ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
EZ Switch 10/100/1000 User Guide From SMC’s EZ line of low-cost workgroup LAN solutions 38 Tesla May 2005 Irvine, CA 92618 Pub #: 150000018400H R01 Phone: (949) 679-8000
ページ3に含まれる内容の要旨
Copyright Information furnished by SMC Networks, Inc. (SMC) is believed to be accurate and reliable. However, no responsibility is assumed by SMC for its use, nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of SMC. SMC reserves the right to change specifications at any time without notice. Copyright © 2005 by SMC Networks, Inc. 38 Tesla Irvine, CA 92618 Al
ページ4に含まれる内容の要旨
LIMITED WARRANTY Limited Warranty Statement: SMC Networks, Inc. (“SMC”) warrants its products to be free from defects in workmanship and materials, under normal use and service, for the applicable warranty term. All SMC products carry a standard 90-day limited warranty from the date of purchase from SMC or its Authorized Reseller. SMC may, at its own discretion, repair or replace any product not operating as warranted with a similar or functionally equivalent product, during the applicable
ページ5に含まれる内容の要旨
PERSON'S MISUSE, NEGLECT, IMPROPER INSTALLATION OR TESTING, UNAUTHORIZED ATTEMPTS TO REPAIR, OR ANY OTHER CAUSE BEYOND THE RANGE OF THE INTENDED USE, OR BY ACCIDENT, FIRE, LIGHTNING, OR OTHER HAZARD. LIMITATION OF LIABILITY: IN NO EVENT, WHETHER BASED IN CONTRACT OR TORT (INCLUDING NEGLIGENCE), SHALL SMC BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL, INDIRECT, SPECIAL, OR PUNITIVE DAMAGES OF ANY KIND, OR FOR LOSS OF REVENUE, LOSS OF BUSINESS, OR OTHER FINANCIAL LOSS ARISING OUT OF OR IN CONNEC
ページ6に含まれる内容の要旨
COMPLIANCES FCC - Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with instructions, may cause harmful interference to radio communications. However, there is no gu
ページ7に含まれる内容の要旨
Immunity: • Product family standard according to EN 55024:1998 • Electrostatic Discharge according to EN 61000-4-2:1995 (Contact Discharge: ± 4 kV, Air Discharge: ± 8 kV) • Radio-frequency electromagnetic field according to EN 61000-4-3:1996 (80 - 1000 MHz with 1 kHz AM 80% Modulation: 3 V/m) • Electrical fast transient/burst according to EN 61000-4-4:1995 (AC/DC power supply: ± 1 kV, Data/Signal lines: ± 0.5 kV) • Surge immunity test according to EN 61000-4-5:1995 (AC/DC Line to Line:
ページ8に含まれる内容の要旨
Please read the following safety informa- tion carefully before installing the Switch: WARNING: Installation and removal of the unit must be carried out by qualified personnel only. • This guide is intended for use by network administrators who are responsible for setting up and installing network equipment; consequently it assumes a basic working knowledge of LANs (Local Area Networks). • The unit must be connected to an earthed (grounded) outlet to comply with international safety stand
ページ9に含まれる内容の要旨
France and Peru only † This unit cannot be powered from IT supplies. If your supplies are of IT type, this unit must be powered by 230 V (2P+T) via an iso- lation transformer ratio 1:1, with the secondary connection point labelled Neutral, connected directly to earth (ground). † Impédance à la terre Power Cord Set U.S.A. and The cord set must be UL-approved and CSA Canada certified. The minimum specifications for the flexible cord are: - No. 18 AWG - not longer than 2 meters, or 16 AWG. -
ページ10に含まれる内容の要旨
Veuillez lire à fond l'information de la sécurité suivante avant d'installer le Switch: AVERTISSEMENT: L’ installation et la dépose de ce groupe doivent être confiés à un personnel qualifié. • Ne branchez pas votre appareil sur une prise secteur (alimentation électrique) lorsqu'il n'y a pas de connexion de mise à la terre (mise à la masse). • Vous devez raccorder ce groupe à une sortie mise à la terre (mise à la masse) afin de respecter les normes internationales de sécurité. • Le coupleu
ページ11に含まれる内容の要旨
