ページ1に含まれる内容の要旨
MX-KB2[B].book Page 1 Wednesday, April 28, 2004 2:16 PM
COMPACT COMPONENT SYSTEM
CA-MXKB2
CA-MXKB1
INSTRUCTIONS
LVT1251-003A
[B]
ページ2に含まれる内容の要旨
MX-KB2[B].book Page 1 Wednesday, April 28, 2004 2:16 PM Warnings, Cautions and Others IMPORTANT for the U.K. IMPORTANT FOR LASER PRODUCTS DO NOT cut off the mains plug from this equipment. If the plug fit- ted is not suitable for the power points in your home or the cable is 1. CLASS 1 LASER PRODUCT too short to reach a power point, then obtain an appropriate safety 2. CAUTION: Do not open the top cover. There are no user approved extension lead or consult your dealer. serviceable parts insid
ページ3に含まれる内容の要旨
MX-KB2[B].book Page 2 Wednesday, April 28, 2004 2:16 PM SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been disigned and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. ✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮ Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical conne
ページ4に含まれる内容の要旨
MX-KB2[B].book Page 1 Wednesday, April 28, 2004 2:16 PM Introduction Thank you for purchasing the JVC Compact Component System. We hope it will be a valued addition to your home, giving you years of enjoyment. Be sure to read this instruction manual carefully before operating your new stereo system. In it you will find all the information you need to set up and use the system. If you have a query that is not answered by the manual, please contact your dealer. Features Here are some of the th
ページ5に含まれる内容の要旨
MX-KB2[B].book Page 2 Wednesday, April 28, 2004 2:16 PM Table of Contents Introduction ...................................................................................................................1 Features.................................................................................................................................................... 1 How This Manual Is Organized..........................................................................................................
ページ6に含まれる内容の要旨
MX-KB2[B].book Page 3 Wednesday, April 28, 2004 2:16 PM Getting Started Accessories Make sure that you have all of the following items, which are supplied with the System. AM (MW) Loop Antenna (1) Remote Control (1) Batteries (2) If any of these items are missing, contact your dealer immediately. How To Put Batteries In the Remote Control Match the polarity (+ and –) on the batteries with the + and – markings in the battery compartment. R03 (UM-4)/AAA (24F) CAUTION: Handle batteries properl
ページ7に含まれる内容の要旨
MX-KB2[B].book Page 4 Wednesday, April 28, 2004 2:16 PM Getting Started CAUTION: Make all connections before plugging the System into an AC power outlet. About the FM Antenna FM wire antenna FM wire antenna is supplied with the System. Connecting the AM (MW) Antenna Rear Panel of the Unit AM (MW) antenna wire (not supplied) If reception is poor, connect the outside antenna. Turn the loop until you have the best reception. AM (MW) loop antenna (Supplied) Attach the AM (MW) loop to its base
ページ8に含まれる内容の要旨
MX-KB2[B].book Page 5 Wednesday, April 28, 2004 2:16 PM Getting Started Connecting the Speakers Connect the right speaker to the RIGHT speaker terminals and the left speaker to the LEFT speaker terminals. “Right” / “Left” is labeled on the rear of the speaker. 1. Open each of the terminals to connect the speaker wire leads. 2. Connect the speaker cords to the Speaker terminals of the Unit. Connect the red (+) and black (–) cords of the right side speaker to the red (+) and black (–) terminals
ページ9に含まれる内容の要旨
MX-KB2[B].book Page 6 Wednesday, April 28, 2004 2:16 PM Getting Started Connecting to the Wall Outlet Plug the AC power cord into the wall outlet. Now, your System is at your command! DEMO Mode When the System is connected to the wall outlet, a DEMO mode displaying some of the system’s features automatically starts. To turn the DEMO display off, press any of the operation buttons. The DEMO display automatically stops. To turn the DEMO display on, press the DEMO button on the Unit. While the
ページ10に含まれる内容の要旨
MX-KB2[B].book Page 7 Wednesday, April 28, 2004 2:16 PM Basic Operations ) STANDBY/ON STANDBY/ON ECO Numeric keys Display STANDBY indicator SOUND ACTIVE FADE MODE BASS EX. MUTING ACTIVE PHONES BASS EX. VOLUME +,– VOLUME SOUND MODE/ SET Sound Mode Various information indicator ACTIVE BASS EX. indicator Level bar Status bar (Indicates various statuses.) * When the System is in use, the display shows other items as well. For simplicity, we show here only the items described in this section
ページ11に含まれる内容の要旨
MX-KB2[B].book Page 8 Wednesday, April 28, 2004 2:16 PM Basic Operations Adjusting the Volume Selecting the Sound Mode (SOUND MODE) Turn the VOLUME control on the Unit clockwise to increase the volume or turn it counterclockwise to decrease the volume. You can select one of 3 SEA (Sound Effect Amplifier) modes. Press the VOLUME + button on the Remote Control to increase You can use this effect only for playback. the volume or press the VOLUME – button on the Remote Control to decrease the vol
