ページ1に含まれる内容の要旨
24-Port Fast Ethernet Switch
Quick Installation Guide
M73-APO07-460
ページ2に含まれる内容の要旨
FCC REGULATORY STATEMENTS FCC Certification, Part15, Class A This equipment has been tested and found to comply with the limits for a class A Digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
ページ3に含まれる内容の要旨
INTRODUCTION The 24-Port Fast Ethernet 10/100Mbps N-Way Switch provides you a flexible, reliable, and affordable solution for an Ethernet network. It comes with twenty-four independent 10BASE-T/100BASE-TX ports. Each port delivers up to 200Mbps throughput, and is able to operate in either half or full-duplex modes. The 24-Port Fast Ethernet 10/100Mbps N-Way Switch also possesses a N-Way auto- negotiation function, which automatically adjusts the device for optimum operation. “Store-and-Fo
ページ4に含まれる内容の要旨
PARTS NAMES AND FUNCTIONS Front Panel: LED Indicators Status LED Color Solid Flashing Becomes solid green when power is Power Green N/A turned on. Sending or Receiving LINK/ACT Green Successful connection packets Rear Panel: Power Port - 2 -
ページ5に含まれる内容の要旨
HARDWARE INSTALLATION The switch is considered as a “plug and play” network device and requires no special setup procedures. Connect the power cord and cables correctly and you are ready to go. Switch installation 1. Put the switch on the appropriate location. When you install the switch, there are two things needed to be considered: Location: Your switch should be located in a place that is central to your home/office space and allows all computers and networked devices connected to
ページ6に含まれる内容の要旨
SPECIFICATION IEEE 802.3 10Base-T Ethernet Standards IEEE 802.3u 100Base-TX Fast Ethernet IEEE802.3x Flow Control Protocol CSMA/CD Twenty four 10/100Mbps RJ-45 Ports (support Ports Auto-MDI/MDIX) Switching Scheme Store-and-Forward Full Duplex: IEEE802.3x Flow control Half Duplex: Back Pressure UTP Category 3 or better (10Base-T) Cabling type UTP Category 5 or better (100Base-TX) 8K MAC Address Power Green LED indicators Link/Act Green: on for successful conn
