ページ1に含まれる内容の要旨
Model 3000ESP
Owner's Guide
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Limited Lifetime Consumer Warranty ® Directed Electronics, Inc. ("DEI ") promises to the original purchaser to repair or replace with a comparable reconditioned model any of the purchased brand unit (hereafter the "unit"), excluding without limitation the siren, the remote transmit- ters, the associated sensors and accessories, which proves to be defective in work- manship or material under reasonable use during the lifetime of the vehicle provided the following conditions are met: the unit w
ページ4に含まれる内容の要旨
THIS WARRANTY DOES NOT COVER LABOR COSTS FOR MAINTENANCE, REMOVAL OR REINSTALLATION OF THE UNIT OR ANY CONSEQUENTIAL DAMAGES OF ANY KIND. IN THE EVENT OF A CLAIM OR A DISPUTE INVOLVING DEI OR ITS SUBSIDIARY, THE PROPER VENUE SHALL BE SAN DIEGO COUNTY IN THE STATE OF CALIFORNIA. CAL- IFORNIA STATE LAWS AND APPLICABLE FEDERAL LAWS SHALL APPLY AND GOVERN THE DISPUTE. THE MAXIMUM RECOVERY UNDER ANY CLAIM AGAINST DEI SHALL BE STRICTLY LIMITED TO THE AUTHORIZED DEI DEALER'S PURCHASE PRICE OF THE UNIT.
ページ5に含まれる内容の要旨
Table of Contents Limited Lifetime Consumer Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . i Standard Configuration Transmitter Diagram. . . . . . . . . . . . . . . . . . . . . . . . . 2 What Is Included. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Important Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 FCC/ID Notice . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ページ6に含まれる内容の要旨
Standard Configuration 2 1999 Directed Electronics, Inc. ©
ページ7に含まれる内容の要旨
What is Included n The control module n A pair of two-button transmitters n The red status LED indicator light ® n A push-button Valet switch n Your warranty card ® n Failsafe Starter Kill ready circuitry (may require additional labor) Important Information This system has been designed to provide years of trouble-free op- eration. Due to the complexity of this system, it must only be installed by an authorized dealer. Installation of this product by any person other than an authorized dealer
ページ8に含まれる内容の要旨
FCC/ID Notice This device complies with Part 15 of FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference re- ceived, including interference that may cause undesired operation. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device. System Maintenance The system requires no specific maintenance.
ページ9に含まれる内容の要旨
Transmitter Functions Your vehicle keyless entry system is programmable, making it pos- sible to assign any transmitter button to any specific receiver func- tion. The transmitter initially comes programmed with Standard Configuration, but may also be customized by an authorized deal- er. The buttons in all of the instructions in this manual correspond to a Standard Configuration transmitter. Standard Configuration Button The arm/lock, disarm/unlock, and panic functions are controlled by . Pres
ページ10に含まれる内容の要旨
Using Your System Arming/Locking Pressing for one second will arm the system and lock the doors. The red LED will begin to flash once per second. The Failsafe® Starter Kill will prevent the vehicle’s starter from crank- ing if it has been installed. If connected, the vehicle's horn will honk and the parking lights will flash once to confirm arming of the system. If the ignition is turned on while the system is armed the horn will honk and the parking lights will flash (if connected). NOTE: You
ページ11に含まれる内容の要旨
Disarming/Unlocking To disarm the system and unlock the doors of the vehicle, press for one second. The Failsafe® Starter Kill will be deactivated and the vehicle’s horn (if connected) will honk twice. The parking lights will also flash twice (if connected). The red LED will go out, unless the system is programmed for passive mode. If programmed for passive mode, the LED will begin to flash rapidly when the sys- tem is disarmed. This indicates that the system will re-engage the Failsafe® Starter
ページ12に含まれる内容の要旨
Silent Mode Use the Silent Mode to temporarily turn off the arm or disarm con- firmation honks by briefly pressing before either arming or disarming the system. The confirmation honk(s) will then be elim- inated for that one operation only. To permanently turn off the arm and disarm confirmation honks, contact your installation dealer. Valet® Mode You can prevent your system from automatically activating the Failsafe® Starter Kill relay and locking the doors, by using Valet® Mode. This is very u
ページ13に含まれる内容の要旨
Panic Mode If you are threatened in or near your vehicle, you can attract attention by triggering the system with your transmitter! Just press for 1.5 seconds, and you will enter Panic Mode. The horn will honk and the parking lights will flash for 30 seconds. To stop Panic Mode at any time, press on the transmitter. NOTE: In order for Panic Mode to function, the vehicle’s horn (or option- al siren) as well as the vehicle's parking lights must be connected. Rapid Resume Logic The system will stor
ページ14に含まれる内容の要旨
Programming Options Programming options control what your system does during normal operation, and require little or no additional parts. However, some may require additional installation labor. The following list of program settings shows the defaults in Bold: n Passive mode or active mode. In passive mode the Failsafe Starter Kill relay will be automatically activated 30 seconds after the ignition key is turned off. n Both the ignition switch-controlled door lock and unlock fea- tures can be
ページ15に含まれる内容の要旨
Owner Recognition ® Owner Recognition is a feature available exclusively from DEI . ® Using a DEI Bitwriter hand-held programming tool, your dealer can program many of the system settings. The programmer makes it possible to program different settings for each transmitter that is used with the system. Then, whenever a specific transmitter is used, the system will recall the settings assigned to that transmit- ter. Owner Recognition lets up to four users of the system have dif- ferent settings th
ページ16に含まれる内容の要旨
Valet® Start System: For the ultimate in convenience, the Valet® Start System can start your vehicle, monitor engine functions, and power your climate control system with a push of a button! Over- rev protection, open-hood lockout, brake-pedal shutoff, and auto- matic timer shutoff are all included. This option is available only for automatic-transmission, fuel-injected gasoline vehicles. Power Window Control: Power window control is provided with the 529T or 530T systems. The 529T system will r
ページ17に含まれる内容の要旨
Glossary of Terms Control Unit: The “brain” of your system. Usually hidden under- neath the dash area. It houses the microprocessor which monitors your vehicle and controls all of the alarm’s functions. ® Failsafe Starter Kill: An automatic switch controlled by the secu- rity system that prevents the starter from cranking whenever the system is armed. The vehicle is never prevented from cranking ® when the system is disarmed, in Valet mode, or should the starter kill switch itself fail. Your sy
ページ18に含まれる内容の要旨
Cut along dotted line where indicated for a quick and easy reference to keep in your purse or wallet. " QUICK REFERENCE GUIDE: To arm/lock using your remote n Pressing for one second will arm the system and lock the doors. The red LED will begin to flash once per second. The Failsafe® Starter Kill will prevent the vehicle’s starter from cranking if it has been in- stalled. The vehicle’s horn (if connected) will honk and the parking lights will flash once to confirm arming of the system. To disar
ページ19に含まれる内容の要旨
ページ20に含まれる内容の要旨
The company behind this system is Directed Electronics, Inc. Since its inception, DEI® has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available. The recipient of more than 20 patents in the field of advanced electronic technology, DEI is ISO 9001 registered. Quality Directed Electronics products are sold and serviced throughout North America and around the world. Call (800) 274-0200 for more information about our products and se
