ページ1に含まれる内容の要旨
AUDIO/VIDEO CONTROL RECEIVER
RX-DP10VBK
LEARN TRANSMIT
STANDBY ON
MAIN ROOM SUB ROOM
MAIN ROOM SUB ROOM
TV/CATV/DBS VCR 1
ON/OFF ON/OFF
STANDBY/ON STANDBY/ON
MAIN ROOM SUB ROOM LEARN
DVD DVD MULTI PHONO CD
VCR 1 VCR 2 TAPE/MD CDR
TV/DBS VIDEO FM AM
ANALOG/DIGITAL EFFECT
INPUT 123
ROOM SIZE
SOUND
456
LIVENESS
7/P 89
WALL
10 0 +10
MASTER VOLUME
RETURN FM MODE 100+
TEST SURROUND DSP THX
ON/OFF MODE ON/OFF
STANDBY
LINE DIRECT CC CONVERTER CC CONVERTER DIMMER
SLEEP DIMMER
TV
CATV/ STANDBY/ON
DBS
MA
ページ2に含まれる内容の要旨
Warnings, Cautions and Others CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK. DO NOT REMOVE COVER (OR BACK) NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of suff
ページ3に含まれる内容の要旨
Note to CATV system installer: This reminder is provided to call the CATV system installer’s attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. For the main unit: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. T
ページ4に含まれる内容の要旨
Table of Contents 7 Setting the Surround Sound Output—SURROUND Introduction ................................................ 2 SPEAKER ............................................................................ 38 Features ...................................................................................... 2 7 Setting the Digital Input Terminals—DIGITAL IN ............. 38 Precautions ................................................................................. 2 7 Preparing for the Compo
ページ5に含まれる内容の要旨
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Features Precautions THX Surround EX (DTS-ES compatible) Power sources THX Surround EX is a format that has additional left and right • When unplugging the receiver from the wall outlet, always pull surround back channels on the basis of Dolby Digit
ページ6に含まれる内容の要旨
Parts Identification Front Panel 1 2 3 4 5 6 7 8 9 INPUT MODE SURROUND SOUND SPEAKERS 1 DSP MODE ADJUST MENU DOWN UP SET / INPUT ATT ON / OFF SELECTOR SPEAKERS 2 SUB ROOM THX LINE DIRECT FM MODE SETUP MENU LEFT RIGHT EXIT ON / OFF / SUB ROOM CONTROL p q w e r t y u i o ; a s d f g h DOOR MASTER VOLUME DOWN STANDBY CC CONVERTER DIMMER STANDBY/ON MAIN ROOM DOOR UP ON/OFF RX-DP10V SUB ROOM DOOR DOWN ON/OFF INPUT MODE SPEAKERS 1 SURROUND DSP MODE SOUND ADJUST MENU DOWN UP SET / INPUT A
ページ7に含まれる内容の要旨
Refer to the pages in parentheses for details. Front Panel Display Window 1 SPEAKERS 1 button (18, 23) 1 ANALOG indicator (24) • Lights up when an analog input (source) is selected. 2 INPUT MODE/INPUT ATT button (23, 24) 2 DIGITAL AUTO indicator (24) 3 SURROUND ON/OFF button (48) • Lights up when auto digital input (DIGITAL AUTO) is 4 DSP MODE button (51) selected. 5 SOUND SELECTOR button (22) 3 Surround/DSP mode indicators 6 ADJUST MENU button (42) • Indicate the current Surround/DSP mode setti
ページ8に含まれる内容の要旨
5 ANALOG/DIGITAL INPUT button (23) Remote Control 6 SOUND button (49, 52, 64) 7 LEVEL +/ – buttons (49, 64)
8 TEST button (49, 64) LEARN TRANSMIT STANDBY ON 9 SURROUND ON/OFF button (48, 64) 1 y MAIN ROOM SUB ROOM p LINE DIRECT button (25) MAIN ROOM SUB ROOM TV/CATV/DBS VCR 1 2 ON/OFF ON/OFF u STANDBY/ON STANDBY/ON q SLEEP button (26) w Operating buttons for audio/video components (31, 64 – 69, MAIN ROOM SUB ROOM LEARN 71 – 73) 3 e On-screen operation buttons (34, 42, 57) • SETUP MENU, ADJUST
ページ9に含まれる内容の要旨
Getting Started This section explains how to connect audio/video components and speakers to the receiver, and how to connect the power supply. Before Installation Connecting the FM and AM Antennas General FM Antenna Connections • Be sure your hands are dry. Extend the supplied FM antenna horizontally. • Turn the power off on all components. ANTENNA • Read the manuals supplied with the components you are going to AM FM Antenna EXT connect. Location AM LOOP • Install the receiver in a location tha
ページ10に含まれる内容の要旨
AM Antenna Connections Connecting the Speakers You can connect the following speakers: 1 2 3 • Two pairs of front speakers to produce normal stereo sound. • One pair of surround speakers to enjoy the surround effect. • One pair of surround back speakers to enjoy 7.1 channel sound reproduction. • One center speaker to produce more effective surround effect (to emphasize human voices). • One powered subwoofer to enhance the bass. ANTENNA IMPORTANT: AM After connecting the speakers listed above, se
ページ11に含まれる内容の要旨
RIGHT LEFT RIGHT LEFT RIGHT LEFT Basic connecting procedure Note: You can connect two pairs of front speakers—one pair to the FRONT 4 2 3 1 1 SPEAKERS terminals, and the other pair to the FRONT 2 / SUB ROOM SPEAKERS terminals. The speakers connected to the FRONT 2 / SUB ROOM SPEAKERS terminals can be used as follows: • As the second front speakers in the main room • As the front speakers in the sub-room when using the Multi-room operations. (See page 17.) CAUTION: Use only the speakers of the SP
