ページ1に含まれる内容の要旨
Table of Content
■ Introduction
Overview……………...……………………………....1
Features………………….………………………..….2
■ Installations
LevelOne Palm-Sized
Console Connection……………….………………...3
Computers Connection……………….……….….…5
Initial Power-up……………….………………..…….6
KVM Switch
■ Operations
Front Panel operation…………...…………...…..….7
Hot-key commands…...…………...……………..….7
■ Appendices
Specifications………………..……………………...10
KVM-0205 KVM-0405
Troubleshooting..………………..……….…………11
Please
ページ2に含まれる内容の要旨
----------------- Introduction Features !Unique loose-free cables included preventing Overview keyboard or mouse connector from getting loose. !Supports PS/2 keyboard and mouse. The LevelOne Palm-Sized KVM, KVM-0205 and !Keyboard and mouse emulation for error-free PC boot KVM-0405 are computer switches that allows access to up. two or four IBM compatible computers respectively from !Keyboard and mouse hot pluggable at any time one PS/2 keyboard, mouse and monitor. Switching withou
ページ3に含まれる内容の要旨
-----------------Installation The figure 2 shows 4-port LevelOne Palm-Sized KVM console connection. Console Connection Turn your computers off. Connect a PS/2 keyboard to the mini-DIN-6 port marked with “Keyboard” and a PS/2 mouse to the mini-DIN-6 port marked with “Mouse”. Then connect your VGA monitor cable directly to the HDB-15 port as shown in figure 1. Figure 2: LevelOne KVM-0405 Console Connection The multi-sync monitor must be capable of synchronizing wit
ページ4に含まれる内容の要旨
Computers Connection Initial Power-up LevelOne Palm-Sized KVM comes with complete cable Make sure all computers and the LevelOne sets facilitating computer connection. One side of the Palm-Sized KVM are powered down during cable has an HDB-15 connector and the other side has installation. You may power up the computers after three connectors (one HDB-15 and two mini-DIN6s). installation,. The LevelOne Palm-Sized KVM can be The PC 1 ~ PC 4 marks on the LevelOne Palm-Sized powered from
ページ5に含まれる内容の要旨
----------------- Operations Selects the computer at PC 4 (for KVM-0405 only). Front Panel operation NOTE: Do not use the keypad at the right side of You may switch to a different computer by pressing the the keyboard for hot key commands. front panel push-button directly or by issuing hot-key commands. The front-panel LED illuminates indicating !To start Auto Scan, automatically scans all the active port. The LED flashes while in either Auto ports one by one at a fixed interval: S
ページ6に含まれる内容の要旨
NOTE: Scan Rate is set to default of 3 seconds ----------------- Appendices after LevelOne Palm-Sized KVM loses power, i.e., all connected computers are turned off. Specifications ! To adjust keyboard typematic rate Specification KVM-0205 KVM-0405 (characters/sec), this setting over-rides that of Console port number 1 BIOS and any operating system: Computer port number 2 4 left Ctrl + left Ctrl + F4 Port selection push button 1 There are four options: 10, 15, 20 and 30 Hot p
ページ7に含まれる内容の要旨
Troubleshooting Ensure that all cables are well seated. Check Package Contents: that keyboard/mouse cables are not swapped. Label the cables for each computer to avoid ▓ The complete KVM-0205 contains: confusion when connected to the device. Symptom Causes Solutions KVM-0205(2-port KVM) x 1 Keyboard or Improper power-up Press and hold down the Custom cable set 1.8M(6ft) x 2 mouse does not sequence. push button for 3 User’s manual x 1 work Keyboard or seconds, the Leve
