ページ1に含まれる内容の要旨
OPERATINGINSTRUCTIONS
TD A S
MASTER VOLUME
TOTALLY DISCRETE AMPLIFIER STAGE
MAIN POWER
REMOTE ST TUNED TAPE M PRESET
SENSOR
MEM
dB
kHz
TONE
MHz
DIRECT
ms
DTS DIGITAL Pro Logic THEATER HALL SLEEP
ON/ OFF
INPUT SELECTOR SURROUND MODE
STANDBY DIGITAL TONE
VIDEO TAPE MON.
AUDIO 6CH DIRECT AUTO DSP MODE STEREO INPUTS DIRECT
ON/STANDBY
VIDEO 3
PHONES
CHANNEL SPEAKER DYNAMIC
SPEAKER
SELECTOR ADJUST TONE MODE MODE RANGE CINEMA EQ MEMO/ENTER TUNING/PRESET T/P MODE FM MODE BAND
ON/OFF
VIDEO L - AUDIO -
ページ2に含まれる内容の要旨
IIn nt tr ro od du uc ct tiio on n UNPACKING AND INSTALLATION FOR U.S.A. Congratulations on Your Purchase! Note to CATV System Installer: This reminder is Your new high fidelity receiver is designed to deliver provided to call the CATV system installer's attention maximum enjoyment and years of trouble free service. to Article 820-40 of the NEC that provides guidelines Please take a few moments to read this manual for proper grounding and, in particular, specifies that thoroughly. It will expla
ページ3に含まれる内容の要旨
READ THIS BEFORE OPERATING YOUR UNIT FOR U.S.A. AND CANADA 120 V FOR OTHER COUNTRIES 115 V/230 V FOR YOUR SAFETY FOR YOUR SAFETY Units shipped to the U.S.A. and Canada are designed Units shipped to countries other than the above for operation on 120 volts AC only. countries are equipped with an AC voltage selector switch on the rear panel. Refer to the following Observe all safety precautions for use of a polarized paragraph for the proper setting of this switch. AC plug. However, some product
ページ4に含まれる内容の要旨
CONTENTS Introduction UNPACKING AND INSTALLATION....................................................................................................... 2 READ THIS BEFORE OPERATING YOUR UNIT................................................................................... 3 System Connections........................................................................................................................................ 5 Front Panel Controls.............................................
ページ5に含まれる内容の要旨
S Sy ys st te em m C Co on nn ne ec ct tiio on ns s When making system connections, please be certain the AC cord is not plugged into an AC outlet. When making connections between components, please be sure to connect the white RCA plugs to the L(left) and the red RCA plugs to the R(right) jacks respectively. Change the position of the FM indoor antenna until you get the best reception of your favorite FM stations. A 75 Ω outdoor FM antenna may be used to further improve the reception. Disc
ページ6に含まれる内容の要旨
SUBWOOFER PRE OUT connection PRE OUT SUB WOOFER This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: Manufactured under license from Dolby Laboratories. “Dolby”, “Pro Logic” AC INPUT (1)This device may not cause harmful interference, and (2)this device must accept any interference received, Manufactured under license from Digital Theater Systems, Inc. and the double-D symbol are trademarks of Dolby Laboratories. Confidential 120V~60Hz Unpubl
ページ7に含まれる内容の要旨
AC INPUT CORD Plug this cord into an AC outlet. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and Manufactured under license from Dolby Laboratories. “Dolby”, “Pro Logic” AC INPUT (2)this device must accept any interference received, Manufactured under license from Digital Theater Systems, Inc. and the double-D symbol are trademarks of Dolby Laboratories. Confidential 120V~60Hz 180W
