ページ1に含まれる内容の要旨
CM16.book Page i Friday, June 18, 2004 3:22 PM
ページ2に含まれる内容の要旨
CM16.book Page i Friday, June 18, 2004 3:22 PM Table of Contents SAFETY INFORMATION ...............................................................................................2 Handset and Base Station ..............................................................................................2 Batteries.................................................................................................................................2 INSTALLATION .........................
ページ3に含まれる内容の要旨
CM16.book Page 2 Friday, June 18, 2004 3:22 PM SAFETY INFORMATION Prior to installing and using the telephone, please read the following important safety information. HANDSET AND BASE STATION Do not: • Rely only on this telephone as your only means of communication in the event of an emergency. As this handset uses radio signals, a connection to the telephone network cannot be guaranteed in all circumstances. • Use this handset near medical equipme
ページ4に含まれる内容の要旨
CM16.book Page 3 Friday, June 18, 2004 3:22 PM In operation: • It is normal for the batteries to become warm when charging. • Discharge the batteries from time to time to prolong their service life. To do this, do not place the phone back into the charger stand until the batteries are completely or almost completely discharged. The battery icon on the display will indicate when the batteries are low and an alert tone is sounded every three minutes. • Only use batteries
ページ5に含まれる内容の要旨
CM16.book Page 4 Friday, June 18, 2004 3:22 PM INSTALLATION The CM-16 consists of a base station, wireless handset and a charging base stand. The following diagram provides an overview of the installation of the product using the power supply provided. Your System Administrator should be aware of the Meridian settings required to make this telephone operational within your business environment. Base Station CM-16 Handset ® Meridian 1 Charging Cradle Base Station The base st
ページ6に含まれる内容の要旨
CM16.book Page 5 Friday, June 18, 2004 3:22 PM Base Station (continued) To wall mount the base station: • Locate the wall mounting strip located on the back side of the base station • Slide the strip out from the base station (Fig A) • Turn the strip around and secure firmly to the wall using the screws supplied (Fig B) • Plug the line cord into the jack on the unit • Slide the base station over the strip until it clicks into place (Fig C) Figure A Figure B Figure C Chargi
ページ7に含まれる内容の要旨
CM16.book Page 6 Friday, June 18, 2004 3:22 PM Battery Charging The handset is powered by a nickel metal hydride battery pack. To install and charge the battery: 1. Slide the cover off of the battery compartment. 2. Place the battery pack in the compartment with the connector wires pointing towards the bottom of the handset. 3. Connect the battery terminal wire to the charging pins located in the compartment 4. Slide the cover of the battery compartment back onto the ha
ページ8に含まれる内容の要旨
CM16.book Page 7 Friday, June 18, 2004 3:22 PM CM-16 HANDSET KEY FUNCTIONS 9 1 2 3 5 4 10 5 11 6 12 14 7 13 14 8 15 7 Model CM-16 User Guide
ページ9に含まれる内容の要旨
CM16.book Page 8 Friday, June 18, 2004 3:22 PM CM-16 HANDSET KEY FUNCTIONS Function # Function Description 1 Receiver 2 Volume key • During Ringing: Adjusts ringer volume • During a call: Adjusts receiver volume • During text mode (not in a call): Moves cursor right/left 3 Display F F 4 Features F F Key List • Access key to the M1 Feature key list • Scrolls up when in the various lists • Add a space during editing 5 Softkeys • Activates
ページ10に含まれる内容の要旨
CM16.book Page 9 Friday, June 18, 2004 3:22 PM SCREEN DISPLAY The screen display on the CM-16 provides five lines, 15 characters per line of display area. Pressing any key will light up the display if the Backlight option is On. The display provides a variety of information, using text or icons, pertaining to set status, including battery strength, reception range and selected settings. Caller information, option menus, instructions, time and date and general
ページ11に含まれる内容の要旨
CM16.book Page 10 Friday, June 18, 2004 3:22 PM Ringer Volume This Icon appears when the phone is not in use to indicate the ringer volume level. As the ringer volume level is increased, from off to high, the box will go from empty to fully black. This icon does not appear when silent alert is activated. The bell icon and the vibrate icon can be present at the same time. This means both the vibrate and audio alerters are active. If the vibrate icon is shown, that means the phone is in
ページ12に含まれる内容の要旨
CM16.book Page 11 Friday, June 18, 2004 3:22 PM MAKING AND ANSWERING CALLS To make a call: Press the O O O O key to obtain dial tone and use the Keypad to dial the number OR Predial the number first using the Keypad. The number, as entered, will appear on the display. If the number is correct, press the O O O O key to dial the number. If number is incorrect use the LLLL key or press down on the volume key to erase digits from right to left. If you need to add a pause to a number (for example
ページ13に含まれる内容の要旨
CM16.book Page 12 Friday, June 18, 2004 3:22 PM O Op pt ti io on ns s • Once the selected number appears on the display, press the O Op pt ti io on ns s S Sa av ve e D Di ir re ec ct to or ry y a an nd d = =N Ne ex xt t softkey — the display shows S Sa av ve e 4D Di ir re ec ct to or ry y a an nd d s= =N Ne ex xt t S Se el le ec ct t • Press the S Se el le ec ct t softkey. If there is no name associated with the number, the display will prompt, to enter a name to save the entry.
