ページ1に含まれる内容の要旨
OWNER’S MANUAL
Model 650
ページ2に含まれる内容の要旨
CONGRATULATIONS Thank you for choosing a Directed Audio audio design, Directed Audio amplifiers power amplifier. Directed has been the will satisfy every music lover’s needs for leader in high-quality and innovative years to come. Your Directed Audio security products in the U.S. since power amplifier comes with a two year 1990. Now we introduce to the car limited warranty if it is installed by an audio industry the same winning authorized DEI dealer. Amplifiers not formula - products that me
ページ3に含まれる内容の要旨
TABLE OF CONTENTS Installation Guidelines . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 2 Amplifier Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 4 Amplifier Controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 5 Speaker Wiring Diagrams . . . . . . . . . . . . . . . . . . . . . . . . .Page 6 Crossover Setting and Gain Adjustment . . . . . . . . . . . . . . . .Page 7 Specification . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ページ4に含まれる内容の要旨
INSTALLATION GUIDELINES 1. Please read the owner’s manual more amps than the on board carefully before you install the fuse(s) of the amplifier(s). The amplifier. gauge of power wire used should 2. Disconnect the battery ground take into account the total current terminal prior to making any elec- draw of the system, and the length trical connections. of wire used. IASCA and other 3. Check for any hazards or obstruc- autosound competition organiza- tions such as gas tanks, fuel or tions have c
ページ5に含まれる内容の要旨
INSTALLATION GUIDELINES (continued) is generated. For low impedance 10. Due to the high-frequency MOSFET speaker applications or restricted switching power supply used in all ventilation installations, an external Directed Audio amplifiers, filtering cooling fan may be advisable. the power cable is not generally 9. Your connections to the amplifier’s required (remember that the amp speaker and power terminals can’t deliver full output if the power should be made with crimped spade supply is res
ページ6に含まれる内容の要旨
AMPLIFIER CONNECTIONS Refer to Figure 1 for details. 1. GROUND TERMINAL - connect this 3. +12V POWER TERMINAL - connect terminal to the car chassis with a this terminal to the positive short heavy gauge wire, DO NOT terminal of the car or separate CONNECT TO THE NEGATIVE audio system battery. Refer to the TERMINAL OF THE CAR BATTERY or installation guidelines and specs to factory chassis ground points page for proper gauge of wire. YOU already occupied by factory wires! MUST PROTECT THIS WIRE W
ページ7に含まれる内容の要旨
AMPLIFIER CONTROLS Refer to Figure 2 for details. crossover frequency controls to 1. RCA INPUT JACKS - accepts line- level outputs from head units or adjust the subwoofer output. signal sources at voltages from 6. BASS EQ - This switch activates an 200mV to 8 volts. 8dB bass boost circuit. Use as 2. GAIN ADJUSTMENT - controls the necessary for low frequency enhancement. gain (input sensitivity) of the amplifier. Each control sets the gain 7. CROSSOVER FREQUENCY - controls for that half of the a
ページ8に含まれる内容の要旨
SPEAKER WIRING DIAGRAMS Five channel operation Three channel operation For bridged three channel operation as shown in this diagram, connect right channel RCAcables to the “FRONT” inputs of the amplifier, and left channel RCA cables to the “REAR” inputs of the amplifier. 6 © 1999 Directed Electronics, Inc
ページ9に含まれる内容の要旨
CROSSOVER SETTINGS AND GAIN ADJUSTMENT Your Directed Audio power amplifier needs to be adjusted carefully to achieve maximum performance. These are some guidelines to follow when fine-tuning the amplifier. • For normal complete system applications, the crossover selection switches should be set to "HPF". • The crossover frequency controls need to be adjusted to suit your particular system. For subwoofer applications, try and keep the setting low enough to prevent image smearing (you should not
ページ10に含まれる内容の要旨
SPECIFICATIONS ch 1-4 ch 5 RMS continuous power per channel,Channels 1-4 driven into 4 ohms 50 250 from 20 to 20,000 Hz, with less than 0.08% total Harmonic Distortion watts watts @ 14.4 VDC. Channel 5 driven into 4 ohms from 20-250 Hz, with less than 0.08% THD @ 14.4 VDC. RMS continuous power per channel,Channels 1-4 driven into 2 ohms 75 350 from 20 to 20,000 Hz, with less than 0.1% Total Harmonic Distortion watts watts @ 14.4 VDC. Channel 5 driven into 2 ohms from 20-250 Hz, wit
ページ11に含まれる内容の要旨
LIMITED TWO YEAR CONSUMER WARRANTY ® Directed Electronics, Inc. (DEI ) promises to ULAR PURPOSE, AND WARRANTY OF the original purchaser, to replace this NON-INFRINGEMENT OF INTELLECTUAL product should it prove to be defective in PROPERTY ARE EXPRESSLY EXCLUDED TO workmanship or material under normal use, THE MAXIMUM EXTENT ALLOWED BY for a period of two years from the date of LAW, AND DEI NEITHER ASSUMES NOR purchase by the dealer as indicated by the AUTHORIZES ANY PERSON TO ASSUME date code mar
ページ12に含まれる内容の要旨
OTHER PRODUCTS AVAILABLE FROM: • CLASS D MONO AMPLIFIERS ® • 2 CHANNEL AMPLIFIERS • 4 AND 5 CHANNEL AMPLIFIERS • SIGNAL PROCESSORS • TUBE SUBWOOFERS • POWERED SUBWOOFERS • SINGLE AND DUAL VOICE COIL SUBWOOFERS • COAXIAL SPEAKERS • SINGLE AND DUAL VOICE COIL SUBWOOFERS • COAXIAL SPEAKERS • COMPONENT SPEAKER SYSTEMS • SINGLE AND DUAL VOICE COIL DIE-CAST SUBWOOFERS • COMPONENT NEODYMIUM SPEAKER SYSTEMS • SINGLE AND DUAL VOICE COIL DIE-CAST SUBWOOFERS • HIGH PERFORMANCE POWER CABLES • PREMIUM S