ページ12に含まれる内容の要旨
MX-KB2[B].book Page 9 Wednesday, April 28, 2004 2:16 PM Using the Tuner Numeric keys FM MODE FM/AM FM/AM SET 22 ¢ 4 ¡ Band display, Frequency display, Preset number FM mode indicators * When the System is in use, the display shows other items as well. For simplicity, we show here only the items described in this section. You can listen to FM and AM (MW) stations. Stations can be Manual Tuning tuned in manually, automatically, or from preset memory storage. Briefly press the 22 or ¡ button t
ページ13に含まれる内容の要旨
MX-KB2[B].book Page 10 Wednesday, April 28, 2004 2:16 PM Using the Tuner CAUTION: Even if the System is unplugged or if the power In AM (MW) broadcast, reception sensitivity will be chang- ed by turning the AM (MW) loop antenna. Turn the AM failure occurs, the preset stations will be stored (MW) loop antenna for best reception. for a few days. However, in case the preset sta- tions are erased, you will need to preset the sta- tions again. Presetting Stations To Change the FM Reception You
ページ14に含まれる内容の要旨
MX-KB2[B].book Page 11 Wednesday, April 28, 2004 2:16 PM Using the CD Player CD Open/ Close 0 DISC SKIP REPEAT Numeric keys PROGRAM RANDOM CANCEL MP3 (for CA- SET MXKB2 only) CD 6 REPEAT CD 6 CD1-CD3 CD1-CD3 PROGRAM /RANDOM 22 ¢ 4/1 ¢/¡ ¡ 4 7 7 SOUND MODE/ SET Track number, Playing time, Program number, etc. Program indicator Random indicator Disc indicators Repeat indicator MP3 indicator * When the System is in use, the display shows other items as well. For simplicity, we show here only th
ページ15に含まれる内容の要旨
Body.fm Page 12 Wednesday, April 28, 2004 3:50 PM Using the CD Player About Disc Indicator: To Unload CDs Selected Disc indicator Take out the CD as shown below. Disc Number indicator While the CD Player is stopped, press the CD 1 Disc Rotation indicator Open/Close 0 button on the Unit to open the tray. The Disc indicator consists of the following three kinds of indicators: Remove the CD, then press the DISC SKIP 2 Disc Number indicator: Lights all the time. button on the Unit. Selected Dis
ページ16に含まれる内容の要旨
MX-KB2[B].book Page 13 Wednesday, April 28, 2004 2:16 PM Using the CD Player For MP3 disc (For CA-MXKB2 only) Basics of Using the CD Player- Total group number Total track number Normal Play To Play CDs Load CDs. 1 Press CD 6 button to play. 2 To pause, press the CD 6 button. The playing time indication The currently selected disc number (e.g. “CD DISC 1” ) ap- blinks on the display. pears on the display. To cancel pause, press the CD 6 button again. Play continues The first track of the sele
ページ17に含まれる内容の要旨
Body.fm Page 14 Wednesday, April 28, 2004 5:09 PM Using the CD Player Repeat steps 3 and 4 to program other tracks 5 Programming the Playing Order on the same CD or the other CD. of the Tracks To play the program, Press the CD 6 but- 6 You can program the playing order of the tracks on all the CDs. ton. Note that you can only make a program when the CD Player is For details, see “To Play the Program You Have Made” men- stopped. tioned below. ❏ You can program up to 60 tracks in any desired o
ページ18に含まれる内容の要旨
MX-KB2[B].book Page 15 Wednesday, April 28, 2004 2:16 PM Using the CD Player If you try to open the tray by pressing the 0 button, “LOCKED” appears on the display to let you know that the tray Random Play has been locked. The tracks of the selected CD will play in no special order when Unlocking the Tray you use this mode. Repeat above steps 1 and 2. In Stop mode, set the CD Player in Random 1 “UNLOCKED” appears on the display. Play mode. On the Unit Press the RANDOM button to light the “R
ページ19に含まれる内容の要旨
MX-KB2[B].book Page 16 Wednesday, April 28, 2004 2:16 PM Using the Cassette Deck (Listening to a Tape) TAPE A 3 TAPE B 3 TAPE A 3 TAPE B 3 22 4/1 0 EJECT 0 EJECT ¢/¡ 7 (Deck B) (Deck A) ¡ 7 3: Tape indicator Deck indicators * When the System is in use, the display shows other items as well. For simplicity, we show here only the items described in this section. The Cassette Deck allows you to play, record, and dub audio tapes. Close the cassette holder gently. 3 ❏ Listening to type I tape is
ページ20に含まれる内容の要旨
MX-KB2[B].book Page 17 Wednesday, April 28, 2004 2:16 PM Using the Cassette Deck (Recording) REC START/STOP PROGRAM CD REC START TAPE A 3 TAPE B 3 DUBBING TAPE A 3 TAPE B 3 7 7 0 EJECT 0 EJECT (Deck B) (Deck A) Deck indicators REC indicator 3: Tape indicator * When the System is in use, the display shows other items as well. For simplicity, we show here only the items described in this section. Recording onto a cassette from any of the sound sources is simple. Just place a tape in Deck B, h
