ページ1に含まれる内容の要旨
COMPACT COMPONENT SYSTEM
CA-MXDVA9R
CA-MXDVA9
CA-MXDVA9R
CA-MXDVA9 for Australia
CA-MXDVA9 for all
except Australia
INSTRUCTIONS
For Customer Use:
Enter below the Model No. and Serial
No. which are located either on the rear,
bottom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
GVT0057-008A
[A, B, UJ]
CA-MXDVA9&9R[A,B,UJ]COVER_1 1 01.8.9, 10:50 AM
ページ2に含まれる内容の要旨
Warnings, Cautions and Others IMPORTANT FOR LASER PRODUCTS IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug REPRODUCTION OF LABELS fitted is not suitable for the power points in your home or the 1 CLASSIFICATION LABEL, PLACED ON REAR ENCLOSURE cable is too short to reach a power point, then obtain an appro- priate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. CLAS
ページ3に含まれる内容の要旨
SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and inter
ページ4に含まれる内容の要旨
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging from the wall outlet, always pull the This manual is organized as follows: plug, not the AC power cord. • The manual mainly explains operations using the DO NOT handle the AC power cord with wet hand
ページ5に含まれる内容の要旨
Contents Location of the Buttons and Controls ....................... 3 Selecting Playback Modes ........................................ 25 Front Panel ................................................................. 3 Programming the Playing Order of the Titles and Remote Control .......................................................... 5 Tracks—Program Play ....................................... 25 Playing at Random—Random Play ......................... 27 Getting Started..................
ページ6に含まれる内容の要旨
Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Front Panel Front Panel 1 2 3 ; 4 a 5 s 6 d f g 7 8 h 9 j p k q l w / e r z t x y u c i v o – 3 – EN01-10.CA-MXDVA9&9R[A,B,UJ]_1 3 01.8.6, 7:42 PM
ページ7に含まれる内容の要旨
Continued Display Window 1 2 3 5 6 7 8 9 4 p q w e r See pages in the parentheses for details. f SOUND MODE control (13) g DOLBY DIGITAL lamp (18, 21) Front Panel PRO LOGIC lamp (37) 1 Disc trays SURROUND lamp (32) 2 STANDBY/ON button and STANDBY lamp h SUBWOOFER LEVEL + / – control (13) (11, 12, 43, 44) j TUNING + / – buttons (15) 3 Remote sensor 1 / Á (fast reverse/fast forward) buttons (14, 23, 31) 4 ECO button (11): Only for England and Australia k VOLUME + / – control (12) 5 PRESET + / – c
ページ8に含まれる内容の要旨
Remote Control Remote Control 1 FM/AM button (12, 15) Pressing this button also turns on the unit. FM MODE button* (15) 2 AUX button (12) y Pressing this button also turns on the unit. 1 u PTY/EON button* (16, 17): Only for CA-MXDVA9R 2 i 3 SUBTITLE button (19) 3 4 DISPLAY button (16, 19, 21, 23, 50) o 4 5 Number buttons (15, 21 – 23, 26, 41) Disc number buttons* (DVD 1, DVD 2, and DVD 3) 5 (20, 22, 26, 27) ANGLE button* (19) DIGEST button* (30) ZOOM button* (29) ; AUDIO button* (19) a 6 THEATER
ページ9に含まれる内容の要旨
Getting Started Continued Supplied Accessories Connecting Antennas Make sure that you have all the following items. FM antenna The number in the parentheses indicates the quantity of the pieces supplied. • AM loop antenna (1) FM antenna (supplied) • FM antenna (1) • Remote control (1) • Batteries (2) • Composite video cord (1): Only for CA-MXDVA9 • AC plug adaptor (1): Only for CA-MXDVA9 except Australia If anything is missing, consult your dealer immediately. 1 Attach the FM antenna to the FM 7
ページ10に含まれる内容の要旨
AM antenna Connecting Speakers IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit. To connect front speakers ANTENNA Vinyl-covered wire 1 3 (not supplied) 1 AM EXT AM LOOP 2 Red FM 75 COAXIAL Speaker cords Speaker cords FRONT SUBWOOFERS (red/black) (red/black) RIGHT LEFT Black Black 2 RIGHT LEFT MAIN AM loop antenna SPEAKERS (supplied) CAUTION: SPEAKER IMPEDANCE 616 Blue 1 Connect the AM loop antenna to the AM LOOP terminals
ページ11に含まれる内容の要旨
Continued To connect a center speaker and rear speakers By connecting a center speaker and rear speakers to the SURROUND SPEAKERS jacks, you can enjoy Dolby Digital and MPEG multichannel sound, and the DSP Center speaker Surround modes. (See page 32.) Right Left front speaker front speaker Center Subwoofer speaker 30˚ 30˚ SURROUND SPEAKERS CENTER REAR 90˚ 90˚ Left rear Right rear speaker speaker RIGHT LEFT CAUTION: SPEAKER IMPEDANCE 16 32 Connecting Other Equipment Right rear Left rear speaker s
ページ12に含まれる内容の要旨
