ページ1に含まれる内容の要旨
MICRO COMPONENT MD SYSTEM
CA-UXJ55MD
REV.MODE
STANDBY/ON
AUTO REVERSE
AHB PRO
MICRO COMPONENT MD SYSTEM UX-J55MD
STANDBY/ON DISC LOADING MECHANISM
12 3 VOLUME
4 DOWN 7 ¢ UP MD REC
DISP/CHARA +
45 6
DISC
CANCEL
SELECT 0 0 AUX/DVD
78 9
‹/8 ‹/8 ¤‹
SET
FM/AM
CD MD TAPE
10 0 +10
TITLE/EDIT DISC UP ENTER
CD10 CD20 CD30 CD40 CD50
–
GROUP SKIP GROUP SKIP
GROUP TITLE TITLE SEARCH
DISC DOWN
/EDIT
FM/AM
CD MD TAPE /AUX
6 6 23
GROUP REC REC REC CD REC
ON/OFF TIME SPEED MODE
MD TAPE MD&TAPE FM
REC REC REC
ページ2に含まれる内容の要旨
Warnings, Cautions and Others CAUTION— button! Disconnect the mains plug to shut the power off completely (the STANDBY/ON lamp goes off). The button in any position does not disconnect the mains line. • When the unit is on standby, the STANDBY/ON lamp lights red. • When the unit is turned on, the STANDBY/ON lamp lights green. The power can be remote controlled. CAUTION To reduce the risk of electrical shocks, fire, etc.: 1. Do not remove screws, covers or cabinet. 2. Do not expose this applianc
ページ3に含まれる内容の要旨
IMPORTANT FOR LASER PRODUCTS REPRODUCTION OF LABELS / 1 CLASSIFICATION LABEL ON EXTERIOR SURFACE 2 WARNING LABEL INSIDE THE UNIT DANGER: Invisible laser VARNING: Osynlig laser- radiation when open and strålning när denna del är interlock failed or defeated. öppnad och spärren är AVOID DIRECT EXPOSURE urkopplad. Betrakta ej TO BEAM. (e) strålen. (s) CLASS 1 ADVARSEL : Usynlig laser- VARO : Avattaessa ja suo- LASER PRODUCT stråling
ページ4に含まれる内容の要旨
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging the unit from the wall outlet, always pull This manual is organized as follows: on the plug, not the AC power cord. • This manual mainly explains operations using the buttons on the remote control. D
ページ5に含まれる内容の要旨
Contents Location of the Buttons and Controls ..................... 3 Recording on MDs .................................................... 28 Front Panel .................................................................... 3 Before You Start Recording on an MD ......................... 28 Remote Control ............................................................. 5 Setting MD Recording Modes ...................................... 30 Recording CD onto an MD Getting Started......................
ページ6に含まれる内容の要旨
Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Front Panel REV.MODE STANDBY/ON e 1 AUTO REVERSE AHB PRO r 2 3 MICRO COMPONENT MD SYSTEM UX-J55MD t 4 y 5 DISC LOADING MECHANISM 6 u VOLUME MD REC 4 DOWN 7 ¢ UP + 7 i DISC SELECT 0 0 AUX/DVD 8 ‹/8 ‹/8 ¤‹ o FM/AM 9 CD MD TAPE ; p CD10 CD20 CD30 CD40 CD50 – a q 5-CD 5-CD CHANGER, PLAY&EXCHANGE PHONES w Front panel See pages in parentheses for details. 1 (standby/on) button and STANDBY/ON lamp q Disc
ページ7に含まれる内容の要旨
Continued Display window on the front panel C D REC DAILY SP 1 DISC PRGM MD TAPE ALL A - B RANDOM AHBPRO SLEEP STEREO 1 2 3 4 5 REC LP24 REC GROUP TITLE SEARCH AUTO STANDBY MONO x124 5 GROUP Display window See pages in parentheses for details. REV.MODE STANDBY/ON AUTO REVERSE AHB PRO 1 CD operation indicators (15, 17 – 19, 34, 36) • CD indicator • Disc tray indicators MICRO COMPONENT MD SYSTEM UX-J55MD 2 MD operation indicators (20 – 25, 31, 32, 36, 39 – 45, 47 – 50, 52, 53) • MD indicator • R
ページ8に含まれる内容の要旨
Remote Control See pages in parentheses for details. 1 Number buttons • 1 – 10, 0 and +10 buttons (9, 14, 17, 21, 22, 25, 39 – 41, 47 – 50, 52, 55 – 57) • Character entry buttons (A – Z, 0 – 9) (25, 52) • MARK button (25, 52) STANDBY/ON • and buttons (25, 47, 51 – 53) 2 TITLE/EDIT button (47 – 52) t 12 3 3 DISC UP button (15 – 17, 30, 34, 56) DISP/CHARA y 45 6 4 Multi operation buttons 1 CANCEL (9, 13 – 26, 31, 32, 34 – 36, 39 – 45, 47 – 50, 54 – 57) u 78 9 •4 (reverse), ¢ (fast-forward), GROU
ページ9に含まれる内容の要旨
Getting Started Continued To connect an outdoor FM antenna Unpacking Before connecting it, disconnect the supplied FM antenna. After unpacking, be sure that you have all the following items. The number in parentheses indicates the quantity of each piece supplied. Outdoor FM antenna (not supplied) • FM antenna (1) • AM loop antenna (1) • Remote control (1) Coaxial cable (not supplied) • Batteries (2) If any item is missing, consult your dealer immediately. Connecting Antennas FM antenna FM anten
ページ10に含まれる内容の要旨
AM antenna Connecting Speakers To connect speakers 1 You can connect the speakers using the speaker cords. 1 2 2 3,4 ANTENNA SPEAKERS Red RIGHT LEFT Vinyl-covered wire (not supplied) Speaker Speaker cord cord SPEAKER IMPEDANCE 3 4Ω ~ 16Ω Black AM loop antenna (supplied) Right speaker Left speaker 1 If the cords are covered with insulation, remove 1 If the cords are covered with insulation, remove a short section of insulation at the end of each a short section of insulation at the end of each
ページ11に含まれる内容の要旨