ページ8に含まれる内容の要旨
F Fr ro on nt t P Pa an ne ell C Co on nt tr ro olls s 6 CH DIRECT BUTTON REMOTE SENSOR AUTO BUTTON AUDIO INPUT SELECTOR BUTTON DSP MODE BUTTON VIDEO INPUT SELECTOR BUTTON MASTER VOLUME TONE DIRECT BUTTON/INDICATOR TAPE MONITOR BUTTON CONTROL KNOB STANDBY BUTTON/ DIGITAL INPUT BUTTON INDICATOR POWER SWITCH STEREO BUTTON TD A S MASTER VOLUME TOTALLY DISCRETE AMPLIFIER STAGE MAIN POWER REMOTE ST TUNED TAPE M PRESET SENSOR MEM dB kHz TONE MHz DIRECT ms DTS DIGITAL Pro Logic THEATER HALL SLEEP
ページ9に含まれる内容の要旨
D DIIG GII L LIIN NK K IIIIII S Sy ys st te em m R Re em mo ot te e C Co on nt tr ro olls s All Sherwood components bearing the DIGI LINK (II or III) logo can be used with this remote control. To control associated Sherwood Digi Link components, you must first make the DIGI LINK connections between the components. With the Sherwood Digi Link III system, pressing a transport control key such as PLAY, on a Sherwood CD player or tape deck will automatically engage that input on the receiver
ページ10に含まれる内容の要旨
30 REMOTE CONTROL OPERATION RANGE AUDIO/VIDEO RECEIVER RD-7103 TD A S MASTER VOLUME TOTALLY DISCRETE AMPLIFIER STAGE MAIN POWER REMOTE ST TUNED TAPE M PRESET SENSOR dB MEM kHz TONE MHz DIRECT ms DTS DIGITAL Pro Logic THEATER HALL SLEEP ON/ OFF STANDBY INPUT SELECTOR SURROUND MODE DIGITAL TONE AUDIO VIDEO TAPE MON. 6CH DIRECT AUTO DSP MODE STEREO INPUTS DIRECT ON/STANDBY VIDEO 3 PHONES SPEAKER SELECTOR CHANNEL ADJUST TONE MODE SPEAKER MODE DYNAMIC RANGE CINEMA EQ MEMO/ENTER TUNING/PRESET T/P MO
ページ11に含まれる内容の要旨
O Op pe er ra at tiio on ns s LISTENING TO A PROGRAM SOURCE Select the desired input source. B Be ef fo or re e o op pe er ra at tiio on n 3 Enter the standby mode. POWER P.SCAN 12 3 4 5 INPUT SELECTOR 678 9 0 MAIN POWER DISC CD TUNER VIDEO1 AUDIO VIDEO TAPE MON. CD REPEAT INTRO A B < A DECK SEL. B DECK PRESET USER FILE T.MON DISPLAY AUX TAPE MON. VIDEO2 CD TUNER VIDEO1 EQUALIZER AUX TAPE MON. VIDEO2 STEREO ON/ OFF 6CH DIRECT VIDEO3 AUTO DSP MODE INPUT SELECTOR T.TONE CH SEL. or VIDEO3 D.TIM
ページ12に含まれる内容の要旨
To compensate for edgy or shrill movie W Wh he en n C CD D o or r V VIID DE EO O1 1~ ~3 3 iis s s se elle ec ct te ed d a as s a an n sound tracks. iin np pu ut t s so ou ur rc ce e 7 Select the digital or analog input CINEMA EQ connected as desired. 4 DIGITAL INPUTS Then “CINEMA EQ ON” is displayed. Each time this button is pressed, the corresponding Press it again to cancel, the “CINEMA EQ OFF” input is selected as follows ; is displayed. Optical 1 Coaxial 1 Coaxial 2 No display(
ページ13に含まれる内容の要旨
At the desired tone mode, adjust the tone A Ad djju us st tiin ng g t th he e t to on ne e( (b ba as ss s a an nd d t tr re eb blle e) ) as desired. 11 Enter the tone mode. ADJUST 10 TONE MODE If the tone display disappears, start from the step 10 again. Each time this button is pressed, the corresponding Notes: tone mode is selected and shown for 3 seconds as Extreme settings at high volume may damage your follows: speakers. BASS TRBL(treble) In the DTS or Dolby Digital mode, the ton
ページ14に含まれる内容の要旨
