ページ1に含まれる内容の要旨
Personal Component System PMC-DR50L/DR70L
3-867-748-11 (1)
Personal
Component
System
GB GB
Operating Instructions page 2
ES ES
Manual de instrucciones página 2
PMC-DR50L
PMC-DR70L
©1999 Sony Corporation
ページ2に含まれる内容の要旨
CAUTION Warning • You can use this player on AC power To prevent fire or shock hazard, do source only. You cannot use it on batteries. not expose the player to rain or When you use this player for the first time, moisture. or when you have not used it for a long time, leave it connected to AC power source for about one hour to charge the To avoid electrical shock, do not open built-in backup battery for the clock, timer, the cabinet. Refer servicing to preset radio stations, etc. You can use the
ページ3に含まれる内容の要旨
Basic Operations Table of contents Basic Operations 4 Playing a CD 6 Listening to the radio 8 Playing a tape 10 Recording on a tape The CD Player The Timer 13 Using the display 28 Setting the clock GB 14 Locating a specific track 30 Waking up to music 15 Playing tracks repeatedly 33 Timer-recording radio (Repeat Play) programmes 16 Playing tracks in random order 36 Falling asleep to music (Shuffle Play) 17 Creating your own programme Setting Up (Programme Play) 37 Hooking up the system (PMC-DR50
ページ4に含まれる内容の要旨
Basic Operations Playing a CD 21 For hookup instructions, see pages 37 - 41 (PMC-DR50L) or pages 42 - 47 (PMC-DR70L). 1 Press Z CD OPEN/CLOSE (direct power-on) and place the CD on the CD tray. With the label side up Display 2 Press u. (On the remote, press N on the CD section.) The CD tray closes and the player Track number Playing time plays all the tracks once. GB 4 Basic Operations
ページ5に含まれる内容の要旨
Basic Operations Use these buttons for additional operations u OPERATE ., > Z CD OPEN/CLOSE x VOLUME –, + Tip To Press Next time you want to adjust the volume VOLUME +, – listen to a CD, just press u. The player turns on (VOL +, – on the remote) automatically and starts stop playback x playing the CD. pause playback u (X on the remote) Press again to resume play after pause. go to the next track > go back to the previous track . remove the CD Z CD OPEN/CLOSE turn on/off the player OPERATE GB Bas
ページ6に含まれる内容の要旨
Listening to the radio 1 2 For hookup instructions, see pages 37 - 41 (PMC-DR50L) or pages 42 - 47 (PMC-DR70L). Display 1 Press BAND until the band you want appears in the display (direct power-on). 2 Hold down TUNE TIME SET + or – (TUNE + or – on the remote) until the frequency digits begin to change in the display. Indicates an FM The player automatically scans stereo broadcast. the radio frequencies and stops when it finds a clear station. If you cannot tune in a station, press the button rep
ページ7に含まれる内容の要旨
Basic Operations Use these buttons for additional operations PLAY MODE OPERATE MONO/ST ISS VOLUME –, + Tips To Press • If the FM broadcast is adjust the volume VOLUME +, – noisy, press PLAY MODE•MONO/ST ISS (VOL +, – on the remote) (MODE on the remote) turn on/off the radio OPERATE until “MONO” appears in the display and the radio will play in To improve broadcast reception monaural. FM: • Next time you want to listen to the radio, just Keep the FM lead aerial as horizontal as possible and press
ページ8に含まれる内容の要旨
Playing a tape 3 1, 2 For hookup instructions, see pages 37 - 41 (PMC-DR50L) or pages 42 - 47 (PMC-DR70L). 1 Press Z PUSH OPEN/CLOSE to With the side you want to play facing up open the tape compartment and insert a recorded tape. Use TYPE I (normal), TYPE II (high position) and TYPE IV (metal) tapes. 2 Press Z PUSH OPEN/CLOSE to close the compartment. 3 Press N. Display (On the remote, press TAPE N.) The player turns on (direct power-on) and starts playing. Tape counter GB 8 Basic Operations
ページ9に含まれる内容の要旨
Basic Operations Use these buttons for additional operations Z PUSH COUNTER RESET OPEN/CLOSE DIR MODE m, M x n OPERATE VOLUME –, + Tips To Press • Press COUNTER RESET adjust the volume VOLUME +, – to reset the counter to “000”. (VOL +, – on the remote) • Next time you want to stop playback x listen to a tape, just press N or n. The play the reverse side n player turns on fast-forward or rewind the tape M or m automatically and starts playing the tape. eject the cassette Z PUSH OPEN/CLOSE turn on
ページ10に含まれる内容の要旨
Recording on a tape 31 3 3 For hookup instructions, see pages 37 - 41 (PMC-DR50L) or pages 42 - 47 (PMC-DR70L). To record on a MiniDisc or DAT recorder, connect the component (see page 48). With the side you want 1 Press Z PUSH OPEN/CLOSE to to record on facing up open the tape compartment, and insert a blank tape. Use TYPE I (normal) tape only. Press Z PUSH OPEN/CLOSE again to close the compartment. 2 Select the programme source you want to record. Display To record from the CD player: Insert a