Connecting External Equipment Putting the Batteries into the Remote Control You can connect other equipment which can be used as a playback device. Insert the batteries—R6S(SUM-3)/AA(15F)—into the remote When you connect and use the equipment, refer also to its control by matching the polarity (+ and –) on the batteries manual supplied. with the + and – marking on the battery compartment. When the remote control can no longer operate the unit, • DO NOT connect any equipment while the replace bot
ページ12に含まれる内容の要旨
Basic and Common Operations To change the clock again Setting the Clock On the remote control ONLY: Before operating the unit any further, first set the built-in CLOCK/ Press CLOCK/TIMER repeatedly until the TIMER clock. When you plug in the power cord, “0:00” starts clock setting screen appears on the display. flashing on the display. The hour digit starts flashing. Then, perform You can set the clock when the unit is either turned on or on steps 2 and 3 in “Setting the Clock” again. standby (o
ページ13に含まれる内容の要旨
Continued To turn off the clock indication (Power Save) When you unplug the AC power cord or if a power On the remote control ONLY: failure occurs The clock is reset to “0:00” right away, while the tuner preset stations will be DISP/CHARA Press DISP/CHARA while the unit is on erased in a few days. standby (off). “DISPLAY OFF” appears on the display for a while, then the clock indication goes off. To turn off the unit automatically (Auto Standby) Using Auto Standby, the unit automatically turns
ページ14に含まれる内容の要旨
Adjusting the Volume Level Reinforcing the Bass Sound You can adjust the volume level only while the unit is turned The richness and fullness of the bass sound is clearly on. The volume level can be adjusted between “VOLUME 0” maintained regardless of how low you set the volume level – “VOLUME 40.” —Active Hyper Bass Pro. • The volume level has no effect on recording. • This function only affects the playback sound, and does not affect your recording. On the remote control: • This function also
ページ15に含まれる内容の要旨
Adjusting the Tone Changing the Display Brightness You can adjust the bass level (low frequency range) and the You can change the display brightness only while the unit is treble level (high frequency range) within a range of “–5” to turned on. “+5” only while the unit is turned on. • This function only affects the playback sound, and does not On the remote control ONLY: affect your recording. DIMMER Press DIMMER while the unit is turned on. • This function also affects the sound from headphones
ページ16に含まれる内容の要旨
Listening to FM and AM Broadcasts Setting the AM Tuner Interval Spacing 2 Press and hold ¢ or 4 for more than 1 second. Some countries AM channel intervals are set to 9 kHz apart, GROUP SKIP GROUP SKIP and some countries use 10 kHz apart. 4 DOWN ¢ UP When shipped, the built-in AM tuner is set to 9 kHz spacing. You can change the channel interval to 9 kHz or 10 kHz spacing. (On the remote control) (On the unit) On the unit ONLY: •¢: Increases the frequencies. To set the AM tuner to the 10 kHz spa
ページ17に含まれる内容の要旨
Presetting Stations When you unplug the AC power cord or if a power failure occurs You can preset 30 FM and 15 AM stations manually. The FM and AM preset stations will be erased in a few days. If this happens, preset the stations again. In some cases, test frequencies have been already stored for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction. You can Tuning in to a Preset Station preset the stations you want into memory by following the
ページ18に含まれる内容の要旨
Playing Back Discs on the 5-CD Changer This unit has been designed to play back the following 3 Press the same disc eject button (CD10 – discs—CD, CD-R, and CD-RW. CD50) you have pressed in step 1. The disc tray closes. When playing a CD-R or CD-RW CD10 CD20 CD30 CD40 CD50 User-edited CD-Rs (CD-Recordable) and CD-RWs (CD- ReWritable) can be played only if they are already “finalized.” • Usually you can play back your original CD-Rs or CD- RWs recorded in audio CD format. However, sometimes When
ページ19に含まれる内容の要旨
Continued To resume play, press CD 6 again. Basic Disc Operations To stop during play, press 7. To change a disc during playback of another disc On the unit ONLY: To remove discs, press the corresponding disc eject buttons Press one of the disc eject buttons (CD10 – CD50) to (CD10 – CD50) on the unit. eject one of the disc trays which is not playing currently. CD10 CD20 CD30 CD40 CD50 Disc playback sequence in the 5-CD changer When 5 discs are loaded on the disc trays*, they are played in the f
ページ20に含まれる内容の要旨
• Program Play can only function when all disc trays are To go to another track directly using the number closed. buttons • If a program has been stored in memory, the program is On the remote control ONLY: called up. • Once the PRGM indicator lights, you cannot change a Pressing the number button(s) allows disc. you to start playing the track number 12 3 on the current disc. DISC UP 3 Press DISC UP or DISC Ex.: For track number 5, press 5. 45 6 DOWN to select the disc For track number 15, pre