ページ12に含まれる内容の要旨
Enhance your audio system Connecting Audio/Video Components You can use this receiver as the pre-amplifier (control amplifier) when you connect power amplifiers to the PREOUT jacks on the You can connect the following audio/video components to this rear panel, using cables with RCA pin plugs (not supplied). receiver. Refer also to the manuals supplied with your components. • Connect the white plug to the audio left jack, and the red plug to the audio right jack. Audio Components Video Components
ページ13に含まれる内容の要旨
CD player CD recorder AUDIO CD recorder RIGHT LEFT To audio input To audio output PHONO CD player CD AUDIO RIGHT LEFT OUT PHONO (REC) TAPE MD CD To audio output IN (PLAY) OUT OUT (REC) (REC) TAPE CDR MD IN IN (PLAY) (PLAY) FRONT OUT (REC) DVD CDR SUB IN WOOFER CENTER (PLAY) SURR (REAR) FRONT R L DVD DVD SUB WOOFER CENTER SURR (REAR) Cassette deck or MD recorder R L DVD Cassette deck To audio input To audio output AUDIO RIGHT LEFT PHONO CD If your audio components have a COMPU LINK or TEXT COMPU
ページ14に含まれる内容の要旨
PUSH - OPEN AV COMPU LINK S-VIDEO VIDEO LR AUDIO VIDEO Video component connections IMPORTANT: Use the cables with RCA pin plugs (not supplied). This receiver is equipped with the following video jacks—composite Connect the white plug to the audio left jack, the red plug to the video, S-video and component video jacks. You can use any of the audio right jack, and the yellow plug to the video jack. three to connect a video component. • If your video components have S-video (Y/C-separation) and/or
ページ15に含まれる内容の要旨
TV and/or DBS tuner AUDIO VIDEO COMPONENT COMPONENT RIGHT LEFT VIDEO S-VIDEO When connecting the TV to the AUDIO jacks (TV TV SOUND SOUND/DBS), DO NOT connect the TV’s video Y DBS output to these video input jacks. OUT PB/CB (REC) 1(DVD) VCR1 IN PR/CR (PLAY) OUT Y (REC) VCR2 IN PB/CB (PLAY) 2 FRONT DVD PR/CR To audio output õ To composite video input SUB MONITOR To S-video input Y WOOFER OUT CENTER ë To component video input A TV MONITOR PB/CB SURR OUT R L SURR PR/CR BACK PREOUT R L SUB MO
ページ16に含まれる内容の要旨
DVD player • When you connect the DVD player with stereo output jacks: AUDIO VIDEO COMPONENT COMPONENT RIGHT LEFT RIGHT LEFT VIDEO S-VIDEO TV SOUND Y PHONO DBS OUT CD PB/CB (REC) 1(DVD) VCR1 OUT IN PR/CR (REC) (PLAY) TAPE MD OUT Note: Y IN (REC) (PLAY) If your DVD player has the component video VCR2 OUT output jacks, you can connect it to either the IN PB/CB (REC) (PLAY) COMPONENT 1 (DVD) or the CDR 2 COMPONENT 2 jacks. FRONT PR/CR IN DVD When connecting the DVD player to either (PLAY) one of
ページ17に含まれる内容の要旨
Notes: Digital Connections • When shipped from the factory, the DIGITAL IN terminals have This receiver is equipped with five DIGITAL IN terminals—one been set for use with the following components: digital coaxial terminal and four digital optical terminals—and one – DIGITAL 1 (coaxial): For DVD player DIGITAL OUT terminal. – DIGITAL 2 (optical): For CD player – DIGITAL 3 (optical): For digital TV broadcast tuner IMPORTANT: – DIGITAL 4 (optical): For CD recorder – DIGITAL 5 (optical): For MD re
ページ18に含まれる内容の要旨
ANTENNA BAND1 BAND2 ANTENNA IR OUT BAND1 BAND2 IR OUT RF REMOTE RF REMOTE The RF rod antenna and IR signal Transmitter Setting Up the RF Rod Antenna The combination of the RF rod antenna and the IR signal transmitter The remote control supplied for this receiver can transmit both RF (below) allows you to use the Multi-room function more (Radio Frequency) signal as well as IR (infrared) signal. The RF conveniently. rod antenna can receive the RF signals emitted from the remote The remote con
ページ19に含まれる内容の要旨
Less than 3 m (10 feet) 3. Connect the plug of the transmitter to the IR Putting Batteries in the Remote Control OUT jack of the receiver and attach the transmitter. Before using the remote control, insert the two supplied batteries first. RF REMOTE ANTENNA Target component(s) 3 2 1 BAND1 LR6(AM3) BAND2 /L40(15A) IR OUT At an angle of approx. 60° 1. On the back of the remote control, remove the battery cover. Signal-emitting angle of the transmitter Horizontally: 60˚ Vertically: 60˚ 2. Inse
ページ20に含まれる内容の要旨
Multi-Room Operations Before operating this receiver any further, be familiar with this Multi-room function. This function enables you to listen to different sources in two different places (we call these two places “main room” and “sub-room”) by using this receiver. This section explains only the required speaker connections, the concept, and basic operations of the Multi-room function. For more detailed operations, see the respective pages in this manual. Required Connections for Sub-Room 1. C
