Inc. 4289 Bonny Oaks Drive, Chattanooga,TN 37406 Tel: (800) 426-3738 Fax: (800) 325-8871 Email: claritycs@plantronics.com Website: www.clarityproducts.com ©2004 Clarity, a Division of Plantronics, Inc. All rights reserved. Ameriphone, Amplifying Your Life, Clarity and The Talking Phone are trademarks or regis- tered trademarks of
ページ3に含まれる内容の要旨
Contents Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . ii Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Package Checklist . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Features Identification . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Installation A. Desk mounting . . . . . . . . . . . . . . . . . . . . .4 B. Wall mounting . . . . . . . . . . . . . . . . . . . . .4 C. Batteries . . . . . . . . . . . . . . .
ページ4に含まれる内容の要旨
E Important Safety Instructions N G L When using your telephone 7.Place this telephone on a I equipment, basic safety precautions stable surface. Serious damage S should always be followed to and/or injury may result if the H reduce the risk of fire, electric telephone falls. shock and persons including the 8.Do not cover the slots and following: openings on this telephone. 1.Read and understand all This telephone should never instructions. be placed near or over a 2.Follow all warnings a
ページ5に含まれる内容の要旨
Important Safety Instructions covered by the operating dangerous voltage points or instructions. Improper short out parts that could result in a risk of fire or adjustment may require electrical shock. Never spill extensive work by a qualified technician to liquid of any kind on the restore the telephone to telephone. 13. To reduce the risk of electrical normal operation. shock, do not take this phone E. If the telephone has been dropped or the case has apart. Opening or removing
ページ6に含まれる内容の要旨
E Important Safety N Instructions G L may explode. Check with installed using an acceptable I local codes for possible method of connection. In some S special disposal instructions. cases, the company’s inside H wiring associated with a single ADDITIONAL SAFETY NOTES line individual service may be FOR CANADIAN USERS extended by means of a certified connector assembly (telephone The following items are included extension cord). The customer as part of the CS-03 Requirements. should be aware
ページ7に含まれる内容の要旨
Important Safety Instructions CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate. The Ringer Equivalent Number is an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalent Number of all the d
ページ8に含まれる内容の要旨
E Introducing the JV-35 N G L Thank you for selecting the I exciting new JV-35 from S H Ameriphone. It has been designed to meet the highest quality standards to provide you with years of convenient and trouble-free service Please read these operating instructions thoroughly before using your telephone. Keep this manual for future reference. You must save your sales receipt as proof of purchase in the event that you need warranty service. If you have any questions F about your JV-35, please R c
ページ9に含まれる内容の要旨
Package Checklist Handset Base Unit Phone Cords JV-35 OPERATING INSTRUCTIONS Telephone Line Cords AND QUICK GUIDE Handset Operating Guides Coil Cord Phone Base Plate Figure 1 - Package Components 2
ページ10に含まれる内容の要旨
E Features on the JV-35 N G L Ringer volume control switch I S Audio output jack H AC adapter Announcement switch Tone / Pulse switch Emergency buttons Braille characters Raised letters for easy identification REDIAL button MEMORY button VOL control (volume) HOLD AMPLIFY button button TONE PROG button selector (program) Figure 2 - Base Unit Controls 3
ページ11に含まれる内容の要旨
Installation B. Wall Mounting A. Desk Mounting 1. Plug in the long phone 1. Pull the handset hook cord. out and reverse its position so that the 2. Plug the handset cord hook points up. into the telephone. Fig. 4- Repositioning the hook Fig.3 - Connections and installation 2. Install the Base Plate by sliding the small tabs 3. Insert the AC Adapter into the upper slots. cord into the receptacle Push on the bottom of on the back of the the Base Plate until it JV-35. Then plug the sn
