ページ1に含まれる内容の要旨
P/N
REV S/N
ADC
MADE IN USA DATE CODE
ADCP-50-304
Issue 19
June 1999
RS-232/V.24, X.21
and V.35 PatchSwitch
User Manual
1586-A
1587-A
1059311 Rev A
A
COMP
B
RST
RST
RST
RST
COMP
RST
RST
RST
RST
RST
RST
RST
RST
RST
ALM
ALM
MASTER
RST
ALM
RST
ALM
RST
ALM
ALM
ALM
ALM
ALM
TD
RD
DCD
SQ
RTS
CTS
DSR
DTR
ALM
TD
RD
DCD
SQ
RTS
CTS
DSR
DTR
TD
RD
DCD
SQ
RTS
CTS
DSR
DTR
ALM
ALM
TD
RD
DCD
SQ
RTS
CTS
DSR
DTR
ALM
ALM
TD
TD
RD
RD
DCD
DCD
SQ
SQ
RTS RTS
CTS CTS
DSR DSR
DTR
DTR
ALM
TD
RD
DCD
SQ
RTS
CTS
DSR
DTR
ALM
ページ2に含まれる内容の要旨
ADCP-50-304 • Issue 19 • June 1999 • Preface COPYRIGHT © 1999, ADC Telecommunications, Inc. All Rights Reserved Printed in the U.S.A. TRADEMARK INFORMATION ADC and ADC Telecommunications are registered trademarks of ADC Telecommunications, Inc. DISCLAIMER OF LIABILITY Contents herein are current as of the date of publication. ADC reserves the right to change the contents without prior notice. In no event shall ADC be liable for any damages resulting from loss of data, loss of use, or loss of pro
ページ3に含まれる内容の要旨
ADCP-50-304 • Issue 19 • June 1999 • Preface TABLE OF CONTENTS Content Page SECTION 1 INTRODUCTION 1 GENERAL. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 2 PURPOSE AND SCOPE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-2
ページ4に含まれる内容の要旨
ADCP-50-304 • Issue 19 • June 1999 • Preface TABLE OF CONTENTS Content Page SECTION 4 PATCHSWITCH X.21 1 GENERAL. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-1 2 DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ページ5に含まれる内容の要旨
ADCP-50-304 • Issue 19 • June 1999 • Preface TABLE OF CONTENTS Content Page SECTION 6 INSTALLATION 1 GENERAL. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-1 1.1 PatchSwitch Chassis Installation (For PatchSwitch V.35 Installation, see Section 3) . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-1 1.2 PatchSwitch Module Installation Procedure .
ページ6に含まれる内容の要旨
ADCP-50-304 • Issue 19 • June 1999 • Preface TABLE OF CONTENTS Content Page 6.15 Request Software Revision Level (REV) Command) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-10 6.16 Request Status (UPdate Command). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-10 6.17 Status Responses . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ページ7に含まれる内容の要旨
ADCP-50-304 • Issue 19 • June 1999 • Preface REVISION HISTORY EDITION/ISSUE DATE REASON FOR CHANGE 1st Edition, Issue 1 02/83 Original. 1st Edition, Issue 2 03/83 Technical changes. 1st Edition, Issue 3 03/83 Warranty changes. 1st Edition, Issue 4 07/83 Technical changes. 2nd Edition, Issue 1 02/84 Incorporation of remote control. 2nd Edition, Issue 2 10/84 Technical changes. 3rd Edition, Issue 1 03/86 Incorporated PSM-12 and PSM-13 Test Modules. 3rd Edition, Issue 2 05/86 Edited Communications
ページ8に含まれる内容の要旨
ADCP-50-304 • Issue 19 • June 1999 • Preface RELATED PUBLICATIONS Listed below are all the related manuals, their content, and their publication numbers. Copies of these publications can be ordered by contacting the ADC Technical Assistance Center at 1-800-366-3891 (in U.S.A. or Canada) or 612-946-3000, extension 3223 (outside U.S.A. and Canada. Title ADCP Number Network Control Products Catalog 517 PatchSwitch Remote Control Unit User Manual ADCP-50-302 PatchSwitch V.35 Installation and User G
ページ9に含まれる内容の要旨
ADCP-50-304 • Issue 19 • June 1999 • Preface GENERAL SAFETY PRECAUTIONS Danger: To prevent electrical shock, never install telephone equipment in a wet location or during a lightning storm. When installing or modifying telephone lines, disconnect lines on the network side before working with uninsulated lines or terminals. Danger: The chassis must be properly grounded to ensure equipment and human safety. Danger: Electric modules can be damaged by electrostatic discharge (ESD). Before handling m
ページ10に含まれる内容の要旨
INTRODUCTION
ページ11に含まれる内容の要旨
ADCP-50-304 • Issue 19 • June 1999 • Section 1: Introduction SECTION 1: INTRODUCTION Content Page 1 GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-1 2 PURPOSE AND SCOPE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-2 2.1 PatchSwitch Assembly Configurations . . . . . . . . . . . . . . . . . . .
