ページ1に含まれる内容の要旨
MICRO COMPONENT SYSTEM
„„• ⁄ˆ⁄˝` ` ˆ—””
UX-P38V Consists of CA-UXP38V and SP-UXP38V
»ˆ—¡˝”· Ø
SP-UXP38V CA-UXP38V SP-UXP38V
COMPACT
COMPACT
DIGITAL VIDEO
DIGITAL AUDIO
INSTRUCTIONS
For Customer Use:
Enter below the Model No. and Serial No.
which are located either on the rear, bot-
tom or side of the cabinet. Retain this
information for future reference.
⁄ Æ„—„
Model No.
Serial No.
ページ2に含まれる内容の要旨
Warnings, Cautions and Others ⁄ ˝⁄˙ˆˆ—˙Ø „ Ł Caution –– STANDBY/ON button! Disconnect the mains plug to shut the power off completely. The STANDBY/ON button in any position does not disconnect the mains line. The power can be remote controlled. ¢ ˝⁄˙ˆˆ—˙Ø § –– ST Ł` ˆ Ø˝`• § „/ » ·! · §»¯ ¡¸¯Œ ¡˝˝¡ Ł˝» · ⁄ˆ Ł˝§˝´ §¶Ł ¡ Ø˝§ Y/O B D N A S T Ł ` ˆ Ø˝`• § „/ » ª„ Ƹ„ · Ł§ `¤— ` ˚ ` ˆ¶ Ł ·¡ ˆ “ ˝` Ł ¿¸¯ Ł˝˚ ´ · Ø „˚ ` ˆ¶ »Ł ·» ª“ · ·´ ˆØ •ˆ¯ ` ⁄˝„ CAUTION CAUTI
ページ3に含まれる内容の要旨
IMPORTANT FOR LASER PRODUCTS ` ⁄˙ `˚ ⁄ ›˚ ¸ˆ ”…¯ ‡– ¯ «˝ˆ REPRODUCTION OF LABELS / / ¡ ˆ• ˚ „ Æ… Ł„'¯ ¡ 2 WARNING LABEL, PLACED INSIDE THE UNIT 1 CLASSIFICATION LABEL, PLACED ON REAR ENCLOSURE 1 » ´Æ”Ø §»ˆ— • Ł · ˙ • §·Ø „¸¯Ø § 2 » ´ Ø ˝„ · ˙ Ø ´ª„˝ »¡ˆ‡ CAUTION: Invisible laser ADVARSEL: Usynlig laser- VARNING: Osynlig laser- VARO: Avattaessa ja suo- radiation when open and stråling ved åbning, når strålning när denna del är jalukitus ohitettae
ページ4に含まれる内容の要旨
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Moisture condensation About This Manual Moisture may condense on the lens inside the unit in the This manual is organized as follows: following cases: • After starting heating in the room • The manual mainly explains operations using the buttons • I
ページ5に含まれる内容の要旨
Contents Location of the Buttons and Controls ....................... 3 Using the Video CD Player (Video CDs) ........................................................... 15 Front Panel ................................................................. 3 Remote Control .......................................................... 5 Setting the TV System.............................................. 15 Playing Video CDs with the PBC Function ............. 15 Getting Started ...........................
ページ6に含まれる内容の要旨
Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Front Panel Front Panel – 3 – EN01-11.UX-P38[US,UB,UN] 3 31/07/2001, 10:25 am English
ページ7に含まれる内容の要旨
Continued Display Window See pages in the parentheses for details. Front Panel Display Window 1 Remote sensor 1 Tape operation indicators 2 STANDBY lamp (9) •2 3 (tape direction) and (reverse mode) indicators 3 STANDBY/ON button (9, 14, 24) 2 Timer indicators 4 TAPE 2 3 button (19 – 20) • (timer), DAILY, REC and SLEEP indicators Pressing this button also turns on the unit. 3 REC indicator 5 CD 3/8 SELECT (play/pause) button (9, 15 – 16, 18) 4 CLOCK indicator Pressing this button also turns on t
ページ8に含まれる内容の要旨
Remote Control Remote Control 1 REPEAT button (14 – 15) 2 DISPLAY button (9) 3 PROG (program) button (13) 4 RANDOM button (13 – 15) 5 SOUND MODE button (10) 6 AUTO PRESET button (11) 7 CD 0 (disc tray open/close) button (12) Pressing this button also turns on the unit. 8 SELECT CD 3/8 button (12 – 13, 15 – 18) Pressing this button also turns on the unit. 9 PREV 4 (reverse search) button (11 – 13, 16) p 7 (stop) button (12 – 14, 16) q CANCEL button (13) w STILL button (17) e ON SCREEN button (18)
ページ9に含まれる内容の要旨
Getting Started Supplied Accessories Connecting Antennas Make sure that you have all the following items. FM antenna The number in the parentheses indicates the quantity of the pieces supplied. • AM loop antenna (1) • FM antenna (1) FM antenna (supplied) • Remote control (1) • Batteries (2) • AC plug adaptor (1) • Video cord (1) If anything is missing, consult your dealer immediately. Putting the Batteries into the Remote Control 1 Attach the FM antenna to the FM 75 Ω COAXIAL terminal. Insert th
ページ10に含まれる内容の要旨
Continued AM antenna Connecting Speakers Red Speaker Speaker cord cord Black Vinyl-covered wire (not supplied) 1 Right Left speaker speaker 1 Press and hold the clamp of the speaker terminal on the rear of the unit. 2 Insert the end of the speaker cord into the terminal. Match the polarity of the speaker terminals: Red (+) to red 2 (+) and black (–) to black (–). AM loop antenna 3 Release the finger from the clamp. (supplied) IMPORTANT: Use only speakers with the same speaker 1 Connect the AM lo
ページ11に含まれる内容の要旨
Continued To connect audio equipment Adjusting the Voltage Selector Be sure that the plugs of the audio cords are colored: White plugs and jacks are for left audio signals, and red ones for right Before plugging in the unit, set the correct voltage for your audio signals. area with the voltage selector on the rear of the unit. To audio output Audio equipment For playing the other equipment through this unit, connect between the audio output jacks on the other Voltage mark equipment and AUX jacks
