ページ1に含まれる内容の要旨
MICRO COMPONENT MD SYSTEM
UX-Z7MD—Consists of CA-UXZ7MD and SP-UXZ7MD
TA/News/Info
INSTRUCTIONS
For Customer Use:
Enter below the Model No. and Serial
No. which are located either on the rear,
bottom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
LVT0900-008A
[A]
UX-Z7MD[A]Cover_f 1 02.7.31, 21:32
ページ2に含まれる内容の要旨
Warnings, Cautions and Others Caution— button! Disconnect the mains plug to shut the power off completely. The button in any position does not disconnect the mains line. The power can be remote controlled. CAUTION To reduce the risk of electrical shocks, fire, etc.: 1. Do not remove screws, covers or cabinet. 2. Do not expose this appliance to rain or moisture. CAUTION • Do not block the ventilation openings or holes. (If the ventilation openings or holes are blocked by a newspaper or cloth, et
ページ3に含まれる内容の要旨
IMPORTANT FOR LASER PRODUCTS REPRODUCTION OF LABELS 1 CLASSIFICATION LABEL ON EXTERIOR SURFACE CLASS 1 LASER PRODUCT 2 WARNING LABEL INSIDE THE UNIT CAUTION: Invisible laser ADVARSEL: Usynlig laser- VARNING: Osynlig laser- VARO: Avattaessa ja suo- stråling ved åbning, når jalukitus ohitettaessa olet radiation when open and strålning när denna del är interlock failed or defeated. sikkerhedsafbrydere er ude öppnad och spärren är alttiina näkymättömälle af funktion. Undgå udsæt- lasers
ページ4に含まれる内容の要旨
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. About This Manual Power sources This manual is organized as follows: • When unplugging the unit from the wall outlet, always pull the plug, not the AC power cord. • This manual mainly explains playback and editing operations using the remote control
ページ5に含まれる内容の要旨
Contents Location of the Buttons .................................. 3 Recording ...................................................... 33 Main Unit ............................................................... 3 Before You Start Recording on an MD ................ 34 Remote Control ...................................................... 5 Setting MD Recording Modes ............................. 36 Recording CD onto an MD—CD Synchronized Getting Started...........................................
ページ6に含まれる内容の要旨
Location of the Buttons Become familiar with the buttons on your unit. Main Unit 1 e 2 r 3 4 t 5 y 6 u 7 i 8 o 9 ; p a q s w d f g Main unit See pages in the parentheses for details. p TAPE @ # (play) button (11, 13, 30) • Pressing this button also turns on the unit. 1 Disc tray (20) q SOUND button (14) 2 Display window (4) w Cassette holder (30) 3 REV.MODE button (25, 30, 39, 40) e Electronic swing panel 4 MD 0 (eject) button (11, 24, 26, 58) r MD loading slot (24) • Pressing this button also t
ページ7に含まれる内容の要旨
Display window on the electronic swing panel 4 9 - 1 2 3 56 7 8 0 = ~ ! Display window See pages in the parentheses for details. 1 CD indicator (21) 2 MD indicator (25) 3 MD recording indicators • MD REC indicator (36, 37, 40, 44 – 50, 52 – 55) • Recording length mode indicators (36) SP, LP2 and LP4 • Recording speed indicators (36) x1, x2 and x4 • Group recording indicator (36) GROUP 4 Tape operation indicators (30, 39, 40) • (reverse mode) and 2 3 (tape direction) 5 TAPE indicator (30) REC ind
ページ8に含まれる内容の要旨
Remote Control 1 Number buttons • 1 – 10, 0 and +10 buttons (12, 18, 21, 25, 26, 44 – 46, 52 – 55) • Character entry buttons (A – Z, 0 – 9) (28, 57) • MARK button (28, 57) • and buttons (15, 28, 52, 56 – 58) t 2 TITLE/EDIT button (52 – 56) 3 GROUP SKIP button (27, 45 – 50) y 1 4 GROUP TITLE/EDIT button (44 – 50, 56) u 5 GROUP SKIP button (27, 45 – 50) 6 LP: button (36) i 7 PLAY MODE button (21, 22, 25 – 27) 2 8 REPEAT button (22, 27) o 3 9 CLOCK/TIMER button (12, 60 – 62) ; p SLEEP button (63
ページ9に含まれる内容の要旨
Getting Started Continued To connect an outdoor FM antenna Unpacking Before connecting it, disconnect the supplied FM antenna. After unpacking, check to be sure that you have all the following items. The number in the parentheses indicates the quantity of the pieces supplied. Outdoor FM antenna (not supplied) • FM antenna (1) • AM loop antenna (1) • Remote control (1) • Batteries (2) If any is missing, consult your dealer immediately. Connecting Antennas FM antenna FM antenna (supplied) A 75 Ω a
ページ10に含まれる内容の要旨
AM antenna Connecting Speakers To connect speakers 1 You can connect the speakers using the speaker cords. 1 2 Speaker terminals 2 3,4 Vinyl-covered wire (not supplied) Black SPEAKERS 3 Red Red R L R L CAUTION: SPEAKER IMPEDANCE 4~16Ω Black Black AM loop antenna (supplied) 1 If cords are covered with insulation, twist the core of Speaker cord the cord at the end of each cord, then remove the insulation. 2 Connect the AM loop antenna to the AM LOOP terminals as illustrated. Rear of the left Rear