Cordon électrique - Il doit être agréé dans le pays d’ utilisation Etats-Unis et Canada: Le cordon doit avoir reçu l ’ homolo- gation des UL et un certificat de la CSA. Les spe'cifications minimales pour un cable flexible sont AWG No. 18, ouAWG No. 16 pour un cable de longueur infe'rieure a` 2 me'tres. - type SV ou SJ - 3 conducteurs Le cordon doit être en mesure d’ acheminer un courant nominal d’ au moins 10 A. La prise femelle de branchement doit être du type à mise à la terre (mise à
ページ12に含まれる内容の要旨
• Das Gerät sollte nicht an eine ungeerdete Wechselstromsteckdose angeschlossen werden. • Das Gerät muß an eine geerdete Steckdose angeschlossen werden, welche die internationalen Sicherheitsnormen erfüllt. • Der Gerätestecker (der Anschluß an das Gerät, nicht der Wandsteckdosenstecker) muß einen gemäß EN 60320/IEC 320 konfigurierten Geräteeingang haben. • Die Netzsteckdose muß in der Nähe des Geräts und leicht zugänglich sein. Die Stromversorgung des Geräts kann nur durch Herausziehen de
ページ13に含まれる内容の要旨
Warnings and Cautionary Messages Warning: This product does not contain any user serviceable parts. Warning: Installation and removal of the unit must be carried out by qualified personnel only. Warning: When connecting this device to a power outlet, connect the field ground lead on the tri-pole power plug to a valid earth ground line to prevent electrical hazards. Warning: This product uses lasers to transmit signals over fiber optic cable. The lasers are compliant with the requirements
ページ14に含まれる内容の要旨
Environmental Statement The manufacturer of this product endeavours to sustain an environmentally-friendly policy throughout the entire production process. This is achieved though the following means: • Adherence to national legislation and regulations on environmental production standards. • Conservation of operational resources. • Waste reduction and safe disposal of all harmful un-recyclable by-products. • Recycling of all reusable waste content. • Design of products to maximize recyclab
ページ15に含まれる内容の要旨
Safety Compliance Underwriters Laboratories Compliance State- ment Important! Before making connections, make sure you have the correct cord set. Check it (read the label on the cable) against the following: Operating Voltage Cord Set Specifications 120 Volts UL Listed/CSA Certified Cord Set Minimum 18 AWG Type SVT or SJT three conductor cord Maximum length of 15 feet Parallel blade, grounding type attachment plug rated 15 A, 125 V 240 Volts (Europe only) Cord Set with H05VV-F cord having
ページ16に含まれる内容の要旨
Contents INTRODUCTION 1 Description of Hardware 1 Features and Benefits 1 Front Panel RJ-45 Ports 2 SMCGS5 Front and Rear Panels 3 SMCGS8 Front and Rear Panels 4 Rear Panel 4 INSTALLING THE SWITCH 5 Package Checklist 5 Selecting a Site 5 Instructions 6 APPLICATION EXAMPLE 8 TROUBLESHOOTING 9 SPECIFICATIONS 10
ページ17に含まれる内容の要旨
ページ18に含まれる内容の要旨
EZ Switch 10/100/1000 INTRODUCTION The EZ Switch 10/100/1000, SMCGS5 and SMCGS8, are high-performance Gigabit Ethernet switches designed for delivering Gigabit connectivity to the desktop. It provides 5/8 full-duplex 1000BASE-T ports that significantly improve network performance and boost throughput for high-bandwidth applications. With 10/16 Gigabits of aggregate bandwidth, this switch provides the quickest solution to meeting the growing demands on your network's limited resources. F
ページ19に含まれる内容の要旨
EZ Switch 10/100/1000 Front Panel LEDs The front panel of the switch provides status LEDs for “at-a-glance” system monitoring. The following table details the functions of the various indicators. Port and System Status LEDs LED Condition Status Power On Power on, normal operation. Off Power off or failure. Link/Act On(Green) Network device is correctly connected to the switch through this port. Off No link. Flashing Data is being sent or (Green) received through this port. 1000M On(Green) C
ページ20に含まれる内容の要旨
EZ Switch 10/100/1000 SMCGS8 Front and Rear Panels Rear Panel The DC power socket is located on the rear panel of the switch. 3