ページ12に含まれる内容の要旨
Common Operations Turning On the Power 2 Press ¢ NEXT or PREV 4 to adjust the hour, then When you press the play button — CD 3/8 SELECT, TAPE press CLOCK. 23, or the source selecting button — FM/AM and AUX, the The minute digits start flashing on the unit automatically turns on and starts playback if the source is display. ready. To turn on the unit, press STANDBY/ON. The STANDBY lamp on the unit lights green. 3 Press ¢ NEXT or PREV 4 to adjust the minute, then press CLOCK. T
ページ13に含まれる内容の要旨
Selecting the Sources and Starting Play Reinforcing the Bass Sound To playback CDs, press SELECT CD 3/8. (See pages 12 – You can reinforce the bass sound to maintain rich (“AHB 1” 14.) and “AHB 2”), full bass at low volume. This function only affects To playback tapes, press TAPE 2 3. (See page 19.) the playback sound, but does not affect your recording. To listen to the FM/AM broadcasts, press FM/AM. (See page 11.) To get the effect, press AHB (Active Hyper Bass) To select the external equipmen
ページ14に含まれる内容の要旨
Listening to FM and AM Broadcasts Tuning in a Station 3 Repeat steps 1 and 2 to store stations for the other band. 1 Press FM/AM. The unit automatically turns on and tunes in the previously tuned station (either FM or AM). When you cannot automatically store stations you want • Each time you press the button, the band Stations with weak signals cannot be detected with this automatic alternates between FM and AM. presetting. To store such a station, use the manual presetting. 2 Press and hold NEX
ページ15に含まれる内容の要旨
Playing Back CDs (CD/CD-R/CD-RW) This unit has been designed to playback the following CDs: 3 Press SELECT CD 3/8. •CD The disc tray automatically closes and the first • CD-R track of the CD starts playing. • CD-RW Continued use of irregular shape CDs (heart-shape, Track number Elapsed playing time octagonal, etc.) can damage the unit. • The CD automatically stops when the last track of the CD has finished playing. General Notes To stop playing, press 7. In general, you will have the best perfor
ページ16に含まれる内容の要旨
Continued To check the program contents Programming the Playing Order of the Tracks — You can check the program contents on the display by pressing Program Play PREV 4 or ¢ NEXT under stop condition. The programed tracks are shown in the programed order. You can arrange the order in which tracks play before you start playing. You can program up to 50 tracks. To modify the program Before or after playing, you can erase the last On the remote control ONLY: programed track by pressing CANCEL on the
ページ17に含まれる内容の要旨
Repeating Tracks — Repeat Play Prohibiting Disc Ejection — Tray Lock You can have all the tracks, the program or individual track You can lock the disc tray and prohibit to eject the CD. currently playing to repeat as many times as you like. • This is possible only while the unit is turned on. On the remote control ONLY: On the unit ONLY: To repeat playing, press REPEAT before or during To prohibit disc ejection, press playing. STANDBY/ON while holding 7. (If the • Each time you press the button
ページ18に含まれる内容の要旨
Using the Video CD Player (Video CDs) You can play video CDs (with or without the Playback Control (PBC) function) to watch the picture on your TV while listening to the sound through your JVC Micro Component System. • If you play an NTSC CD in PAL AUTO mode on a PAL exclusive TV, the image may be distorted. If this happens change the CD Player’s TV output mode to “PAL”. Before playing video CDs • When you play an NTSC CD in PAL AUTO mode on a multisystem Make sure that the connection between th
ページ19に含まれる内容の要旨
Continued 2. Press the ¢ NEXT/PREV 4 buttons to select the Playing Video CDs with the PBC Function Using item (“SEL XX”) and press the CD 3¥8 SELECT button the Menu Screen (Menu-Driven Play) to play it back. Before playing, make sure that Repeat indicator “ ” or “ ” is not lit. If lit, press the REPEAT button on the ALL Remote Control until “PBC” appears on the display. 1 Load a video CD with PBC. Do not press the SELECT CD 3/8 button yet. On the Remote Control: 1. Press the VCD No +/– button to
ページ20に含まれる内容の要旨
Example of playback using Playback Control (PBC) 1 Menu Screen 2 3 press 1 2 3 1 Moving 1 RETURN 2 2 Picture 3 To next screen press 12 3 12 Moving Moving Moving Moving Still Moving Moving Still RETURN Picture Picture Picture Picture Picture Picture Picture Picture To previous screen press RETURN A selection menu is displayed when you start playing a video Playing video CDs without the PBC Function CD with PBC. The selection menu shows a list of numbers for selection. Some video CDs may show