SURROUND SOUND This receiver incorporates a sophisticated Digital Signal Processor that allows you to create optimum sound quality and sound atmosphere in your personal Home Theater. Surround modes This unit has 6 different surround modes to allow you to enjoy surround sound with various program sources: DTS, DOLBY DIGITAL, DOLBY PRO LOGIC, DOLBY VIRTUAL, THEATER, HALL. DTS (Digital Theater System) : Allows you to enjoy 5.1(or 6) discrete channels of high quality digital audio from DTS program
ページ15に含まれる内容の要旨
Speaker placement FRONT TV set FRONT LEFT RIGHT SUB CENTER SPEAKER WOOFER To obtain the best surround sound effect in your home, place the speakers as follows; Front speakers: Place each front speaker about 1m (40 ) from the TV set. Center speaker: Place the center speaker either above or below the TV set to assure good visualization of center channel program. Rear speakers: Place the rear speakers approximately 1m above the ear level of a seated listener on the direct left and right of them
ページ16に含まれる内容の要旨
Select the desired speaker setting. Adjusting the speaker settings SPEAKER MODE 3 Adjust the settings of front, center ,rear speakers and subwoofer connected. If the speaker setting is adjusted to “S”, the low range bass sound of the channel(s) is redirected to the subwoofer or the front channels and if the speaker Each time this button is pressed, one of 11 different setting is adjusted to “N”, the sound of the channel(s) speaker settings is selected and displayed for 8 is redirected to othe
ページ17に含まれる内容の要旨
Adjust the level of the selected channel Adjusting each channel level as desired. 8 Select the desired channel. POWER P.SCAN 7 12 3 4 5 678 9 0 POWER P.SCAN DISC 12 3 4 5 CD REPEAT INTRO A B < 678 9 0 ADJUST A DISC CHANNEL DECK SEL. CD B DECK REPEAT INTRO SELECTOR A B < or PRESET USER FILE T.MON DISPLAY CD TUNER VIDEO1 EQUALIZER A DECK SEL. AUX TAPE MON. VIDEO2 STEREO B DECK PRESET USER FILE T.MON DISPLAY 6CH DIRECT VIDEO3 AUTO DSP MODE INPUT CD TUNER VIDEO1 EQUALIZER SELECTOR T.TONE CH SEL.
ページ18に含まれる内容の要旨
Check the delay time to be adjusted. In the surround modes except for the DTS, 13 POWER P.SCAN normal stereo and Dolby Virtual modes, 12 3 4 5 678 9 0 DISC CD REPEAT INTRO A B < A DECK SEL. B DECK PRESET USER FILE T.MON DISPLAY When the distances from the prime listening position to front CD TUNER VIDEO1 EQUALIZER AUX TAPE MON. VIDEO2 STEREO D.TIME 6CH DIRECT VIDEO3 AUTO DSP MODE left, center, front right, rear left and rear right speakers are SELECTOR INPUT T.TONE CH SEL. D.TIME ADJUST CH LE
ページ19に含まれる内容の要旨
LISTENING TO RADIO BROADCASTS Select the desired band. Auto tuning 2 Select the tuner. BAND 1 MHz POWER P.SCAN 12 3 4 5 678 9 0 AUDIO DISC CD REPEAT INTRO A B < BAND FREQUENCY A DECK SEL. B DECK PRESET USER FILE T.MON DISPLAY CD TUNER VIDEO1 EQUALIZER TUNER AUX TAPE MON. VIDEO2 STEREO or 6CH DIRECT VIDEO3 AUTO DSP MODE Each time this button is pressed, the band is changed INPUT SELECTOR T.TONE CH SEL. D.TIME ADJUST CH LEVEL MASTER DISPLAY SLEEP MUTE to FM or AM. SYS When pressing the BAND bu
ページ20に含まれる内容の要旨
Repeat the above steps 1 to 3 to memorize Select the desired preset number (1~30) and other stations. press the MEMORY/ENTER button. 4 3 MEMO/ENTER TUNING/PRESET MEMORY BACKUP FUNCTION When using the NUMERIC buttons on the remote The following items, set before the receiver is turned control. off, are memorized. Examples) INPUT SELECTOR settings 3 For “3” : Surround mode settings within 2 seconds 1 5 Preset stations,etc. For “15” : Note : If the electricity fails or the AC input cord is Th