ページ1に含まれる内容の要旨
User Guide
Matrix Switchers
CrossPoint 450 Plus Series
CrossPoint Ultra Series
MAV Plus Series
Matrix Switchers
68-521-20 Rev. D
01 14
ページ2に含まれる内容の要旨
Safety Instructions Safety Instructions • English Инструкция по технике безопасности • Русский WARNING: This symbol, , when used on the product, is intended to ПРЕДУПРЕЖДЕНИЕ: Данный символ, , если указан alert the user of the presence of uninsulated dangerous voltage within the на продукте, предупреждает пользователя о наличии product’s enclosure that may present a risk of electric shock. неизолированного опасного напряжения внутри корпуса продукта, которое может привести к поражению электр
ページ3に含まれる内容の要旨
FCC Class A Notice This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. The Class A limits provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Ope
ページ4に含まれる内容の要旨
Conventions Used in this Guide Notifications The following notifications are used: WARNING: A warning indicates a situation that has the potential to result in death or severe injury. ATTENTION: Attention indicates a situation that may damage or destroy the product or associated equipment. NOTE: A note draws attention to important information. TIP: A tip provides a suggestion to make working with the application easier. Software Commands Commands are written in the fonts shown here: ^AR Mer
ページ5に含まれる内容の要旨
Contents Setting RGB delay (CrossPoint switchers) .... 55 Introduction ............................................ 1 Using Presets.............................................. 57 About this Guide ............................................. 1 Muting and Unmuting Video and Audio About the Crosspoint and MAV Outputs .................................................... 60 Matrix Switchers ............................................. 1 Viewing and Adjusting the Input CrossPoint Ultra Switcher
ページ6に含まれる内容の要旨
Programming Guide ..............................89 HTML Operation ................................... 131 Serial Ports ..................................................... 90 Download the Startup Page ......................... 132 Rear Panel RS-232/RS-422 Port .................. 90 Status Tab .................................................... 133 Front Panel Configuration Port ................... 90 System Status Page .................................. 133 Ethernet (LAN) Port ................
ページ7に含まれる内容の要旨
Introduction • About this Guide • About the CrossPoint and MAV Matrix Switchers • Definitions • Features About this Guide This guide contains installation, configuration, and operating information for the complete Extron family of full-function, medium- and large-sized, analog video matrix switchers, specifically: • CrossPoint 450 Plus large (matrix sizes from 24 inputs by 12 outputs to up to 32 inputs by 32 outputs) ultra-wideband RGBHV and audio matrix switchers • CrossPoint Ultra small (ma
ページ8に含まれる内容の要旨
Class Room 101 Class Room 102 Class Room 103 Class Room 104 Class Room 105 Class Room 106 LAN Extron Ethernet CrossPoint Ultra 128 HVA Matrix Switcher Extron DVS 304 Scaler Extron VSC 700 Scan Converter VCR DVD Extron DVS 304 Scaler Extron Extron Extron Extron Extron RGB 109xi RGB 109xi RGB 109xi RGB 109xi RGB 109xi Interface Interface Interface Interface Interface Cable Box Extron DVS 304 Scaler Student Internet Instructor Student Student DVD Computer Connection Computer Computer Computer F
ページ9に含まれる内容の要旨
MAV Plus series switchers offer multiple models of all matrix sizes, with one, two, or three (MAV Plus 1616 and smaller) video planes, to support different low resolution video formats (exceptions are noted in MAV Plus Switchers on page 6): • HDA for switching component/HDTV video and two-channel stereo audio • HD for switching component/HDTV video signals only • SVA for switching S-video and two-channel stereo audio • SV for switching S-video signals only • AV for switching composite video an
ページ10に含まれる内容の要旨
The matrix switchers are housed in rack-mountable, metal enclosures with 19” rack ears. The amount of vertical rack space required for each switcher is as follows: • 2U high enclosure • MAV Plus 84, 88, 124, and 128 HDA, HD, SVA, and SV switchers • MAV Plus 84, 88, 124, 128, 816, 164 (audio only), 168, 1212, and 1616 AV, AV RCA, V, and A switchers • 3U high enclosure • CrossPoint 84, 88, and 128 HV and HVA switchers • MAV Plus 168, 1212, and 1616 SVA and SV switchers • MAV Plus 328 and 248 A s
ページ11に含まれる内容の要旨
Each model has an internal 100 VAC to 240 VAC, 50/60 Hz, switching power supply that provides worldwide power compatibility. The CrossPoint 450 Plus 2412, 2424, 3216, and 3232 and MAV Plus 2412, 2424, 3216, and 3232 each have two, primary and redundant, power supplies. The power ratings of the power supplies for the various switchers are as follows: • 20 watts • MAV Plus 128 AV RCA • MAV Plus 88 and 128 • 30 watts • CrossPoint 84, 88, and 128 • MAV Plus 816, 168, 1212, and 1616 • MAV Plus 16