ページ11に含まれる内容の要旨
Continued To remove the speaker grilles Connecting External Equipment The speaker grilles are removable as illustrated below: You can connect another equipment which can be used as a playback device. Holes Projections When you connect and use the equipment, refer also to its manual supplied. • DO NOT connect other equipment while the power is on. • DO NOT plug in any equipment until all connections are complete. To connect external equipment Speaker grille Be sure that the plugs of the audio cor
ページ12に含まれる内容の要旨
NOW, you can plug in the unit and other connected Putting the Batteries into the Remote equipment FINALLY! Control Insert the batteries—R6P(SUM-3)/AA(15F)—into the remote control, by matching the polarity (+ and –) on the batteries with the + and – marking on the battery compartment. When the remote control can no longer operate the unit, replace both batteries at the same time. 1 SPEAKERS R L R L CAUTION: SPEAKER IMPEDANCE 4~16Ω To a wall outlet 2 AC power cord When you connect the AC power cor
ページ13に含まれる内容の要旨
Basic and Common Operations The buttons emphasized in the illustration below are used and explained in this section (pages 11 to 15). Remote control Main unit – 10 – EN10-15UX-Z7MD[A]f 10 02.7.31, 21:22
ページ14に含まれる内容の要旨
Turning On the Power Setting the Auto Power Off When you press one of the source selecting buttons, the Using Auto Power Off function, the unit automatically unit automatically turns on (and starts playback if the turns itself off if no sound comes in for more than 3 source is ready). minutes except when FM or AM is selected as the source. If any operation is done during this 3-minute period, Auto On the remote control: Power Off is canceled temporarily even though no sound comes in. On the remo
ページ15に含まれる内容の要旨
Setting the Clock When you unplug the AC power cord or if a power failure occurs You can set the clock whether the unit is turned on or in The clock loses the setting and is reset to “0:00.” If this happens, standby mode. set the clock again. On the remote control ONLY: To turn off the clock indication (power save mode) 1 Press CLOCK/TIMER. Press DISP/CHARA while the unit is in standby mode. “0:00” appears in the main display with the hour digit “DISPLAY OFF” appears in the main display. flashin
ページ16に含まれる内容の要旨
Selecting the Sources and Starting Play Adjusting the Volume To select the tuner or external equipment as the source You can adjust the volume level only while the unit is On the remote control: turned on. Press FM/AM/AUX. • The volume level has no effect on recording. The unit automatically turns on (when the unit is in On the remote control: standby), and the last selected source appears in the main To increase the volume, press VOLUME + . display. To decrease the volume, press VOLUME – . • Ea
ページ17に含まれる内容の要旨
Reinforcing the Bass Sound Selecting the Sound Modes The richness and fullness of the bass sound is clearly You can select one of the 4 preset sound modes. maintained regardless of how low you set the volume • This effect does not affect recording. You can use this —Active Hyper Bass Pro. effect only for playback. • This effect does not affect recording. You can use this • This function also effects the sound from headphones. effect only for playback. To select the sound modes, press SOUND repea
ページ18に含まれる内容の要旨
To create your favorite colors Setting the Display Illumination You can create two favorite colors and store them in You can change the illumination color and brightness of the memory as “MANUAL1” and “MANUAL2.” electronic swing panel and the display window. • There is a time limit in doing the following steps. If the unit exits from the color adjusting mode before you finish, start from step 1 again. To select the illumination color You can select the illumination color by your preference. On t
ページ19に含まれる内容の要旨
Listening to FM and AM Broadcasts The buttons emphasized in the illustration below are used and explained in this section (pages 17 and 18). Remote control Main unit – 16 – EN16-18UX-Z7MD[A]f 16 02.7.31, 21:22
ページ20に含まれる内容の要旨
To change the FM reception mode Tuning in to a Station When an FM stereo broadcast is noisy or hard to receive, you can change the FM reception mode to improve the 1 Press FM/AM/AUX (or FM/AM on the main unit) to reception. select either “FM” or “AM.” On the remote control ONLY: When you press the button for the first time, the unit Press FM MODE. automatically turns on with the last selected source. • Each time you press the button, FM reception mode On the remote control: alternates between ST