Hearth and Home Technologies WSK200の取扱説明書

ページ1に含まれる内容の要旨

WSK100, WSK200 and WSK210 Wall Switches
- Installation and Operating Instructions -
WARNING
CAUTION
Inspect components for damage. Damaged
DO NOT DISCARD THIS MANUAL
parts may impair safe operation.
• Important installation and operation instruc-
• Do NOT install damaged components.
tions included.
• Do NOT install incomplete components.
• Do NOT install substitute components.
• Read, understand and follow these
Report damaged parts to dealer.
instructions for safe installation and
operation.

ページ2に含まれる内容の要旨

1.3 Installing the Control Box 1.0 INSTALLATION INSTRUCTIONS 1.1 Determine Location WARNING Determine the location for the wall switch. The selected Burn Risk. location should be in the same space as the gas fi replace. Shock Risk. Never place this unit in a separate room. The distance from Do not install the control box when fi re- • the fi replace to the switch may be up to 50 ft. place is hot. Do not plug control box in until all con- • The switch should be mounted into a UL-listed ele

ページ3に含まれる内容の要旨

PILOT IPI MODULE BATTERY PACK ON/OFF SWITCH BRN BRN NOT USED NOT USED ORG DEXEN IPI VALVE (7) 12" WIRES BUNDLED MINIMUM GRN BLK JUMPER GRN YEL SEE DETAIL RED A - A FOR HIGH LIMIT SWITCH GRN WSK210 DETAIL BLK BLU WALL SWITCH BLK JUMPER DETAIL B-B FOR B-VENT APPLIANCES GROUND WSK-100/200 CONTROL BOX J-BOX (110V) DELAY CIRCUIT BATTERY WSK210 PACK ONLY DETAIL A - A Figure 3. IPI wiring diagram with WSK100, WSK200 and WSK210 Wall Switch 3 BLK RED BRN GRN ORG BLK BLK RED BRN BRN WHT GRN ORG ORG BLK B

ページ4に含まれる内容の要旨

2.0 OPERATION INSTRUCTIONS NOTE: If the fi replace has an ON/OFF rocker switch (located near the gas valve), the switch may either be disconnected or turned to the OFF position. Rocker switch is not required for operation of this control. 2.1 Wall switch button operation On/Off Button • Button Press: Turns fi replace ON • Button Press: Turns fi replace OFF During severe cold weather, homeowners may fi nd that activating the pilot assists in lighting the fi replace. Use the pilot button to s