ページ1に含まれる内容の要旨
GLX60.4 / GLX100.4
GLX1000.1D / GLX1400.1D
GLX1800.1D / GLX2200.1D
ページ2に含まれる内容の要旨
HIFONICS GLADIATOR HIGH PERFORMANCE AMPLIFIERS The Gladiator Series products have been designed to a very high level of performance, with features unavailable in any other product. All of the amplifiers have variable crossovers built in, with added touches such as subsonic filter, bass equalization and an HFR-3 remote control module for the monoblocks that allows overall Level control from reach of the drivers seat. To insure years of listening pleasure, all amplifiers have a built in diagnos
ページ3に含まれる内容の要旨
WIRE GAUGE GENERAL INSTALLATION PROCEDURE System Design The success of any car stereo system relies on several factors, such as the system design, execution of the installation, and system setup. Please remember that any system is only as good as its weakest link. Please remember that higher power systems are not necessarily useful purely for high sound pressure levels, but also to establish a headroom capability, to reproduce musical peaks cleanly without distortion. Lower power amplifiers w
ページ4に含まれる内容の要旨
AMPLIFIER FEATURE DESCRIPTIONS GLADIATOR AMPLIFIERS: Each model is capable of 4 & 2-Ohms stereo per channel, or 4-Ohms mono bridged operation except A POWER LED indicates the powered up and turned on condition. the mono amps which are capable of 4, 2 and 1-Ohm loads. All Hifonics amplifiers feature a comprehensive diagnostic system, with speaker lead short circuit, Tri-Mode operation with any stereo pair of amplifier channels is possible, as with all bridgeable and amplifier DC faults ind
ページ5に含まれる内容の要旨
1/2 CH LINE INPUT REMOTE HI PASS LOW PASS BASS EQ LEVEL POWER LINE OUT 1/2 CH LINE INPUT REMOTE HI PASS LOW PASS BASS EQ LEVEL POWER LINE OUT CH1/2 CH3/4 X-OVER CH1/2 CH3/4 X-OVER R R R R R R 10Hz-15KHz 30Hz-150Hz 0dB-10dB 6V 0.2V PROTECT HI FULL LP/BP 10Hz-15KHz 30Hz-150Hz 0dB-10dB 6V 0.2V PROTECT HI FULL LP/BP 3/4 CH HI PASS LOW PASS BASS EQ LEVEL 3/4 CH X-OVER HI PASS LOW PASS BASS EQ LEVEL X-OVER L L L L L L CH2-CH4 CH2-CH4 10Hz-15KHz HI FULL LP/BP 30Hz-150Hz 0dB-10dB 6V 0.2V MODE 1
ページ6に含まれる内容の要旨
1/2 CH LINE INPUT REMOTE HI PASS LOW PASS BASS EQ LEVEL POWER LINE OUT CH1/2 CH3/4 X-OVER R R R 10Hz-15KHz 30Hz-150Hz 0dB-10dB 6V 0.2V PROTECT HI FULL LP/BP 3/4 CH HI PASS LOW PASS BASS EQ LEVEL X-OVER L L L CH2-CH4 10Hz-15KHz HI FULL LP/BP 30Hz-150Hz 0dB-10dB 6V 0.2V MODE BALANCED SUB INPUT OUTPUT INPUT LEVEL PHASE REMOTE BASS EQ SONIC LOW PASS POWER L L PROTECT 9V 0.2V 0 180 0dB
ページ7に含まれる内容の要旨
BALANCED SUB BALANCED SUB INPUT OUTPUT INPUT LEVEL PHASE REMOTE BASS EQ SONIC LOW PASS INPUT OUTPUT INPUT LEVEL PHASE REMOTE BASS EQ SONIC LOW PASS POWER POWER L L L L PROTECT PROTECT 9V 0.2V 0 180 0dB 10dB 15Hz 35Hz 35Hz 250Hz 9V 0.2V 0 180 0dB 10dB 15Hz 35
ページ8に含まれる内容の要旨