ページ12に含まれる内容の要旨
CrossPoint 450 Plus Switchers There are four CrossPoint 450 Plus series matrix sizes available, each in an HVA (RGBHV video and audio) and HV (RGBHV video only) model: • CrossPoint 450 Plus 2412 (24 inputs by 12 outputs) • CrossPoint 450 Plus 2424 (24 inputs by 24 outputs) • CrossPoint 450 Plus 3216 (32 inputs by 16 outputs) • CrossPoint 450 Plus 3232 (32 inputs by 32 outputs) The CrossPoint 450 Plus Series switchers have a minimum bandwidth of 450 MHz (-3 dB). All models can also switch RGBS,
ページ13に含まれる内容の要旨
• MAV 1616 Plus (16 inputs by 16 outputs) • HDA • HD • SVA • SV • AV • V • A • MAV 248 Plus (24 inputs by 8 outputs) • A • MAV 2412 Plus (24 inputs by 12 outputs) • SVA • SV • AV • V • A • MAV 2424 Plus (24 inputs by 24 outputs) • SVA • SV • AV • V • A • MAV 328 Plus (32 inputs by 8 outputs) • A • MAV 3216 Plus (32 inputs by 16 outputs) • SVA • SV • AV • V • A • MAV 3232 Plus (32 inputs by 32 outputs) • SVA • SV • AV • V • A MAV Plus HDA and HD switchers can also route low resolution RGsB and Rs
ページ14に含まれる内容の要旨
Definitions The following terms, which apply to Extron matrix switchers, are used throughout this guide: Tie — An input-to-output connection. Set of ties — An input tied to two or more outputs. (An output can never be tied to more than one input.) Configuration — One or more ties or one or more sets of ties. Current configuration — The configuration that is currently active in the switcher (also called configuration 0) Global memory preset — A configuration that has been stored. Up to 32 globa
ページ15に含まれる内容の要旨
Audio output volume (audio models) — The audio volume of each output can be displayed and adjusted through a range of full output to completely silent from the front panel or under serial port or Ethernet control. Digital Sync Validation Processing (DSVP) (CrossPoint) — In critical environments or unmanned, remote locations, it may be vital to know that sources are active and switching. The Extron DSVP confirms that input sources are active by scanning all sync inputs for active signals. DS
ページ16に含まれる内容の要旨
Switching flexibility — Provides individually buffered, independent matrix switched outputs with audio follow and audio breakaway for audio models. • Tie any input to any or all outputs • Quick multiple tie — Multiple inputs can be switched to multiple outputs simultaneously. This allows all displays (outputs) to change from source to source at the same time. • Audio follow — Audio can be switched with its corresponding video input via front panel control or under Ethernet or serial port rem
ページ17に含まれる内容の要旨
Three front panel security lockout modes (Executive modes) — If a matrix switcher is installed in an open area, where operation by unauthorized personnel may be a problem, either of two security lockout modes can be implemented (the third mode is unlocked). When a front panel locked mode is enabled, a special button combination or SIS command is required to unlock the front panel controller and make the front panel fully operational. I/O grouping — Allows the matrix to be virtually divided i
ページ18に含まれる内容の要旨
Installation This sections details the installation and configuration of the CrossPoint Matrix Switchers and MAV Plus Matrix Switchers, including: • Setup and Installation Checklist • Rear Panel Views • Rear Panel Connections • Front Panel Configuration Port Setup and Installation Checklist Get ready c Familiarize yourself with the matrix switcher. c Obtain IP setting information for the matrix switcher from the local network administrator (see Ethernet Connection on page 149). Installation th
ページ19に含まれる内容の要旨
Rear Panel Views All connectors for all switchers are on the rear panel. Figure 4 through figure 14, on the following pages, show a representative sampling of all of the matrix switchers described in this guide. See Rear Panel Connections, on page 19, for connecting cables to the rear panel connectors. ATTENTION: • Use electrostatic discharge (ESD) precautions (be electrically grounded) when making connections. Electrostatic discharge can damage equipment, even if you cannot feel, see, or h
ページ20に含まれる内容の要旨
CrossPoint 450 Plus Switchers Figure 4 shows the CrossPoint 450 Plus 3232 HVA RGB video and stereo audio matrix switcher. NOTE: The CrossPoint 450 Plus 2412, 2424, and 3216 are housed in the same 10U or similar 8U enclosure, but have fewer output connectors to accommodate their smaller matrix sizes. 1 1 2 3 4 1 2 3 4 1 2 3 4 1 2 3 4 1 2 3 4 6 7 8 6 7 8 6 7 8 6 7 8 6 7 8 5 5 5 5 5 9 10 11 12 9 10 11 12 9 10 11 12 9 10 11 12 9 10 11 12 13 14 15 16 13 14 15 16 13 14 15 16 13 14 15 16 13 14 15 16
