ページ1に含まれる内容の要旨
MICRO COMPONENT SYSTEM
–Consists of CA-UXHB4 and SP-UXHB4
UX-HB4
INSTRUCTIONS
LVT1266-001A
[B]
UX-HB4[B]cover2.p65 1 04.8.5, 4:02 PM
ページ2に含まれる内容の要旨
Warnings, Cautions and Others CAUTION— (STANDBY/ON) button! IMPORTANT for the U.K. Disconnect the mains plug to shut the power off completely (all lamps DO NOT cut off the mains plug from this equipment. If the plug and indications go off). The (STANDBY/ON) button in any fitted is not suitable for the power points in your home or the cable position does not disconnect the mains line. is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your d
ページ3に含まれる内容の要旨
SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards, but like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. ✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮ Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and inter
ページ4に含まれる内容の要旨
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging the unit from the wall outlet, always pull This manual is organized as follows: on the plug, not the AC power cord. • This manual mainly explains operations using the DO NOT handle the AC power cord
ページ5に含まれる内容の要旨
Contents Location of the Buttons and Controls ....................... 3 Listening to FM and AM (MW) Broadcasts .......... 21 Main Unit............................................................................... 3 Tuning in to a Station .......................................................... 21 Remote Control ..................................................................... 5 Presetting Stations ............................................................... 21 Tuning in to a Preset Sta
ページ6に含まれる内容の要旨
Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Main Unit Top view 1 COMPACT DIGITAL AUDIO OPEN 2 DAILY TIMER/SNOOZE 3 Front view q 4 5 STANDBY VOLUME 6 – + CD TAPE FM/AM/DAB AUX 7 w #/8 PHONES SCROLL DOWN SELECT SCROLL UP AUX 4 7¢ REC 8 e r PUSH OPEN 9 AUTO REVERSE t p UX-HB4 MICRO COMPONENT SYSTEM 3 01-05_UX-HB4[B]6.p65 3 04.8.5, 6:16 PM
ページ7に含まれる内容の要旨
Continued Display window 12 34567 8 9p q w e r 8 tyu See pages in parentheses for details. Main unit Display window 1 Disc cover (12) 1 Repeat indicators 2) OPEN (disc cover open) (12) • , ALL, GR. (group) 3 DAILY TIMER/SNOOZE button (28) 2 REC indicators 4 Remote sensor (5) • (recording), (recording timer) 5 STANDBY lamp (10) 3 MP3 indicator 6 (STANDBY/ON) button (10) 4 ST. (stereo) indicator 7 Source buttons 5 (sleep timer) indicator • CD #¥8, TAPE ¤‹, FM/AM/DAB, AUX 6 BASS indicator Pressin
ページ8に含まれる内容の要旨
Remote Control See pages in parentheses for details. 1 STANDBY/ON button (10, 28) 2 SLEEP button (29) 3 TIMER button (27) 4 SET button (9, 27, 28) 5 CANCEL button (27, 28) e 6 REV. (reverse) MODE button (16, 25, 26) STANDBY/ON CLOCK DISPLAY A. STANDBY 7 Source buttons r 1 • CD 3¥8, TAPE 2 3, FM/AM/DAB, AUX t SLEEP Pressing one of these buttons also turns on the unit. 123 2 8 PROGRAM button (14, 18, 21) TIMER 9 RANDOM button (15) 456 3 y p Multi control buttons SET • UP/PRESET GROUP , DOWN/PRES
ページ9に含まれる内容の要旨
Do not connect the AC power cord until all other Getting Started connections have been made. Continued 1 Put the DAB antenna into the antenna cover Unpacking until the DAB antenna fits in with the After unpacking, check to be sure that you have all the projection inside the antenna cover. following items. 2 Connect the DAB antenna to the DAB ANT. The number in parentheses indicates the quantity of each piece supplied. terminal. • DAB antenna (1) • AM (MW) loop antenna (1) To adjust the DAB ante
ページ10に含まれる内容の要旨
FM ANTENNA AM LOOP Do not connect the AC power cord until all other connections have been made. Connecting AM (MW) and FM Antennas Connecting Speakers Place the antenna away from the unit and adjust its position You can connect the speakers using the speaker cords. for the best reception. 1 2,3 AM (MW) loop antenna 1 (supplied) Red Ò Black  Red 2 FM antenna Speaker Speaker cord cord Black 1 Adjust the position for the FM antenna for the best reception. 2 Connect the supplied AM (MW) loop Right
ページ11に含まれる内容の要旨
Do not connect the AC power cord until all other connections have been made. To remove the speaker grilles Putting the Batteries into the Remote Control The speaker grilles are removable as the illustration below. Insert the batteries—AAA/UM-4/R03—into the remote control by matching the polarity (+ and –) on the batteries Holes Projections with the + and – marking on the battery compartment. When the remote control can no longer operate the unit, replace both batteries at the same time. 1 Speake
ページ12に含まれる内容の要旨