ページ14に含まれる内容の要旨
CM16.book Page 13 Friday, June 18, 2004 3:22 PM Note: The volume key can also be used to adjust the right/left cursor to add spaces or to erase characters on the display when editing or creating names, key labels etc. To adjust the receiver volume: • While on a call, press the top of the key to increase the receiver volume and press the bottom of the key to decrease the volume. The receiver volume icon on display will indicate the current volume level. In absence of a PBX, the receiver vo
ページ15に含まれる内容の要旨
CM16.book Page 14 Friday, June 18, 2004 3:22 PM OPTIONS To access the options list: M M 1. Press the M M key when the phone is not in use — the display will U Us se e t to o v vi ie ew w EE LL indicate U Us se e sr t to o v vi ie ew w. Use the EE and LL keys for scrolling. 2. There are ten options that can be accessed by either scrolling to the option or by using the keypad to dial the option number as per the table below. Option # Options list 1 Language 2 Key label 3 Ring tone 4 Cu
ページ16に含まれる内容の要旨
CM16.book Page 15 Friday, June 18, 2004 3:22 PM Key label The Key label option gives access to the display text associated with the 14 Meridian features that can be programmed with to CM-16 handset. Text to identify a specific feature can be added, modified or deleted or all feature key text can be deleted at once. Labels can have up to 14 characters. To edit key label text Press the C C C Ch h h ha a a an n n ng g g ge e e e softkey from the key label display • At the Edit display screen, pr
ページ17に含まれる内容の要旨
CM16.book Page 16 Friday, June 18, 2004 3:22 PM Ring Tone The CM-16 offers the choice of four different ring tones. To change the ring tone, follow the display menu prompts using the two softkeys as required to change, cancel or select a ring tone. Each of the four ring tones can be heard prior to selection. The display will always show — — — —c c c co o o on n n nf f f fi i i ir r r rm m m me e e ed d d d— — — — to indicate when a selection has been made. Pressing the C C C Ca a a a
ページ18に含まれる内容の要旨
CM16.book Page 17 Friday, June 18, 2004 3:22 PM Vibrate The Vibrate option allows the CM-16 handset to signal an incoming call by vibrating as well as ringing. By default, this option is always Off. To enable this feature, press the C C C Ch h h ha a a an n n ng g g ge e e e softkey and the display will indicate V V V Vi i i ib b b br r r ra a a at t t te e e e O O O On n n n and- - - -c c c co o o on n n nf f f fi i i ir r r rm m m me e e ed d d d- - - - and will quickly return to the
ページ19に含まれる内容の要旨
CM16.book Page 18 Friday, June 18, 2004 3:22 PM Backlight The Backlight option enables the user to have the display diffuser lighted or not when a keypad key is pressed. Press C C C Ch h h ha a a an n n ng g g ge e e e softkey to turn Backlight ON or Off. Once the Backlight option is chosen, the screen will display B B B Ba a a ac c c ck k k kl l l li i i ig g g gh h h ht t t t O O O On n n n or B B B Ba a a ac c c ck k k kl l l li i i ig g g gh h h ht t t t O O O Of f f ff f f f
ページ20に含まれる内容の要旨
CM16.book Page 19 Friday, June 18, 2004 3:22 PM DIRECTORY The directory can store up to 50 names and numbers, which are displayed in alphabetical order. If no name is entered, the entries are sorted by number, at the beginning of the directory. Adding a name and number to the Directory 1. Press Directory softkey 2. Press A A A Ad d d dd d d d softkey. Display prompts E E E En n n nt t t te e e er r r r n n n nu u u um m m mb b b be e e er r r r 3. Enter the number using the keypad. You c