ページ12に含まれる内容の要旨
E Installation N G L 3. Plug in the short phone 6. Lift the handset and I cord. listen for a dial tone. S H 4. Insert the AC Adapter 7. Your JV-35 is ready to cord into the receptacle use. on the back of the JV-35. Then plug the AC Adapter into an C. Batteries electrical outlet. E S During a power outage the P JV-35 will maintain full A function if back-up batteries Ñ have been installed in O advance. If batteries are not L installed during a power outage, the AMPLIFY button, the voic
ページ13に含まれる内容の要旨
Installation Fig. 7 - Battery installation 6
ページ14に含まれる内容の要旨
E Operating your JV-35 N G L A. Dialing I S H Pick up the handset and dial like any other telephone. As you dial, the numbers you Figure 8 - AMPLIFY Button are dialing will be announced (Seven, five, two, etc.) If you 2.Adjust the VOL control read Braille, you can use the to suit your hearing. small bump on the 5 button to help identify correct buttons. You can also use the Braille characters on the buttons to find the letters on each button. For example, the 2 button has Braille Fig. 9- Vol
ページ15に含まれる内容の要旨
Operating your JV-35 warning printed in Braille to C. Adjusting The Tone the back of the handset (See, Diagram A). 1. When you hear a voice on the line, press the AMPLIFY button. Diagram A - JV35 handset Fig. 11- Amplify Button Note: In standard use, the 2. Adjust the TONE selector amplifier turns off whenever to suit your hearing. you hang up the telephone. This is a useful feature if many people use the phone. If you want the amplifier to always remain on, slide the Volume Reset Override sw
ページ16に含まれる内容の要旨
E Operating your JV-35 N G L Note: When the JV-35 is on I HOLD, if you pick up another S phone that is on the same H line, the JV-35 will automatically hang up. You Fig. 13 - Ringer Switch can continue your call on the other phone. E. Hold F. Last Number Redial E 1. To put the phone on S hold, press the HOLD P Lift the handset and press A button and put the the REDIAL button to dial Ñ handset in its cradle. the last number you O The red light in the Ring dialed. L Flasher shows HOLD is o
ページ17に含まれる内容の要旨
Operating your JV-35 G. Programming The 3. Press PROG button Emergency Buttons again. The Emergency Buttons can 4. Press one of the be programmed to dial Emergency buttons. numbers with one touch. You may wish to use these buttons for police, fire or medical response. 1. Lift the handset and Fig. 18 - Emergency Button press the PROG button. 5. Hang up the handset. 6. The number is now stored into the Emergency button you Fig. 16 - PROG Button selected. 2. Enter the phone number as y
ページ18に含まれる内容の要旨
E Operating your JV-35 N G L H. Dialing With An Emergency 2. Enter the phone number I as you would normally S Button H dial it. 1. Lift the handset. 2. Press one of the Emergency buttons. You will hear an announcement similar to: Fig. 20 - Entering Number “Emergency One” and then the number you have 3. Press the PROG button stored for that button will be again. automatically dialed. 4. Press MEMORY, then I. Programming Frequently one of the number Dialed Numbers buttons: 0, 1, 2, 3, etc.
ページ19に含まれる内容の要旨
Operating your JV-35 7. To change a stored automatically dialed. number or to program another memory K. Recording Emergency button, repeat this Button Identification process from step 1. Announcements The JV-35 comes with factory J. Memory Dialing pre-recorded announcements to identify each Emergency button 1. Lift the handset. such as “Emergency One” etc. You can erase these 2. Press MEMORY and identification announcements one of the number and record announcements of buttons. your own,
ページ20に含まれる内容の要旨
E Operating your JV-35 N G L beep” sound. This 4. After three seconds I confirms the JV-35 is there will be a “beep” S H ready to be programmed. to tell you recording has stopped. Your recording will be played back immediately so you can check it, followed by a Fig. 22 - Announcement Switch “beep-beep” sound. 3. Press the desired 5. Now you can repeat Emergency button. steps 3 and 4 if you After the “beep,” speak want to change your into the handset to announcement or if you record an
