ページ1に含まれる内容の要旨
SmartSwitch 9000
9E531-24
24 Port 10BASE-FL Ethernet Module
User’s Guide
9033274
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Notice NOTICE Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made. The hardware, firmware, or software described in this manual is subject to change without notice. IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING B
ページ4に含まれる内容の要旨
Notice CABLETRON SYSTEMS, INC. PROGRAM LICENSE AGREEMENT IMPORTANT: THIS LICENSE APPLIES FOR USE OF PRODUCT IN THE FOLLOWING GEOGRAPHICAL REGIONS: CANADA MEXICO CENTRAL AMERICA SOUTH AMERICA BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT, CAREFULLY READ THIS LICENSE AGREEMENT. This document is an agreement (“Agreement”) between You, the end user, and Cabletron Systems, Inc. (“Cabletron”) that sets forth your rights and obligations with respect to the Cabletron software program (“Program”) in
ページ5に含まれる内容の要旨
Notice 6. EXCLUSION OF WARRANTY. Except as may be specifically provided by Cabletron in writing, Cabletron makes no warranty, expressed or implied, concerning the Program (including its documentation and media). CABLETRON DISCLAIMS ALL WARRANTIES, OTHER THAN THOSE SUPPLIED TO YOU BY CABLETRON IN WRITING, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH RESPECT TO THE PROGRAM, THE ACCOMPANYING WRITTEN MATER
ページ6に含まれる内容の要旨
Notice export to Country Groups D:1 or E:2 the direct product of the plant or a major component thereof, if such foreign produced direct product is subject to national security controls as identified on the U.S. Commerce Control List or is subject to State Department controls under the U.S. Munitions List. 5. UNITED STATES GOVERNMENT RESTRICTED RIGHTS. The enclosed Product (i) was developed solely at private expense; (ii) contains “restricted computer software” submitted with restricted right
ページ7に含まれる内容の要旨
Notice 4. EXPORT REQUIREMENTS. You understand that Cabletron and its Affiliates are subject to regulation by agencies of the U.S. Government, including the U.S. Department of Commerce, which prohibit export or diversion of certain technical products to certain countries, unless a license to export the product is obtained from the U.S. Government or an exception from obtaining such license may be relied upon by the exporting party. If the Program is exported from the United States pursuant to
ページ8に含まれる内容の要旨
Notice SAFETY INFORMATION CLASS 1 LASER TRANSCEIVERS THE 9H539-24 MODULE USES CLASS 1 LASER TRANSCEIVERS. READ THE FOLLOWING SAFETY INFORMATION BEFORE INSTALLING OR OPERATING THESE MODULES. The Class 1 laser transceivers use an optical feedback loop to maintain Class 1 operation limits. This control loop eliminates the need for maintenance checks or adjustments. The output is factory set, and does not allow any user adjustment. Class 1 Laser transceivers comply with the following safety stand
ページ9に含まれる内容の要旨
Notice DECLARATION OF CONFORMITY Application of Council Directive(s): 89/336/EEC 73/23/EEC Manufacturer’s Name: Cabletron Systems, Inc. Manufacturer’s Address: 35 Industrial Way PO Box 5005 Rochester, NH 03867 European Representative Name: Mr. J. Solari European Representative Address: Cabletron Systems Limited Nexus House, Newbury Business Park London Road, Newbury Berkshire RG14 2PZ, England Conformance to Directive(s)/Product Standards: EC Directive 89/336/EEC EC Directive 73/23/EEC EN 55022
ページ10に含まれる内容の要旨
Notice viii
ページ11に含まれる内容の要旨
Contents Chapter 1 Introduction Features .......................................................................................................................... 1-1 Related Manuals............................................................................................................ 1-7 Getting Help .................................................................................................................. 1-8 Chapter 2 Installing the SmartSwitch 9000 Module Unpacking the Module ..
ページ12に含まれる内容の要旨
Contents Dimensions ...................................................................................................... 5-2 Weight............................................................................................................... 5-2 Environment.................................................................................................... 5-2 x
ページ13に含まれる内容の要旨
Chapter 1 Introduction The 9E531-24 shown in Figure 1-1, is a 10BASE-FL Ethernet switching module for Cabletron Systems SmartSwitch 9000 chassis, providing 24 MT-RJ MMF ports. The 9E531-24 can be used to connect individual 10 BASE-FL user devices and servers. Features Connectivity The 9H532-24 connects to Ethernet networks or workstations through the 24 MTRJ ports on the front panel. These ports are IEEE 802.1D and 802.3 10BASE-FL compliant. The ports support Multimode fiber cables with att
ページ14に含まれる内容の要旨
Introduction ETHERNET 9E531-24 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 Figure 1-1. The 9E531-24 1-2
ページ15に含まれる内容の要旨
Introduction Duplex Mode Through Local Management, each port on the 9E531-24 can be configured to support either full or half duplex mode of operation. Runtime IP Address Discovery This feature enables the modules to automatically accept an IP address from a Boot Strap Protocol (BootP) server on the network into NVRAM without requiring a user to enter an IP address through Local Management. When the modules are connected to the network and powered up, Runtime IP Address Discovery (RAD) check
ページ16に含まれる内容の要旨
Introduction Management Management of the 9E531-24 module and SmartSwitch chassis and any optional equipment is accomplished using the Local Management application or remote SNMP management stations. Local Management is accessible through the RS232 COM port on the Environmental Module using a local VT100 terminal, or a remote VT100 terminal via a modem connection, and in-band via a Telnet connection. In-band remote management is possible through Webview or any SNMP compliant Network Manage
ページ17に含まれる内容の要旨
Introduction device, and to have it pause its transmission while the receiving device processes the frames already received. Flow control can be enabled or disabled on a port-by- port basis. Both devices must support the IEEE 802.3x standard for flow control to work. The 9E531-24 supports the following two types of flow control: • frame based 802.3x • back pressure Frame based 802.3x flow control is supported on all Ethernet ports operating in the full duplex mode. Back pressure flow contro
ページ18に含まれる内容の要旨
Introduction Standards Compatibility The 9E531-24 is fully compliant with the IEEE 802.3, 802.3x, 802.1Q, and 802.1p standards. The 9E531-24 provides IEEE 802.1D Spanning Tree Algorithm (STA) support to enhance the overall reliability of the network and protect against “loop” conditions. The 9E531-24 supports a wide variety of industry standard MIBs including RFC 1573 (MIB II), RFC 1271 (RMON), RFC 1493 (Bridge MIB), RFC 1354 (FIB MIB), and RFC 1190 (Path MTU Discovery). A full suite of C
ページ19に含まれる内容の要旨
Introduction Related Manuals The Cabletron Systems manuals listed below should be used to supplement the procedures and technical data contained in this manual. SmartSwitch 9000 Installation Guide SmartSwitch 9000 9C300-1 Environmental Module User’s Guide SmartSwitch 9000 9C214-1 AC Power Supply User’s Guide SmartSwitch 9000 9X5XX Series Local Management User’s Guide Cabling Guide Ethernet Technology Guide Network Troubleshooting Guide WebView User’s Guide SmartTrunk User’s Guide 1-7
ページ20に含まれる内容の要旨
Introduction Getting Help For additional support related to this device or document, contact Cabletron Systems using one of the following methods: World Wide Web http://www.cabletron.com/ Phone (603) 332-9400 Internet mail support@cabletron.com FTP ftp://ftp.cabletron.com/ Login anonymous Password your email address To send comments or suggestions concerning this document, contact the Cabletron Systems Technical Writing Department via the following email address: TechWriting@cabletron.com Ma
