ページ1に含まれる内容の要旨
COMPACT COMPONENT SYSTEM
SISTEMAS DE COMPONENTES COMPACTOS
SISTEMA DE COMPONENTE COMPACTO
CA-D702T
COMPACT
DIGITAL AUDIO
PROGRAM
/RANDOM
DISC
REPEAT
DISC
EDIT
DISC
FM AM
PRO LOGIC 3CH LOGIC TEST TONE SHIFT
–+ CENTER
LEVEL CENTER MODE SLEEP
REAR SOUND
–+ LEVEL DELAY TIME MODE
FM MODE
L BALANCE R ECHO S.A.BASS
TAPE A TAPE B DIRECTION REPEAT
DISC 1 DISC 2 DISC 3
CD CONTROL TAPE CONTROL
AUX REC PAUSE
+
VOLUME
–
RM-SED752TRU REMOTE CONTROL
INSTRUCTIONS
MANUAL DE INSTRUCCIONES
INSTRUÇÕES
For Custo
ページ2に含まれる内容の要旨
Warnings, Cautions and Others Avisos, precauciones y otras notas Advertências, precauções e outras notas Caution –– switch! IMPORTANT for the U.K. Disconnect the mains plug to shut the power off completely. The DO NOT cut off the mains plug from this equipment. If the switch in any position does not disconnect the mains line. The power plug fitted is not suitable for the power points in your home can be remote controlled. or the cable is too short to reach a power point, then obtain an appropr
ページ3に含まれる内容の要旨
IMPORTANT FOR LASER PRODUCTS / IMPORTANTE PARA PRODUCTOS LÁSER / IMPOTANTE PARA PRODUTOS LASER / / REPRODUCTION OF LABELS / REPRODUCCIÓN DE ETIQUETAS / REPRODUÇÃO DE ETIQUETAS / 1 CLASSIFICATION LABEL, PLACED ON REAR ENCLO- 2 WARNING LABEL, PLACED INSIDE THE UNIT SURE 1 ETIQUETA DE CLASIFICACIÓN, PEGADA EN LA PARTE 2 ETIQUETA DE ADVERTENCIA, PEGADA EN EL INTE- RIOR DE LA UNIDAD POSTERIOR DE LA CAJA 1 ETIQUETA DE CLASSIFICAÇÃO LOCALIZADA NA PARTE 2 ETIQUETA DE ADVERTÊNCIA
ページ4に含まれる内容の要旨
Caution: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1 Front: No obstructions and open spacing. 2 Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below. 3 Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more. Precaución: el aparato debe estar bien ventilado Para evitar posibles riesgos de descargas eléct
ページ5に含まれる内容の要旨
Thank you for purchasing the JVC Compact Component System. We hope it will be a valued addition to your home, giving you years of enjoyment. Be sure to read this instruction manual carefully before operating your new stereo system. Here you will find all the information you need to set up and use the system. For questions that are not be answered in the manual, contact your dealer. Features Here are some of the things that make your System powerful and easy to use. Easy operation The controls an
ページ6に含まれる内容の要旨
Table of Contents Features...................................................................... 1 Fast Forward / Reverse ....................................... 22 How This Manual Is Organized................................. 1 Changing Discs While Playing........................... 22 IMPORTANT PRECAUTIONS ................................ 1 Programing the Playing Order of the Tracks ........... 23 Checking the Program ........................................ 24 Getting Started ................
ページ7に含まれる内容の要旨
Getting Started Accessories Check that you have all of the following items, which are supplied with the System. AM Loop Antenna (1) Remote Control (1) Batteries (2) FM Wire Antenna (1) AC Plug Adaptor (except for Argentina) (1) If any of these items is missing, contact your dealer immediately. Setting the VOLTAGE SELECTOR Switch To avoid damaging the System, set the voltage before plugging in the Unit. Set the correct voltage for your area with the VOLTAGE SELECTOR switch on the back panel of th
ページ8に含まれる内容の要旨
CAUTION: Make all connections before plugging the Unit into an AC power outlet. Connecting the FM Antenna Using the Supplied Wire Antenna Extend the supplied FM Wire Antenna horizontally. FM Wire Antenna Using an FM 75-Ohm Antenna Cable (not supplied) If reception is poor, connect the outside antenna. Outside FM Antenna Wire 2 13 Before attaching a 75-ohm coaxial lead (the kind with a round wire going to an outside antenna), disconnect the supplied FM Wire Antenna. CAUTION: To avoid noise, keep
ページ9に含まれる内容の要旨
CAUTION: Make all connections before plugging the Unit into an AC power outlet. Connecting the Speakers Refer to instructions for speakers as well when you connect speakers. For each speaker, connect one end of the speaker wires to the speaker terminals on the back of the System. 1. Open each of the terminals and insert the speaker wires firmly, then close the terminals. 2. Connect the red (+) and black (–) terminals of the right side speaker to the red (+) and black (–) terminals marked RIGHT o
ページ10に含まれる内容の要旨
Connecting Auxiliary Equipment VCR or other equipment To listen to this source, press AUX. AUX RIGHT LEFT Now you can plug the AC power cord into the wall outlet, and your System is at your command! COMPU PLAY COMPU PLAY is JVC’s feature that lets you control the most frequently used functions of the System with a single touch. One Touch Operation starts playing a CD, turns on the radio, plays a tape, etc. with a single press of the play button for that function. What One Touch Operation does fo
ページ11に含まれる内容の要旨
Common Operations PROGRAM
