ページ1に含まれる内容の要旨
E
M
U
MICRO COMPONENT SYSTEM
UX-P30—Consists of CA-UXP30 and SP-UXP30
CD-R/RW PLAYBACK
MICRO COMPONENT SYSTEM UX-P30
SOUND
AHB PRO
STANDBY/ON
+
–
DISPLAY SLEEP
STANDBY
AUX
PROG RANDOM REPEAT CD TAPE
FM/AM AUX
3/8 2 3
SOUND AUTO
FM/AM
MODE PRESET FM MODE
CLOCK TIMER
TAPE 4 7 ¢
CD
CD
REV.MODE
CANCEL MULTI KEY SET
DISPLAY PTY
MODE /EON
REC
AHB
VOLUME PHONES
PRO
RM-SUXP3R REMOTE CONTROL
SP-UXP30 CA-UXP30 SP-UXP30
INSTRUCTIONS
GVT0115-008B
[B]
COVER_UX-P30[B]ff.pm6 3 03.5.7, 1:20 PM
L
O
V
ページ2に含まれる内容の要旨
Warnings, Cautions and Others CAUTION— (standby/on) button! IMPORTANT for the U.K. Disconnect the mains plug to shut the power off completely. DO NOT cut off the mains plug from this equipment. If the plug The (standby/on) button in any position does not disconnect the fitted is not suitable for the power points in your home or the cable mains line. is too short to reach a power point, then obtain an appropriate The power can be remote controlled. safety approved extension lead or consult your
ページ3に含まれる内容の要旨
SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards, but like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. ✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮ Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and inter
ページ4に含まれる内容の要旨
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging the unit from the wall outlet, always pull This manual is organized as follows: on the plug, not the AC power cord. • The manual mainly explains operations using the DO NOT handle the AC power cord w
ページ5に含まれる内容の要旨
Contents Location of the Buttons and Controls ....................... 3 Playing Back Discs (CD/CD-R/CD-RW) ................ 15 Front Panel ................................................................. 3 Playing Back the Entire Disc—Normal Play ........... 15 Remote Control .......................................................... 5 Basic Disc Operations .............................................. 16 Programming the Playing Order of the Tracks —Program Play ...............................
ページ6に含まれる内容の要旨
E M U Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Front Panel Front Panel p CD-R/RW PLAYBACK 1 MICRO COMPONENT SYSTEM UX-P30 SOUND q AHB PRO w 2 e + – 3 STANDBY 4 CD TAPE FM/AM AUX 3/8 2 3 5 r CLOCK TIMER 4 7 ¢ 6 t 7 y REV.MODE u 8 REC i PHONES 9 3 EN01-08_UX-P30[B]f.pm6 3 03.4.18, 4:04 PM L O V
ページ7に含まれる内容の要旨
Continued Display Window 1 2 3 4 5 [ ] DAILY REC SLEEP REC RDS TA NEWS INFO CLOCK PRGM RANDOM ALL BASS SOUND MONOST 68 7 9 pq See pages in the parentheses for details. Front Panel Display Window 1 Disc tray 1 Tape operation indicators 2 Display window •2 3 (tape direction) and (reverse mode) 3 STANDBY lamp (9) 2 Timer indicators 4 (standby/on) button (9, 17, 22) • (timer), DAILY (Daily Timer), REC (Recording 5 Remote sensor Timer), and SLEEP (Sleep Timer) 6 CLOCK button (9) 3 REC indicator 7 TI
ページ8に含まれる内容の要旨
E M U Remote Control See pages in the parentheses for details. 1 REPEAT button (17) 2 DISPLAY button (9) 3 PROG (program) button (16) 4 RANDOM button (17) STANDBY/ON 5 SOUND MODE button (10) 6 AUTO PRESET button (11) 1 r 7 CD 0 (disc tray open/close) button (15) DISPLAY SLEEP Pressing this button also turns on the unit. 2 t 8 CD 3/8 (play/pause) button (9, 15, 16) AUX PROG RANDOM REPEAT Pressing this button also turns on the unit. 3 y 94 (reverse search) button (11, 13, 14, 16 – 18) SOUND AUTO 4
ページ9に含まれる内容の要旨
Continued Getting Started Supplied Accessories Connecting Antennas Make sure that you have all the following items. FM antenna The number in the parentheses indicates the quantity of each piece supplied. • AM loop antenna (1) • FM antenna (1) • Remote control (1) FM antenna (supplied) • Batteries (2) If anything is missing, consult your dealer immediately. Putting the Batteries into the Remote Control Insert the batteries—R6(SUM-3)/AA(15F)—into the remote control, by matching the polarity (+ and
ページ10に含まれる内容の要旨
AM (MW) antenna Connecting Speakers ] ] 1 3 2 ANTENNA Vinyl-covered wire Red RIGHT LEFT (not supplied) MAIN SPEAKERS 1 AM EXT AM LOOP Speaker Speaker SPEAKER IMPEDANCE cord cord MIN 4 Black FM 75 COAXIAL Right speaker Left speaker 2 AM loop antenna 1 Press and hold the clamp of the speaker (supplied) terminal on the rear of the unit. 2 Insert the end of the speaker cord into the 1 Connect the AM loop antenna to the AM terminal. LOOP terminals as illustrated. Match the polarity of the speaker ter
ページ11に含まれる内容の要旨
Connecting Other Equipment You can connect audio equipment—used only as a playback device. • DO NOT connect any equipment while the power is on. • DO NOT plug in any equipment until all connections are complete. To connect audio equipment Be sure that the plugs of the audio cords are colored: White plugs and jacks are for left audio signals, and red ones for right audio signals. AUX RL To audio output Audio equipment For playing the other equipment through this unit, connect between the audio ou