BALANCED SUB BALANCED SUB INPUT OUTPUT INPUT LEVEL PHASE REMOTE BASS EQ SONIC LOW PASS INPUT OUTPUT INPUT LEVEL PHASE REMOTE BASS EQ SONIC LOW PASS POWER POWER L L L L PROTECT PROTECT 9V 0.2V 0 180 0dB 10dB 15Hz 35Hz 35Hz 250Hz 9V 0.2V 0 180 0dB 10dB 15Hz 35
ページ9に含まれる内容の要旨
12 GAUGE JUMPER WIRE POWER POWER BALANCED SUB BALANCED SUB PROTECT PROTECT INPUT OUTPUT INPUT LEVEL PHASE REMOTE BASS EQ SONIC LOW PASS IN INPUT OUTPUT INPUT LEVEL PHASE REMOTE BASS EQ SONIC LOW PASS IN L L L L 9V 0.2V 0 180 0dB 10dB 15Hz 35Hz 35Hz 250Hz 9V 0.2V 0 180 0dB 10dB 15Hz 35Hz 35Hz 250Hz OUTPUT OUTPUT M
ページ10に含まれる内容の要旨
SETTING UP SYSTEMS AFTER INSTALLATION FOR BEST PERFORMANCE GLX60.4 / GLX100.4 General: At this point you are ready to get more specific on the settings for your amplifier. High Pass: -When in Hi Pass operation, this setting acts as a low frequency cut off for your system reproduction. The point that you set it at cuts off any frequencies from reproduction beyond this point. The 12 o’clock position is a great starting point. EXAMPLE: If you adjust the High Pass to 100Hz, the amplifier will not p
ページ11に含まれる内容の要旨
TROUBLESHOOTING A SYSTEM The key to finding the problem in a misbehaving sound system is to isolate parts of that system in a logical fashion to track down the fault. Description of the Diagnostic system built into all HIFONICS amplifiers The diagnostic system will shut down the amplifier, until reset by turning the head unit off, and back on. This state of affairs will be indicated by the front panel PROTECT LED lighting up under the following conditions: 1 - A sort circuit on the loudspeaker
ページ12に含まれる内容の要旨
10
ページ13に含まれる内容の要旨
GLADIATOR Maxxsonics Limited Warranty As the manufacturer of Maxxsonics, MB Quart, Autotek, Crunch and Hifonics car audio products, Maxxsonics USA Inc. Warrants to the original consumer purchaser the amplifier to be free from defects in material and workmanship for one (1) Year from date of purchase. All other parts and accessories of the system are warrantied to be free from defects in material and workmanship for one (1) year from date of purchase. Maxxsonics will repair or replace at it’s
ページ14に含まれる内容の要旨
Accessories 5V ON SLAVE 3V 7V OFF MASTER 35Hz 250Hz 1V 9V 15Hz 35Hz MODE LOW PASS RED - CLIP OUTPUT TEST TONE SUBSONIC GREEN - 9V 65Hz FILTER LEVEL FILTER 24 dB/OCT 24 dB/OCT MAXX-LINK MLX-100 9V 0.2V 0 180 0dB +10 dB 30Hz 100Hz INPUT PHASE BOOST BANDWIDTH FREQUENCY LEVEL PARAMETRIC BASS EQ -6dB BYPASS RED - CLIP GREEN - 9V -20dB 0dB NORMAL LEVEL 12
ページ15に含まれる内容の要旨
OEM Integration Accessories MX-1 Premium High To Low Level Converter MX-3 Bass Controller * Converts High Level OEM speaker wires to Ultra Clean RCA Low Level Outputs * High Level Inputs: Accepts all types of High level Inputs * Parametric Bass EQ: Provides a wide array of subwoofer output signal including floating ground and high voltages up to 30 volts. shaping controls to enhance bass response and sound quality including * Audio Signal Sense / Hardwire Turn-On: Audio sense detec
ページ16に含まれる内容の要旨
PART#: A1011