ページ12に含まれる内容の要旨
ADCP-50-304 • Issue 19 • June 1999 • Section 1: Introduction 12. Remote switching and alarm control operation up to 1,000 feet away from the PatchSwitch chassis rack; 13. Remote operator control via serial data communications circuits employing either RS-232, RS-422 or V.35 standards; 14. Optional autofallback to either A/B switch position on detection of an alarm; 15. Local or remote bank switching using manual or serial control; 16. 0, +5V and –5 to –48 Vdc pulse controlled bank switching, and
ページ13に含まれる内容の要旨
ADCP-50-304 • Issue 19 • June 1999 • Section 1: Introduction The Interlocked group feature protects a device used as a substitute. A spare device may be connected to the DTE-B port of several A/B switching modules as shown in Figure 1-1. The A/B Interlock Jumper of each module in the group must be in the same position. When one device fails, the spare device may be substituted. Now, If another device fails, the interlocked group feature prevents the spare from being substituted for the second fa
ページ14に含まれる内容の要旨
ADCP-50-304 • Issue 19 • June 1999 • Section 1: Introduction MODULE 1 A MODEM 1 B MODULE 2 A MODEM 2 B MODULE 3 A MODEM 3 B MODULE 4 A MODEM 4 B SPARE MODEM FRONT END PROCESSOR 1588-A Figure 1-1. Typical Hot Spare Modem Configuration Page 1-4 © 1999, ADC Telecommunications, Inc.
ページ15に含まれる内容の要旨
ADCP-50-304 • Issue 19 • June 1999 • Section 1: Introduction 2.2 PatchSwitch Equipment The PS equipment consists of a chassis with a control module and associated power supply, modules forpatching and/or switching and interfacing, blank panel and patch cords. Table 1-2 lists the PS equipment. Table 1-2. PatchSwitch Equipment (V.35 Modules are described in Section 3. X.21 Modules are described in Section 4) ADC NUMBER DESCRIPTION COMMENTS RDC-01 PatchSwitch Chassis, Standard rack mounted chassis
ページ16に含まれる内容の要旨
ADCP-50-304 • Issue 19 • June 1999 • Section 1: Introduction Table 1-2. PatchSwitch Equipment, continued (V.35 Modules are described in Section 3. X.21 Modules are described in Section 4) ADC NUMBER DESCRIPTION COMMENTS PSW-000002 PatchSwitch Power Supply Dual output supply used with RDC-01/RDC-02 (9 pin in-line connector) chassis with input power source –48 Vdc. PSW-000003 PatchSwitch Power Supply Dual output supply used with RDC-01/RDC-02 (9 pin in-line connector) chassis with input power s
ページ17に含まれる内容の要旨
ADCP-50-304 • Issue 19 • June 1999 • Section 1: Introduction 2.2.3 Data Converter Module (PSR-06) This module is a printed circuit board assembly with components, a front panel with four LED status indicators and a rear 96-pin DIN connector. The module interfaces with the ADC Remote Control Unit, a user's CRT terminal, or computer, and converts signals providing RS-422/RS- 232 compatibility to permit remote serial control for PatchSwitch equipment to be connected to RS-232 modem or CRTs. 2.2.4 L
ページ18に含まれる内容の要旨
ADCP-50-304 • Issue 19 • June 1999 • Section 1: Introduction 2.2.11 Blank Panel (PSM-09) This panel is used in chassis module positions in lieu of a module. The panel is a two piece assembly secured to the chassis by two mounting screws. 2.2.12 Test Module (PSM-12) Test Module PSM-12 is normally mounted in the slot position 17 of the PS chassis, but may be mounted in any slot to the left of position 17 (1 through 16). This module provide the user with RS-232/V.24 interface capabilities and stat
ページ19に含まれる内容の要旨
ADCP-50-304 • Issue 19 • June 1999 • Section 1: Introduction 3 SPECIFICATIONS Physical Characteristics PS Chassis Height: 7 inches (17.78 cm) Width: 19 inches (48.3 cm) Depth: 12 inches (30.12 cm) Environmental Conditions Ambient Temperature: Operating: +32° F to +122° F (0° C to +50° C) Storage: –40° F to +158° F (–40° C to +70° C) Relative Humidity: Operating:10% to 80% noncondensing Storage: 5% to 90% noncondensing Power Requirements PS Chassis: +5 Vdc @ 3 amps +12 Vdc @ 1 amp (switching) 3.
ページ20に含まれる内容の要旨
FUNCTIONAL DESCRIPTION