/RANDOM SET DISC REPEAT DISC EDIT MULTI CONTROL DISC STANDBY indicator SOUND MODE TIMER/CLOCK PHONES SEA CONTROL CANCEL/DEMO S.A. BASS VOLUME AUX Display FM AM PRO LOGIC 3CH LOGIC TEST TONE SHIFT SHIFT CENTER –+ CENTER MODE LEVEL SLEEP SOUND MODE indicator SOUND
REAR LEVEL REAR –+ DELAY TIME LEVEL MODE SOUND MODE –, + FM MODE
L BALANCE R S.A.BASS / ECHO S.A. BASS TAPE A TAPE B DIRECTION REPEAT BALANCE L, R DISC 1 DISC 2 DISC 3 CD CONTROL TAPE CONTROL AUX REC PAUS
ページ12に含まれる内容の要旨
Setting the Clock Before operating the unit, set the correct time. 1 You can set the clock whether the Unit is on or off. 1. Press TIMER/CLOCK. The hour digits begin flashing. Flashing 2. Press 4 P. DOWN or ¢ P. UP on 2 , 4 the MULTI CONTROL to set the hours. Press ¢ P. UP to increase the hour. Press 4 P. DOWN to decrease the hour. Holding down continuously changes the hour setting more rapidly. 3. Press SET. The minute digits begin flashing. Flashing 3 , 5 4. Press 4 P. DOWN or ¢ P. UP on the
ページ13に含まれる内容の要旨
CAUTION: The Volume cannot be adjusted while the Unit is on STANDBY. DO NOT turn on the Unit and/or start playing any source without setting the VOLUME control to 0; otherwise, the sudden blast of sound can damage your hearing, speakers and/or headphones. For private listening Connect a pair of headphones to the PHONES jack. No sound comes out of the speakers. Be sure to turn down the volume before connecting or putting on headphones. Balance Adjustment ———————————————————— You can use the Remot
ページ14に含まれる内容の要旨
Sound Modes The System has some preset sound effects that give you control of the way your music sounds, so you can tailor it for your room and for the quality of the source. We can give you some idea of how each one affects the music, but the only way to really tell is to try them yourself. You can also create up to three of your own customized S.E.A. (Sound Effect Amplifier) settings and store them in the Unit’s memory (MANUAL 1, MANUAL 2, MANUAL 3). The preset sound modes include modes using
ページ15に含まれる内容の要旨
3. Use MULTI CONTROL to adjust to any Sound Mode desired. Press 4 P. DOWN or ¢ P. UP on the MULTI CONTROL to select the tone range you want to adjust. You can adjust “LOW”, “MID” or “HIGH” tone. Flashing Flashing Flashing Press TUNING DOWN 1 or Á TUNING UP on the MULTI CONTROL to adjust the level. The level can be adjusted between –3 and +3 in 7 steps. 4. Press SET. “MANUAL 1” appears on the display. 5. Press 4 P. DOWN or ¢ P. UP on the MULTI CONTROL to select the MANUAL number for the memory.
ページ16に含まれる内容の要旨
Listening to Auxiliary Equipment By playing the sound from auxiliary equipment through the System, you can gain control over how the music or program sounds. Once the connected equipment is playing through the System, you can apply the sound effects. First make sure that the auxiliary equipment is properly connected to the System. (See page 6). 1. Turn down the volume level to 0. 2. Press AUX. “AUX” appears on the display. The AUX button on the Unit lights up. or AUX COMPU PLAY When AUX is press
ページ17に含まれる内容の要旨
Dolby Surround PROGRAM
/RANDOM DISC REPEAT DISC EDIT DISC PRO LOGIC / 3CH LOGIC Operation keys FM AM PRO LOGIC 3CH LOGIC TEST TONE SHIFT SHIFT CENTER –+ LEVEL CENTER MODE SLEEP REAR SOUND
–+ LEVEL DELAY TIME MODE Display FM MODE
L BALANCE R / ECHO S.A.BASS Dolby Surround indicator TAPE A TAPE B DIRECTION REPEAT DISC 1 DISC 2 DISC 3 CD CONTROL TAPE CONTROL AUX REC PAUSE + VOLUME – RM-SED702TXU REMOTE CONTROL When the System is being used, the display shows other items as well. However, we
ページ18に含まれる内容の要旨
Preparing the Dolby Surround To use the Dolby Surround effects, you need to prepare the various settings. These settings are set using the Remote Control. The Dolby Surround settings are: Center Speaker Mode Center Speaker mode contains the following four settings. PHANTOM: Select this setting if you have not connected a center speaker. The left and right front speakers project the sound to give the effect of a center speaker. (PRO LOGIC only) NORMAL: Select this setting if you are using a small
ページ19に含まれる内容の要旨
Getting Ready to Use Dolby Pro Logic Speaker Arrangements for Dolby Pro Logic———————— Layout when using the center speaker and Layout when using the rear speakers rear speakers TV TV Front Front Front Front Speaker Speaker Speaker Speaker Center Speaker Rear Rear Rear Rear Speaker Speaker Speaker Speaker Setting-up Dolby Pro Logic ———————————————— 1. Press PRO LOGIC/3CH LOGIC to select PRO LOGIC. Each time you press the button, Dolby Surround programs change as follows: = PRO LOGIC = 3CH LOGIC =
ページ20に含まれる内容の要旨
\ Getting Ready to Use Dolby 3 Channel Logic Speaker Arrangements for Dolby 3 Channel Logic ———— TV Front Front Speaker Speaker Center Speaker Setting-up Dolby 3ch Logic ———————————————— 1. Press PRO LOGIC/3CH LOGIC to select 3CH LOGIC. Each time you press the button, Dolby Surround programs change as follows: = PRO LOGIC = 3CH LOGIC = OFF = (back to the beginning) or 3CH LOGIC SHIFT When using the Remote Control, press SHIFT then press the 3CH LOGIC (2). • Perform the steps below using the butt
