ページ1に含まれる内容の要旨
HTR-5130/HTR-5130RDS
BG
HTR-5130
HTR-5130RDS
NATURAL SOUND AV RECEIVER
AMPLI-TUNER AUDIO-VIDEO
OWNER’S MANUAL
MODE D’EMPLOI
BEDIENUNGSANLEITUNG
BRUKSANVISNING
MANUALE DI ISTRUZIONI
MANUAL DE INSTRUCCIONES
YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A.
YAMAHA CANADA MUSIC LTD. 135 MILNER AVE., SCARBOROUGH, ONTARIO M1S 3R1, CANADA
GEBRUIKSAANWIJZING
YAMAHA ELECTRONIK EUROPA G.m
ページ2に含まれる内容の要旨
SUPPLIED ACCESSORIES l After unpacking, check that the following parts are included. ACCESSORIES FOURNIS l Après le déballage, vérifier que les pièces suivantes sont incluses. MITGELIEFERTE ZUBEHÖRTEILE l Nach dem Auspacken überprüfen, ob die folgenden Teile vorhanden sind. MEDFÖLJANDE TILLBEHÖR l Kontrollera efter det apparaten packats upp att följande delar finns med. ACCESSORI IN DOTAZAIONE l Verificare che tutte le parti seguenti siano contenute nell’imballaggio dell’apparecchio. ACCESORIOS
ページ3に含まれる内容の要旨
English Thank you for selecting this YAMAHA AV receiver. FEATURES l 5 Speaker Configuration l 3 Center Channel Modes (NORMAL/WIDE/PHANTOM) (Power Amp. Section) Main: 60W + 60W (8Ω) RMS Output l Multi-Functions for RDS Broadcast Power, 0.04% THD, 20–20,000 Hz Reception HTR-5130RDS only Center: 60W (8Ω) RMS Output Power, l 40-Station Random Access Preset Tuning 0.04% THD, 20–20,000 Hz l Automatic Preset Tuning Rear: 60W + 60W (8Ω) RMS Output Power, 0.04% THD, 20–20,000 Hz l Preset Station Shifting
ページ4に含まれる内容の要旨
CAUTION : READ THIS BEFORE OPERATING YOUR UNIT. 1. To assure the finest performance, please read this manual IMPORTANT carefully. Keep it in a safe place for future reference. Please record the serial number of this unit in the space below. 2. Install this unit in a cool, dry, clean place – away from windows, heat sources, sources of excessive vibration, Model: dust, moisture and cold. Avoid sources of humming (transformers, motors). To prevent fire or electrical shock, Serial No.: do not exp
ページ5に含まれる内容の要旨
English 30° For U.K. customers Special Instructions for U.K. Model If the socket outlets in the home are not suitable for the plug IMPORTANT supplied with this appliance, it should be cut off and an THE WIRES IN MAINS LEAD ARE COLOURED IN appropriate 3 pin plug fitted. For details, refer to the ACCORDANCE WITH THE FOLLOWING CODE: instructions described on the right. Blue: NEUTRAL Note: The plug severed from the mains lead must be Brown: LIVE destroyed, as a plug with bared flexible cord is hazar
ページ6に含まれる内容の要旨
PROFILE OF THIS UNIT You are the proud owner of a Yamaha stereo receiver – an extremely sophisticated audio component. The Digital Sound Field Processor (DSP) built into this unit takes advantage of Yamaha’s undisputed leadership in the field of digital audio processing to bring you a whole new world of listening experiences. Follow the instructions in this manual carefully when setting up your system, and this unit will sonically transform your room into a wide range of listening environments –
ページ7に含まれる内容の要旨
English SPEAKER SETUP SPEAKERS TO BE USED This unit is designed to provide the best sound-field quality with a 5 speaker configuration. The most effective speakers to use with this unit are main speakers, rear speakers and a center speaker. You may omit the center speaker. (Refer to the “4-Speaker Configuration” shown below.) The main speakers are used for the majority of the sound output as well as effect sounds. The rear speakers are used for the effect and surround sounds, and the center spea
ページ8に含まれる内容の要旨
CONNECTIONS CONNECTIONS WITH OTHER COMPONENTS Never plug in this unit and other components until all connections are completed. When making connections between this unit and other components, be sure all connections are made correctly; that is to say L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. Also, refer to the owner’s manual for each component to be connected to this unit. * If you have YAMAHA components numbered as 1, 3, 4, etc. on the rear panel, connections can be made easily
ページ9に含まれる内容の要旨
English Connecting an external decoder for Dolby Digital, DTS and other future formats or a DVD player, etc. If you have a separate Dolby Digital, DTS or other format decoder, or if you have a DVD player or other component which incorporates a Dolby Digital, DTS, or other format decoder, its 6 channel discrete outputs can be connected to the 6CH DISCRETE INPUT terminals of this unit. (Example) 6CH DISCRETE OUTPUT MAIN CENTER SURROUND Dolby Digital decoder SUB DIGITAL WOOFER IN 6CH DISCRETE INPUT
ページ10に含まれる内容の要旨
CONNECTING SPEAKERS Main speakers A Main speakers B Right Left Left Right SPEAKERS MAIN A IMPEDANCE SELECTOR SET BEFORE POWER ON B MAIN A OR B: 4ΩMIN. /SPEAKER A B: 8ΩMIN. /SPEAKER Subwoofer system CENTER : 6ΩMIN. /SPEAKER REAR : 6ΩMIN. /SPEAKER REAR R CENTER (SURROUND) MAIN A OR B: 8ΩMIN. /SPEAKER A B:16ΩMIN. /SPEAKER CENTER : 8ΩMIN. /SPEAKER OUTPUT REAR : 8ΩMIN. /SPEAKER SUB WOOFER CAUTION SEE INSTRUCTION MANUAL FOR CORRECT SETTING. Right Left Center speaker Rear speakers
