ページ1に含まれる内容の要旨
MLS 608 D Series • Setup Guide
™
The Extron MLS 608 D Series are eight input, multi-format AV switchers with ProDSP audio
and are able to integrate analog and digital sources. There are three models:
• MLS 608 D (with variable preamp output - no amplifier)
• MLS 608 D MA (with 40 watt 70 volt mono power amplifier)
• MLS 608 D SA (with 2 x 20 watt stereo power amplifier)
This guide allows you to easily and quickly setup and configure your MLS 608 D using step by step instructions. It covers pe
ページ2に含まれる内容の要旨
MLS 608 D Series • Setup Guide (Continued) Twisted Pair (TP) Cable Transmission Distance CAUTION: Do not connect the MTP cable to any LAN port, telecommunications network, or digital video output port. Likewise, do not connect a LAN cable to any MTP or digital video output port. There are different maximum distances for analog and digital signals. Analog signals — The maximum distance is determined by the frequency and resolution of the signal that is input to the MLS 608 D. The table below ™
ページ3に含まれる内容の要旨
NC NC LR AUDIO LR AUDIO L R LR Installation and Cabling Step 1 — Mount the Switcher 2U Rack Mount Bracket (use four Turn off or disconnect all equipment power sources and rack mount lower holes) the MLS 608 D using the two supplied brackets (see image at right). Step 2 — Connect MLS 608 D Inputs Video — Connect inputs from video sources to the applicable connectors marked “Inputs” (see b, d, and g on page 1 for connector types). b Inputs 1-3 — RGB (RGBHV, RGBs, or RGsB), component (bi- o
ページ4に含まれる内容の要旨
MONO AUDIO MONO AUDIO L R L R Tx Rx MLS 608 D Series • Setup Guide (Continued) Step 4 — Connect Outputs from MTP/HDMI U R Digital video — Connect a display to the HDMI Composite Video – RS-232 Control (Analog Side) – Component Video – Connect to this BNC. NOT USED IN THE MLS 608 D SYSTEM. Connect to these 3 BNCs. connector for digital video output. Analog video — Connect the analog outputs as RS-232 Mono output 1 NO GROUND. shown at right. Sleeve(s) Mono output 2 R-Y B-Y Tx Rx SPARE Y NO GROUN
ページ5に含まれる内容の要旨
Optimizing Video ANALOG SIGNAL RGB VID LEVEL PEAKING DIGITAL SIGNAL AUDIO Y/C RS-232 YUV Setting the Peaking and Level on the MTP/HDMI U R RGB MTP/HDMI U R Image sharpness is adjusted with the front panel Peaking adjustment knob. This applies only to the analog side of the device. Increased peaking compensates for mid- and high-frequency detail loss. Minimum setting (full counterclockwise) is zero peaking. Image brightness is adjusted using the Level adjustment knob. NOTE: To avoid possible
ページ6に含まれる内容の要旨
MLS 608 D Series • Setup Guide (Continued) Front Panel Features All models have the following front panel features: SOURCE SELECTION VOLUME MIC VOLUME DOC AUX PC LAPTOP Blu-ray CAM VID R CONFIG 12345678 MLS 608 D ™ AV Switcher with ProDSP 4 5 6 1 2 3 a Power/reset status LED d Input selection buttons (8) b Reset button (recessed) e Program volume control (adjustment knob) c USB configuration port f Mic volume control (adjustment knob) Front Panel Operation NOTE: For operation details for all mo
ページ7に含まれる内容の要旨
™ Using the DSP Configurator Software The MLS can be configured using the DSP Configurator software from the supplied DVD or downloaded from www.extron.com. To upload from the DVD: Place the disc in the DVD drive and install the program onto a local PC that is connected to the MLS 608 D. To download from the Extron website: 1. At the home page, click the Download tab and click Software (at left side of page). 2. Navigate to the DSP Configurator file and click Download. 3. Log in with your
ページ8に含まれる内容の要旨
MLS 608 D Series • Setup Guide (Continued) Typical Application for MLS 608 D Series, Showing the MLS 608 D SA Microphones Extron MLC 226 IP DV+ Extron Enhanced MediaLink MTP T 15HD A D TCP/IP Transmitter Controller w/ IP Link Network Projector Ethernet Control Switcher Ethernet Control ® GlobalViewer A/V Resource Laptop Management and Remote Control Application Screen Control Digital Video + Extron RS-232 SI 26 Surface Mount Speakers Extron Extron MLS 608 D SA MTP + Audio MTP/HDMI U R Medi
