Extron electronic sSM 26の取扱説明書

ページ1に含まれる内容の要旨

Product Category
SM 26 • Setup Guide
NOTE: Unless otherwise stated, mounting hardware is not included.
®
This setup guide contains installation information about the Extron SpeedMount SM 26 speaker.
NOTE: Installation and service must be performed by authorized personnel only.
Installing the Speaker Mounting Plate
The SM 26 speaker comes with a flat mounting plate and an adapter for positioning the speaker 10° up, down, left, or right.
• 0° mounting plate — The flat (0°) mounting plate allows

ページ2に含まれる内容の要旨

LOOP IN IN LOOP LOOP IN IN LOOP SM 26 • Setup Guide (Continued) NOTE: A speaker wire access hole (see the following figures) must also be cut in the wall. Mark that hole location now with the mounting plate positioned on the wall while ensuring that the wall stud does not interfere with the wire routing and that the mounting plate hides the access hole. 3. Drill the mounting plate pilot holes and cut the speaker wire access hole, as previously marked. 4. Install the speaker cables into the w

ページ3に含まれる内容の要旨

Product Category 33-0000-01 Rev. Ax1 + + – – LOOP IN IN LOOP NOTE: If surface mounting, route the wires through alternate access points as shown at right. 10° Mounting Adapter 0° Mounting Plate Alternate Access Point Alternate Access Points 0.27” (7 mm) Good ATTENTION: Use the appropriate mounting screws. The screw heads must not protrude more than 0.27 inch (7 mm) above the screw holes in the mounting plate (see the figure on the right). If the screw head protru

ページ4に含まれる内容の要旨

Setting the Tap Selector Switch (SM 26T Model Only) For the SM 26T model, insert a small screwdriver through the upper left portion of the front grille, as shown below, to adjust the tap selector switch to the desired setting. Tap Indicator 8Ω for 70 Volt 70 100 8Ω Unlocked Tap Indicator for 100 Volt Unlocked Locked Twist to Lock/Unlock Using the Security Key to Lock and Unlock the Speaker Insert the key into the center of the speaker grille and turn t