ページ12に含まれる内容の要旨
Common Operations Turning On the Power 4 7 ¢ 2 Press ¢ or 4 to adjust the hour, then When you press the play button—CD 3/8, TAPE 2 3 or press CLOCK. the source selecting button—FM/AM and AUX, the unit automatically turns on and starts playback if the source is The minute digits start flashing ready. on the display. CLOCK To turn on the unit, press STANDBY/ON (or on the unit). CLOCK The STANDBY lamp on the unit goes out. STANDBY STANDBY/ON 3 Press ¢ or 4 to 4 7 ¢ adjust the minute, then press C
ページ13に含まれる内容の要旨
E M U Adjusting the Volume Selecting the Sound Modes You can adjust the volume level only while the unit is turned You can select one of the 4 preset sound modes. This function on. The volume level can be adjusted between “VOLUME 0” only affects the playback sound, but does not affect your and “VOLUME 40.” recording. SOUND When using the remote control, press – VOLUME + To select the sound modes, press MODE VOLUME + to increase the volume or SOUND MODE (or SOUND on the unit) press VOLUME – to de
ページ14に含まれる内容の要旨
Listening to FM and AM (MW) Broadcasts Tuning in a Station Presetting Stations You can preset 30 FM and 15 AM (MW) stations—using FM/AM 1 Press FM/AM. either automatic presetting or manual presetting. The unit automatically turns on and In some cases, test frequencies have been already memorized tunes in the previously tuned for the tuner since the factory examined the tuner preset station—either FM or AM (MW). function before shipment. This is not a malfunction. You can • Each time you press th
ページ15に含まれる内容の要旨
To preset stations manually—Manual Presetting Tuning in a Preset Station • There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 On the remote control ONLY: again. FM/AM On the remote control ONLY: 1 Press FM/AM. The unit automatically turns on and tunes in 1 Tune in the station you want to preset. the previously tuned station—either FM or AM (MW). • See “Tuning in a Station” on page 11. SET • Each time you press the button, the band
ページ16に含まれる内容の要旨
Receiving FM Stations with RDS RDS (Radio Data System) allows FM stations to send an Searching for Programs by PTY Codes additional signal along with their regular program signals. (PTY Search) For example, the stations send their station names, as well as information about what type of program they broadcast, such One of the advantages of RDS is that you can locate a as sports or music, etc. particular kind of program by specifying the PTY codes. When tuned to an FM station which provides the R
ページ17に含まれる内容の要旨
Switching Temporarily to a Program Type of How the Enhanced Other Networks function actually Your Choice works: The Enhanced Other Networks function allows the unit to CASE 1 switch temporarily to a broadcast program of your choice If there is no station broadcasting the program you (TA, NEWS, and INFO) from a different station. have selected • The function only works when you are listening to a preset The unit continues tuning in the current station. FM RDS stations providing the data. « To act
ページ18に含まれる内容の要旨
Playing Back Discs (CD/CD-R/CD-RW) This unit has been designed to playback the following Playing Back the Entire Disc—Normal Play discs—CD, CD-R, and CD-RW. CD Continued use of irregular shape discs 1 Press CD 0 (or 0 on the unit). (heart-shape, octagonal, etc.) can damage the The unit automatically turns on and the unit. disc tray comes out. General Notes In general, you will have the best performance by keeping 2 Place a disc correctly on the circle of your discs and the mechanism clean. the d
ページ19に含まれる内容の要旨
Continued Basic Disc Operations 3 Press MULTI KEY > or MULTI KEY < to select the track number, then press SET. While playing a disc, you can do the following operations. MULTI KEY SET To stop play for a moment Press CD 3/8. CD While pausing, the elapsed playing time flashes on the display. To resume playing, press CD 3/8 again. PRGM To go to another track Track number Program step number MULTI KEY Press MULTI KEY > / MULTI KEY < or ¢ / 4 repeatedly before or during 4 Repeat step 3 to program oth
ページ20に含まれる内容の要旨
Playing at Random—Random Play Prohibiting Disc Ejection—Tray Lock The tracks will play in no particular order when you use this You can lock the disc tray and prohibit to eject the disc. mode. • This is possible only while the unit is turned on. On the remote control ONLY: On the unit ONLY: RANDOM To use Random play mode, press RANDOM 7 before or during playing. To prohibit disc ejection, press (standby/on) The RANDOM indicator lights up on the display. while holding 7. (If the disc tray is ope
