ページ1に含まれる内容の要旨
[ Quick Start Guide ]
FIBERE CHANNEL SWITCH INSTALLATION d
®
SANbox 1400 Series
®
for Windows Operating Systems
QUICK START GUIDE
ページ2に含まれる内容の要旨
Purchasers of OEM products should consult with the OEM for support. Support Headquarters QLogic Corporation 12984 Valley View Road Eden Prairie, MN 55344-3657 USA QLogic Web Site www.qlogic.com Technical Support Web Site support.qlogic.com Technical Support Email support@qlogic.com Technical Training Email tech.training@qlogic.com North American Region Email support@qlogic.com Phone +1-952-932-4040 Fax +1 952-932-4018 Europe, Middle East, and Africa Region Email emeasupport@qlogic.com Phone Numb
ページ3に含まれる内容の要旨
Quick Start Guide Installation Instructions Congratulations on your purchase of the SANbox® 1400 Series Fibre Channel switch. This Quick Start Guide describes the simple steps to install and activate your new switch using a Windows® workstation. For advanced options and instructions (including Solaris®, Linux®, and MacOS X® installations), refer to the SANbox 1400 Series Fibre Channel Switch Installation Guide on the CD provided with the switch. If you would prefer to view this quick start gu
ページ4に含まれる内容の要旨
Step 3. Install SFPs An SFP transceiver is required for each switch port that will be connected to a device, device loop, or another switch. ❑ To install an SFP transceiver, insert the transceiver into the switch port and gently press until it snaps in place. The transceiver will fit only one way. If the transceiver does not install under gentle pressure, flip it over and try again. Step 4. Apply Power to the Switch ❑ Connect the external DC power supply to the back of the switch. HEARTBEAT ❑
ページ5に含まれる内容の要旨
Step 6. Install the SANsurfer Switch Manager Application The SANsurfer Switch Manager application includes the Configuration Wizard. This wizard auto-detects and configures the switch based on selected options and recommended settings. To install the SANsurfer Switch Manager application on a Windows workstation/server, perform the following steps: 1. Insert the supplied CD into the CD ROM drive of the Windows workstation/server. 2. From the tabs at the top of the product introduction screen, c
ページ6に含まれる内容の要旨
4
ページ7に含まれる内容の要旨
© 2006 QLogic Corporation. QLogic, the QLogic logo, the Powered by QLogic logo, SANbox, SANsurfer, and SANsurfer Management Suite are registered trademarks or trademarks of QLogic Corporation. All other brands and product names are trademarks or registered trademarks of their respective owners. Information supplied by QLogic is believed to be accurate and reliable. QLogic Corporation assumes no responsibility for any errors in this brochure. QLogic Corporation reserves the right, without notice,
ページ8に含まれる内容の要旨
*50638-01B* QLogic Corporation 26650 Aliso Viejo Parkway Aliso Viejo, CA 92656 949.389.6000 www.qlogic.com 50638-01 B J