Common Operations UP SEARCH/ SEARCH/ Setting the Clock SCROLL SCROLL PRESET 5 Press UP or DOWN to adjust DOWN UP GROUP the minute, then press SET. / SELECT Before operating the unit any further, first set the unit’s clock. DOWN PRESET When you plug in the power cord, “0:00” starts flashing on GROUP the display. You can set the clock when the unit is in standby mode. On the remote control ONLY: SET • When you press and hold UP or DOWN, the minute indication changes continuously. CLOCK 1 Press
ページ13に含まれる内容の要旨
Continued Turning On the Power Selecting the Source STANDBY/ON To turn on the unit, press STANDBY/ON . To select the source, press CD 6, TAPE 2 3, FM/AM/ The STANDBY lamp on the unit goes off. DAB, or AUX. • When you press the source button—CD 3/8, • When you select CD or TAPE as the source, playback starts TAPE 2 3, FM/AM/DAB, and AUX, the unit automatically. automatically turns on. To operate the CD player, see pages 12 to 15. To operate the tape deck, see page 16. To turn off the unit (on st
ページ14に含まれる内容の要旨
Fade-Out Muting (FADE MUTING) Reinforcing the Bass Sound On the remote control ONLY: You can boost the bass sound. • This function only affects the playback sound, and does not FADE MUTING Press FADE MUTING. affect your recording. The volume level decreases to the minimum level, and “Muting” flashes on the display. On the remote control ONLY: SOUND/HBS To release muting, press FADE MUTING again. The Press and hold SOUND/HBS. volume level resumes to the previous level. • Each time you press and h
ページ15に含まれる内容の要旨
Playing Back Discs Continued This unit has been designed to play back the following Playing Back the Entire Disc—Normal Play discs—CD, CD-R, and CD-RW. You can play back the discs containing the tracks in music 1 Press ) OPEN on top of the unit. CD format or MP3 files in ISO 9660 format. The disc cover opens. • In this instruction, we call a disc recorded MP3 files “MP3 • You can insert a disc while listening to another source. disc,” a folder contains MP3 files “group,” and an MP3 file “track.
ページ16に含まれる内容の要旨
When stop playing audio CD: To go to another track directly using the number buttons Total track number Total playing time On the remote control ONLY: Cursor 123 Pressing the number button(s) before or during play allows you to start playing the 456 track number you want. Ex.: For track number 5, press 5. 78 9 When stop playing MP3 disc: For track number 15, press +10, then Current group number Current track number press 5. 0 +10 For track number 20, press +10 twice, then press 0. To locate a p
ページ17に含まれる内容の要旨
Continued UP SEARCH/ SEARCH/ SCROLL SCROLL When you are programming from MP3 PRESET To go to another track directly using the number DOWN UP GROUP disc buttons / SELECT Pressing PRESET GROUP or PRESET DOWN You can select a track only within a same group. PRESET GROUP GROUP selects the first track of each On the remote control ONLY: group. 123 Pressing the number button(s) before or during play allows you to start playing the 456 4 Repeat step 3 to program other tracks you track number you w
ページ18に含まれる内容の要旨
UP SEARCH/ SEARCH/ To exit from Random Play, press 7 or SCROLL PRESET SCROLL Repeating Tracks—Repeat Play DOWN UP GROUP RANDOM. / SELECT You can have all the tracks, the program or individual track The RND. indicator goes off. DOWN PRESET GROUP currently playing, repeat as many times as you like. • You cannot activate the Random Play function during Program Play. On the remote control ONLY: REPEAT Press REPEAT. /FM MODE • Each time you press the button, Repeat Play Displaying the Remaining Ti
ページ19に含まれる内容の要旨
Playing Back Tapes Playing Back a Tape If no cassette is inserted when you press TAPE ¤ ‹ You can play back type I tapes only. “No TAPE” appears on the display. UP SEARCH/ SEARCH/ SCROLL SCROLL PRESET DOWN UP To stop playing, press 7. GROUP 1 Press PUSH OPEN. / PUSH OPEN SELECT The cassette holder opens. DOWN PRESET GROUP SCROLL DOWN SELECT SCROLL UP 4 7 ¢ UP SEARCH/ SEARCH/ SCROLL SCROLL To fast-wind to the left or to the right, PRESET DOWN UP GROUP press ¢ or 4 (or ¢ or 4 on the / SELECT
ページ20に含まれる内容の要旨
Listening to DAB Broadcast What is DAB? Initial Scanning Digital Audio Broadcasting (DAB) is a radio which carries When you change the source to DAB for the first time, the information in digital format enabling near CD-quality audio unit performs the initial scanning to search for the available sound. Also DAB enables broadcasters to transmit additional stations. data along with the audio. FM/AM/DAB Press FM/AM/DAB repeatedly to select DAB structure “DAB.” DAB is broadcast as groups of data cal