ページ11に含まれる内容の要旨
English How to Connect: Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is the + and – markings are observed. If these wires are reversed, the sound will be unnatural and lack bass. Caution Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit
ページ12に含まれる内容の要旨
SUBWOOFER OUTPUT terminal OUTPUT SUB WOOFER This terminal is for connecting to the input terminal of an amplifier driving a subwoofer. This terminal outputs low frequencies from the main and center channels. (The cut-off frequency of signals output from this terminal is 150 Hz.) When 6 channel discrete signals are input to this unit and are selected as the input source, this terminal outputs signals from the subwoofer channel. IMPEDANCE SELECTOR switch Be sure to switch this only when the power
ページ13に含まれる内容の要旨
English ANTENNA CONNECTIONS l Each antenna should be connected to the designated terminals correctly, referring to the following diagram. l Both AM and FM indoor antennas are included with this unit. In general, these antennas will probably provide sufficient signal strength. Nevertheless, a properly installed outdoor antenna will give clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may result in improvement. Outdoor FM antenna Outdoor AM antenn
ページ14に含まれる内容の要旨
CONTROLS AND THEIR FUNCTIONS FRONT PANEL ~ Ù
! Ú
@Û
Ü
$ # NATURAL SOUND AV RECEIVER VOLUME l6 20 l2 28 8 TV/DBS DVD/LD VCR 2CH/6CH 2CH/6CH STANDBY/ON 40 4 TAPE/MD TUNER PHONO CD MONITOR 60 2 0 –dB TUNING DELAY/CENTER/ A/B/C/D/E 1 2 3 4 56 7 8 MEMORY EDIT MODE FM/AM DOWN TUNING UP REAR/SWFR TIME/LEVEL MAN'L/AUTO FM AUTO/MAN'L MONO BASS TREBLE BALANCE RDS MODE/ CONCERT PHONES SPEAKERS FREQ EON PRO LOGIC ENHANCED VIDEO MONO MOVIE CENTER MODE 0 0 0 l l l l l l A B 2 2 2 2 2 2 ROCK CONCERT
ページ15に含まれる内容の要旨
English Ý PHONES jack ( EON button HTR-5130RDS only To listen with headphones, connect the headphones to the Press this button to select a specified program type (NEWS, PHONES jack. The sound output from the PHONES jack is the INFO, AFFAIRS, SPORT) when you want to locate a radio same as that from the main speakers. program of that type automatically. (Refer to page 34.) When listening with headphones privately, set both the SPEAKERS A and B switches to the OFF position and switch á TUNING DOWN
ページ16に含まれる内容の要旨
DISPLAY PANEL ~Ù
! Ú
@Û
PRESET SLEEP STEREO NORM ms dB WIDE kHz PHANTOM MHz 0 20 l00 EFFECT OFF PRO LOGIC CONCERT MONO DISCO ROCK CONCERT MEMORY AUTO PTY HOLD NEWS INFO ENHANCED VIDEO MOVIE TV SPORTS CONCERT HALL PS PTY RT CT EON AFFAIRS SPORT TAPE MON ß
# Ü
$ Ý
%Þ
^ ~ Multi-information display Ü MEMORY indicator Displays various information, for example station frequency, When the MEMORY button is pressed, this indicator flashes for preset station number and name of selected input source.
ページ17に含まれる内容の要旨
English REMOTE CONTROL TRANSMITTER The remote control transmitter provided with this unit is designed to control all the most commonly used functions of this unit. If the CD player and tape deck connected to this unit are YAMAHA components designed for remote control compatibility, then this remote control transmitter will also control various functions of each component. $ TIME/ DELAY/CENTER –+ LEVEL TEST EFFECT /REAR/SWFR ~ Ü
ON/OFF PROGRAM PROLOGIC ENHANCED # VCR TV/DBS DVD/LD 2CH /6CH PLAY
ページ18に含まれる内容の要旨
For Control of This Unit # Program selector keys ~ DELAY/CENTER/REAR/SWFR and TIME/LEVEL +/– keys PROGRAM: Adjust the delay time (DELAY), the center channel output level When the built-in digital sound field processor (including the (CENTER), the rear channel output level (REAR) and the Dolby Pro Logic Surround decoder) is on, this key changes the output level to the SUBWOOFER OUTPUT terminal (SWFR). currently selected DSP program whenever the right or left side Select the item which you want to
ページ19に含まれる内容の要旨
English SPEAKER BALANCE ADJUSTMENT This procedure lets you adjust the sound output level balance between the main, center, and rear speakers using the built-in test tone generator. When this adjustment is performed, the level heard at the listening position should sound the same from each speaker. This is important for the best performance of the digital sound field processor and the Dolby Pro Logic Surround decoder. 5 2 1 TIME/ DELAY/CENTER –+ LEVEL /REAR/SWFR TEST EFFECT ON/OFF PROGRAM PROLOGI
ページ20に含まれる内容の要旨
10 TIME/ DELAY/CENTER –+ LEVEL /REAR/SWFR TEST EFFECT 9 ON/OFF PROGRAM PROLOGIC ENHANCED VCR TV/DBS DVD/LD 2CH /6CH DIR A DIR B REC/PAUSE PLAY TAPE A/B A/B/C/D/E TUNER –+ PRESET PLAY DISC CD LR PHONO POWER /I VOLUME SLEEP 867 7 7 Turn up the volume. 6 Select the center channel output mode suitable for your VOLUME speaker configuration. (Refer to “SPEAKER CONFIGURATION” on page 7.) l6 20 l2 28 8 40 44 CENTER MODE NORMAL 60 2 0 –dB WIDE PHANTOM You will hear a test tone (like pink noise) in orde
