ページ1に含まれる内容の要旨
CA_MXKA6.book Page 1 Friday, February 7, 2003 7:56 PM
COMPACT COMPONENT SYSTEM
CA-MXKA6
STANDBY/ON
SLEEP
AUX
FM MODE FM /AM
CD
CD1 CD2 CD3
REPEAT PROGRAM /RANDOM
TAPE TAPE
A/B
SELECT RDS MODE DISPLAY MODE
SOUND VOLUME
MODE
FADE
ACTIVE SOUND
BASS EX. TURBO MUTING
RM-SMXKA6R REMOTE CONTROL
INSTRUCTIONS
For Customer Use:
Enter below the Model No. and Serial No.
which are located either on the rear, bot-
tom or side of the cabinet. Retain this
information for future reference.
Model No.
ページ2に含まれる内容の要旨
Warning.fm Page 1 Friday, February 7, 2003 8:11 PM Warnings, Cautions and Others IMPORTANT FOR LASER PRODUCTS IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fit- REPRODUCTION OF LABELS ted is not suitable for the power points in your home or the cable is 1 CLASSIFICATION LABEL, PLACED ON EXTERIOR SURFACE too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only wit
ページ3に含まれる内容の要旨
Warning.fm Page 2 Friday, February 7, 2003 8:11 PM SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been disigned and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. ✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮ Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connection
ページ4に含まれる内容の要旨
CA_MXKA6.book Page 1 Friday, February 7, 2003 7:56 PM Introduction Thank you for purchasing the JVC Compact Component System. We hope it will be a valued addition to your home, giving you years of enjoyment. Be sure to read this instruction manual carefully before operating your new stereo system. In it you will find all the information you need to set up and use the system. If you have a query that is not answered by the manual, please contact your dealer. Features Here are some of the thin
ページ5に含まれる内容の要旨
CA_MXKA6.book Page 2 Friday, February 7, 2003 7:56 PM Table of Contents Introduction ...................................................................................................................1 Features.................................................................................................................................................... 1 How This Manual Is Organized............................................................................................................
ページ6に含まれる内容の要旨
CA_MXKA6.book Page 3 Friday, February 7, 2003 7:56 PM Getting Started Accessories Make sure that you have all of the following items, which are supplied with the System. AM (MW) Loop Antenna (1) FM Wire Antenna (1) Remote Control (1) Batteries (2) If any of these items are missing, contact your dealer immediately. How To Put Batteries In the Remote Control Match the polarity (+ and –) on the batteries with the + and – markings in the battery compartment. R6P(SUM-3)/AA(15F) CAUTION: Handle b
ページ7に含まれる内容の要旨
CA_MXKA6.book Page 4 Friday, February 7, 2003 7:56 PM
CAUTION: Make all connections before plugging the System into an AC power outlet. Connecting the FM Antenna
FM wire antenna (supplied)
A 75-ohm antenna with coaxial type connector (IEC or DIN45 325) should be connected to the FM 75-ohm COAXIAL terminal. If reception is poor, connect the outdoor antenna. FM outdoor antenna (Not supplied) Coax
ページ8に含まれる内容の要旨
CA_MXKA6.book Page 5 Friday, February 7, 2003 7:56 PM
Connecting the AM (MW) Antenna
AM (MW) antenna wire (not supplied) If reception is poor, connect the outside antenna. Turn the loop until you have the best reception. AM (MW) loop antenna (Supplied) Attach the AM (MW) loop to its base by snapping the tabs on the loop into the slot in the base. Even when connecting an outside AM (MW) antenna, keep the indoor AM (MW) loop connected. CAUTION: To
ページ9に含まれる内容の要旨
CA_MXKA6.book Page 6 Friday, February 7, 2003 7:56 PM
Connecting External Equipment Connect a signal cord (not supplied) between the System’s AUX-IN terminals and the output terminals of the external MD recorder, tape deck, etc. You can then listen to the external source through the System. Signal cord (not supplied) MD recorder, tape deck, etc. (not supplied) Pin-plug x 2 Pin-plug x 2 Connecting to the Wall Outlet Plug the AC power cord into the wall outlet. Now, your System
ページ10に含まれる内容の要旨
Body.fm Page 7 Thursday, February 13, 2003 10:11 AM Basic Operations ) STANDBY/ON STANDBY/ON SLEEP Display Numeric AUX keys FM MODE FM /AM SOUND MODE VOLUME SOUND TURBO ACTIVE BASS EX. PHONES CD CD1 CD2 CD3 STANDBY indicator REPEAT PROGRAM /RANDOM TAPE TAPE A/B SELECT RDS MODE DISPLAY MODE ECO SOUND VOLUME SOUND MODE MODE FADE ACTIVE SOUND VOLUME +,– BASS EX. TURBO MUTING ACTIVE FADE MUTING BASS EX. RM-SMXKA6R REMOTE CONTROL SOUND Various information TURBO BASS indicator Sound Mode indic
ページ11に含まれる内容の要旨
CA_MXKA6.book Page 8 Friday, February 7, 2003 7:56 PM
