ページ1に含まれる内容の要旨
TROUBLESHOOTING SPECIFICATIONS
Dish Diameter: 11.6"
Your ANT2050X antenna comes with a switchable amplifier which is
Dipole Length: 35.9"
designed to operate over a wide range of signal strengths. The default
setting is the DX (distance setting) which is set at the factory and Height: Adjustable
allows maximum amplifier gain. Normally there will be no need to Included Accessories: 2 - 7 ft. RG-6 weather resistant cables,
change this setting to the LOC (Local) position, however if the 2 - Diplexe
ページ2に含まれる内容の要旨
Omni-Directional DBS Off-Air Antenna Direct Broadcast Satellite CAUTION • If you notice anything making contact with the overhead wires, WARNING! call the power company to have the item removed properly. USE EXTREME CAUTION WHEN INSTALLING AN • Do not run the downlead cable over power wires. OUTDOOR ANTENNA CLOSE TO OVERHEAD WIRES. • If there is any doubt of clearing overhead wires, only a IF THE ANTENNA STARTS TO FALL, LET IT GO! IF qualified professional should remove an old antenna. ANY PART
ページ3に含まれる内容の要旨
TROUBLESHOOTING SPECIFICATIONS Dish Diameter: 11.6" Your ANT2050X antenna comes with a switchable amplifier which is Dipole Length: 35.9" designed to operate over a wide range of signal strengths. The default setting is the DX (distance setting) which is set at the factory and Height: Adjustable allows maximum amplifier gain. Normally there will be no need to Included Accessories: 2 - 7 ft. RG-6 weather resistant cables, change this setting to the LOC (Local) position, however if the 2 - Diplexe
ページ4に含まれる内容の要旨
T TM M In Out DBS Video/Audio 75 Ohm "F Jack Input In Video/Audio DBS Receiver Television Back 75 Ohm "F" Jack Input INSTALLATION CONTINUED INSTALLATION CONTINUED the straight pipe with 5 holes (as shown in diagram B). Now place assembled pipes into small end of double mounting clamp and Output to the TV’s S-Video Input (as shown in diagram I). loosely secure clamp with wrench (as shown in diagram C). RCA patch cords and S-Video cables are supplied in most DBS installation kits. 5. Mount pipe