ページ1に含まれる内容の要旨
Quick Installation Guide
EtherFast 10/100M Switch
Model No.: SP616EB
http://www.micronet.info
ページ2に含まれる内容の要旨
Introduction Micronet SP616EB 10/100M Switch provides powerful, high-performance Ethernet switch, with all 16 ports capable of 10M and 100M auto-negotiation operation. With its intelligent addressing engine, it provides users with a wire-speed filtering and forwarding of the traffic. All ports support auto-uplink detection, so users don't have to worry about the cable type. Each port will automatically communicate for best speed and to run in half- or full-duplex mode. Store-and-forward
ページ3に含まれる内容の要旨
Features Compliant with IEEE802.3 10Base-T, IEEE802.3u 100Base-TX and IEEE802.3x flow control Supports speed (10/100Mbps) and duplex mode(Half/Full) and auto-detection Supports MDI/MDI-X auto crossover Supports full and half duplex operation on all ports Supports back-pressure (Half/Full) and flow control (IEEE 802.3x) Supports extensive LED indicators for network diagnostics Wire-speed packet filtering and forwarding rate Store-and-forward architecture filters fragment & CRC e
ページ4に含まれる内容の要旨
Physical Description SP616EB front view Please refer to the following table for LED definition. LED Status Operation POWER On Power is on. Off Power is off. On/Green Connection established. LNK/ACT Blink/Green Transmitting or receiving data. Off No link. 3
ページ5に含まれる内容の要旨
Installation Installation is easy-- simply connect the cables and the power cord. The system is ready, and you can use all the features. Connect each station to the switch by twisted-pair cable. Plug one of the RJ-45 connectors into a RJ-45 port of the switch, and plug the other RJ-45 connector into the station’s network adapter. Power on the switch and then the system is ready. All ports could be used to connect with another switch. As all the ports support auto-uplink (MDI / MDI-
ページ6に含まれる内容の要旨
Specifications IEEE802.3, IEEE802.3u, IEEE802.3x, Standard compliant Interface 16 * 10/100M RJ-45 ports 10BASE-T: Cat. 3, 4, 5 UTP/STP Cable Connections 100BASE-TX: Cat. 5 UTP/STP MAC address 8K Buffer Memory 160K Byte for the whole system Network speed:10Mbps and 100Mpbs NWay Protocol Duplex mode: Full and Half Uplink Auto Uplink (Auto MDI / MDI-X) Filtering/Forwarding 10Mbps: 14,880pps/14,880pps Rate 100Mbps: 148,800pps/148,800pps Emission FCC Class A, CE o o o o Operatin
ページ7に含まれる内容の要旨
CE Mark Warning This equipment complies with the requirements relating to electromagnetic compatibility, the essential protection requirement of Council Directive 89/336/EEC on the approximation of the laws of the Member States relating to electromagnetic compatibility. Company has an on-going policy of upgrading its products and it may be possible that information in this document is not up-to-date. Please check with your local distributors for the latest information. No part of this