Adjusting the Volume Selecting the Sound Mode (SOUND MODE) Turn the VOLUME control on the Unit clockwise to increase the volume or turn it counterclockwise to decrease the volume. You can select one of 3 SEA (Sound Effect Amplifier) modes. Press the VOLUME + button on the Remote Control to increase You can use this effect only for playback. the volume or press the VOLUME – button on the Remote Control to decrease the volum
ページ12に含まれる内容の要旨
CA_MXKA6.book Page 9 Friday, February 7, 2003 7:56 PM Using the Tuner STANDBY/ON Numeric SLEEP keys AUX FM MODE FM /AM ¡ ¢ FM/AM FM MODE SET CD CD1 CD2 CD3 SELECT +,– REPEAT PROGRAM /RANDOM RDS MODE TAPE TAPE A/B DISPLAY MODE SELECT RDS MODE DISPLAY MODE FM/AM DISPLAY MODE SOUND VOLUME MODE 4 22 SELECT +,– RDS MODE ACTIVE SOUND FADE MUTING BASS EX. TURBO RM-SMXKA6R REMOTE CONTROL Band display, Frequency display, Preset channel RDS indicator FM mode indicators * When the System is in use, th
ページ13に含まれる内容の要旨
CA_MXKA6.book Page 10 Friday, February 7, 2003 7:56 PM CAUTION: Even if the System is unplugged or if the power In AM (MW) broadcast, reception sensitivity will be chang- ed by turning the AM (MW) loop antenna. Turn the AM failure occurs, the preset stations will be stored (MW) loop antenna for best reception. for a few days. However, in case the preset sta- tions are erased, you will need to preset the sta- tions again. Presetting Stations To Change the FM Reception You c
ページ14に含まれる内容の要旨
Body.fm Page 11 Friday, February 14, 2003 3:34 PM
Receiving FM Stations with One of the advantages of the RDS service is that you can locate a particular kind of program by specifying the PTY codes. RDS To search for a program using PTY codes: You can use the RDS (Radio Data System) by using the buttons on On the Unit the Unit or the Remote Control. RDS allows FM stations to send additional signals with their reg- ular program signals. For
ページ15に含まれる内容の要旨
CA_MXKA6.book Page 12 Friday, February 7, 2003 7:56 PM CHILDREN: Entertainment programs for children
#% SOCIAL A: Programs on social activities RELIGION: Programs dealing with any aspect of belief or faith, RDS mode is another convenient RDS service that allows this Unit or the nature of existence or ethics to switch temporarily to a broadcast program of your choice PHONE IN: Programs where people can express their views
ページ16に含まれる内容の要旨
CA_MXKA6.book Page 13 Friday, February 7, 2003 7:56 PM To stop listening to the program selected by RDS mode Press the RDS MODE button. “OFF” appears and the program type (TA, NEWS or INFO) indicator goes off on the display. In RDS standby mode, if you change the source or turn off the power, RDS standby mode is canceled. When the RDS is being operated (i.e. the selected pro- gram type is being received from the broadcast station) and if the DISPLAY MODE or SELECT button i
ページ17に含まれる内容の要旨
CA_MXKA6.book Page 14 Friday, February 7, 2003 7:56 PM Using the CD Player STANDBY/ON Numeric REPEAT keys SLEEP PROGRAM RANDOM AUX CD1-CD3 FM MODE FM /AM CD Open/ Close 0 4 ¢ DISC SKIP SET 7 7 CD1-CD3 CANCEL CD CD1 CD2 CD3 ¡ CD ¢ REPEAT PROGRAM /RANDOM 6 4 22 TAPE TAPE A/B REPEAT CD 6 SELECT RDS MODE DISPLAY MODE PROGRAM SOUND VOLUME MODE /RANDOM ACTIVE SOUND FADE MUTING BASS EX. TURBO Track number, Playing time, Program number, etc. Program indicator RM-SMXKA6R REMOTE CONTROL Disc indicat
ページ18に含まれる内容の要旨
CD-R /RW PLAYBACK CA_MXKA6.book Page 15 Friday, February 7, 2003 7:56 PM ! "#
$ ❏ When you use an 8 cm (3'') CD, place it on the inner circle of the (
) tray. When CD tray has ejected once and then ❏ You can load CDs while listening to the other source or while CD1 is pressed. (DISC1 is selected) listening to the CD being played back. Shows that the disc is rotating. ❏ When power is turned off with the tray opened, the tray is auto- Shows that this matically
ページ19に含まれる内容の要旨
CA_MXKA6.book Page 16 Friday, February 7, 2003 7:56 PM ! "#
$ Removing/changing the CDs during playback While playing back a CD (e.g. CD1), you can remove or change Basics of Using the CD Player- the other CDs (e.g. CD2 and CD3) by pressing the CD Open/Close Normal Play 0 button. After removing or changing, press the same button to close the tray.
$
* Load CDs. 1 During playback (using the 4 or ¢ button): Briefly press the 4 or ¢ button to select the t
ページ20に含まれる内容の要旨
CA_MXKA6.book Page 17 Friday, February 7, 2003 7:56 PM ! "#
$ Repeat steps 3 and 4 to program other tracks 5 Programming the Playing Order on the same CD or the other CD. of the Tracks To play the program, Press the CD 6 but- 6 You can program the playing order of the tracks on all the CDs. ton. Note that you can only make a program when the CD Player is For details, see “To Play the Program You Have Made” men- stopped. tioned below. ❏ You can program up to 32 tracks in any desi