To connect audio equipment with an optical digital To connect a TV input terminal—such as digital decoder For CA-MXDVA9R: You can connect a digital decoder such as an MD recorder or Connect your TV to the AV OUT terminal using a SCART a CD recorder by using an optical digital cord (not supplied). cable (not supplied). Set the Y/C-COMP. switch and select • See also “About sounds output through the rear terminals.” the signal output mode correctly according to your TV. • AV OUT terminal is only fo
ページ13に含まれる内容の要旨
For CA-MXDVA9: Now, you can plug the AC power cord. Connect your TV and this unit using the composite video cord (supplied) or an S-video cord (not supplied). When connecting the AC power cord into a wall outlet, the • You can also use JVC’s AV COMPU LINK control system. unit automatically starts display demonstration. (See page 46.) • Only for CA-MXDVA9 except Australia: If the wall outlet does not match the AC plug, use the VIDEO OUT supplied AC plug adaptor. VIDEO IMPORTANT: Be sure to check
ページ14に含まれる内容の要旨
Common Operations Turning On or Off the Power Setting the Clock STANDBY/ON To turn on the unit, press Before operating the unit any further, first set the clock built STANDBY/ON so that the in this unit. You can set the clock whether the unit is on or STANDBY STANDBY lamp goes off. off. On the unit ONLY: 1 Press CLOCK/TIMER. The hour digits start flashing on the display. STANDBY/ON To turn off the unit (on standby), press STANDBY/ON again so that the STANDBY STANDBY lamp lights up. • The clock
ページ15に含まれる内容の要旨
Continued Adjusting the Volume Setting the AM Tuner Interval Spacing You can adjust the volume level only while the unit is turned Only for CA-MXDVA9 except Australia: on. The volume level can be adjusted in 32 steps (VOL MIN, Some countries space AM stations 9 kHz apart, and some VOL 01—VOL 30, and VOL MAX). countries use 10 kHz spacing. • When shipped, the unit is set to 10 kHz interval. Turn VOLUME + / – clockwise (+) to increase the volume or On the unit ONLY: counterclockwise (–) to decreas
ページ16に含まれる内容の要旨
D.CLUB*: Increases resonance and bass. Reinforcing the Bass Sound HALL*: Adds depth and brilliance to the sound. You can select one of the 4 subwoofer levels. This function STADIUM*: Adds clarity and spreads the sound, like in an only affects the playback sound, but does not affect your outdoor stadium. recording. The subwoofer level can be adjusted in 4 steps— SEA (Sound Effect Amplifier) modes: LEVEL 1, LEVEL 2, LEVEL 3, and LEVEL 4 (MAX ROCK: Boosts low and high frequency. Good for LEVEL). ac
ページ17に含まれる内容の要旨
Creating Your Own Sound Modes 4 Press SET again. —Manual Mode You can create SEA patterns to suit your preference. These changed settings can be stored in the MANUAL 1, MANUAL 2, and MANUAL 3 modes. • There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again. 5 Turn 4 / ¢ to select one On the unit ONLY: of the MANUAL 1, MANUAL 2, and MANUAL 3 1 Select one of the preset sound modes. modes into which you want to • If you want to add
ページ18に含まれる内容の要旨
Listening to FM and AM Broadcasts On the unit ONLY: Tuning into a Station 1 Tune into the station you want to preset. 1 Press FM/AM. • See “Tuning into a Station.” The unit automatically turns on and tunes into the previously received 2 Press SET. station (either FM or AM). • Each time you press the button, the band alternates between FM and AM. 2 Start searching for stations. On the unit: 3 Turn PRESET + / – to select a Press and hold TUNING + or – preset number. for more than 1 second. On the
ページ19に含まれる内容の要旨
Receiving FM Stations with RDS —Only for CA-MXDVA9R Continued RDS (Radio Data System) allows FM stations to send an To search for a program using the PTY codes additional signal along with their regular program signals. REMEMBER you must preset FM RDS stations to use the For example, the stations send their station names, as well as PTY codes. If not yet done, see page 15. information about what type of program they broadcast, such • There is a time limit in doing the following steps. If the as
ページ20に含まれる内容の要旨
Switching to a Program Type of Your Choice How the EON function actually works: Temporarily CASE 1 By receiving EON (Enhanced Other Networks) data sent by If there is no station broadcasting the program you FM RDS stations, the EON function allows the unit to switch have selected temporarily to a broadcast program of your choice (TA, The unit continues tuning in the current station. NEWS, or INFO) from a different station. Ç • The EON function only works when you are listening to a When a statio
