Extron electronic sMLC 64 RS VC Dの取扱説明書

ページ1に含まれる内容の要旨

Product Category
MLC 60 Series • Setup Guide
for the MLC 62 RS D, MLC 62 IR D, and MLC 64 RS VC D
The MLC 60 D Series are keypad controllers for use
in classrooms and meeting facilities. They mount
®
DISPLAY DISPLAY DISPLAY
to Decora -style wallplates and therefore may be
ON ON
OFF OFF ON OFFFF
referred to as “D” models. The controllers have
VOLUME VOLUME VVOLUME OLUME
PC
backlit soft touch buttons and can control common
LAPTOP
AV functions, including power, input switching,
PC
PC VIDEO
V

ページ2に含まれる内容の要旨

MLC 60 Decora Series • Setup Guide (Continued) Use Allen Wrench 2. Change the faceplate, buttons, and volume control knob as to Loosen Screw needed. Turn Knob to Expose Screw a. (MLC 64 RS VC D only) If changing the faceplate on the MLC 64 volume control module, first remove the volume knob: 1. Rotate the knob until the dot on the knob is aligned with the bottom edge of the volume icon on the faceplate. The notches in the edge of the knob and the notch in the edge of the hole in the facepla

ページ3に含まれる内容の要旨

Product Category z Port B IR/S (RS models) or Port A IR (IR models): Connect a display device, switcher, or up to two IR emitters to this port. On RS models, you can configure Port B IR/S for either serial or IR communication, using the MLC 60 Series configuration program. On IR-only models, Port A IR supports only an IR connection. Ground ( ) IR Signal IR Emitter 50' (15 m) MLC RS D Rear Panel z Relays port (RS models only): The Relays port provides connections for two relays. Connect one

ページ4に含まれる内容の要旨

GROUND Rx Tx GROUND 1 4. Connect and apply power. Connect the included power supply to the MLC as shown below, then connect power to COMMON all devices in the system. 2 1 GROUND 3/16” Tx/IR (5 mm) Max. GROUND Tx Ridges GROUND Ground +12 VDC 12 VDC input Smooth SECTION A–A Power Supply Output Cord Ground all devices. MLC RS D Rear Panel 5. Configure the MLC buttons and ports (see the MLC 60 Series Configuration USB Configuration Program Help File for the procedures): Port a. Load and install