ページ11に含まれる内容の要旨
Basic Operations 3 Start recording. To record the whole CD Press CD DUBBING. When is displayed: If the the tape is reversed with the recording of the track unfinished, the player will record the track again from its beginning on the reverse side. To record the radio (You can also record the CD according to the following procedure. Play the CD after the tape starts recording.) Press z/X and then N. To record on the reverse side, press n. (On the remote, while keeping m z/X pressed, press TAPE N
ページ12に含まれる内容の要旨
Recording on a tape (continued) Use these buttons for additional operations x DIR MODE z/X PLAY MODE MONO/ST ISS n, N OPERATE Tips To Press • Adjusting the volume or the audio emphasis stop recording x on the tape section (page 52) will not affect pause recording z/X the recording level. Press the button again to • When or is resume recording. displayed, recording will be made on both turn on/off the player OPERATE sides of the tape. To record on one side, press DIR MODE to display To erase a
ページ13に含まれる内容の要旨
The CD Player The CD Player Using the display DISPLAY You can check information about the CD using the display. Checking the total track number and playing time Press DISPLAY in stop mode. Total track number Total playing time Checking the remaining time Press DISPLAY while playing a CD. To display Press DISPLAY the current track number once and the remaining time on the current track* the number of tracks left twice and remaining time on the CD the current track number three times and playing t
ページ14に含まれる内容の要旨
Locating a specific track You can quickly locate any track using the number buttons. You can also find a Number specific point in a track while playing a buttons CD. ., > Note To locate Press You cannot locate a a specific track directly number button of the track. specific track if “SHUF” or “PGM” is lit a point while listening to . or > while playing in the display. Turn off the sound and hold down until you the indication by find the point. pressing x on the CD section. a point while observi
ページ15に含まれる内容の要旨
The CD Player Playing tracks PLAY MODE repeatedly MONO/ST ISS (Repeat Play) You can play tracks repeatedly in normal, single, shuffle or programme ., > play modes (see pages 16 - 18). x u On the remote 1 Press x on the CD section. • Use MODE to select “CD” appears in the display. “REP 1”, “REP ALL”, “REP” “SHUF” or 2 Proceed as follows: “REP” “PGM”. • When you’ve selected To repeat Do this “REP 1”, use the number button to select a single track 1 Press PLAY MODE• the track. MONO/ST ISS until “
ページ16に含まれる内容の要旨
Playing tracks in PLAY MODE random order MONO/ST ISS (Shuffle Play) You can play tracks in random order. x u On the remote 1 Press x on the CD section. 1 Press x on the CD section. “CD” appears in the display. 2 Use MODE to select 2 Press PLAY MODE•MONO/ST ISS until “SHUF” “SHUF”. appears in the display. 3 Press N on the CD section. 3 Press u. To cancel Shuffle Play Press PLAY MODE•MONO/ST ISS until “SHUF” disappears from the display. GB 16 The CD Player
ページ17に含まれる内容の要旨
The CD Player Creating your PLAY MODE own programme MONO/ST ISS ENTER MEM (Programme Play) While listening to the CD, you can select the track you want and arrange the ., > playing order of up to 20 tracks on a CD. x u On the remote 1 Press x on the CD section. 1 Press x on the CD “CD” appears in the display. section. 2 Press MODE to select 2 Press PLAY MODE•MONO/ST ISS until “PGM” “PGM”. appears in the display. 3 Press the number button to select the 3 Press . or > to select the track you want
ページ18に含まれる内容の要旨
Creating your own programme (Programme Play) (continued) Tips To cancel Programme Play • If the programme play Press PLAY MODE•MONO/ST ISS until “PGM” is finished, the disappears from the display. programme is saved. You can play the same programme again by To check the order of tracks before play pressing u. • If you open the CD Press ENTER MEM on the player. tray, the programme is Every time you press the button, the track number erased. appears in the programmed order. • You can record your o
ページ19に含まれる内容の要旨
The Radio The Radio Presetting radio BAND TUNE TIME SET stations –, + You can store radio stations into the player's memory. You can preset up to 30 radio stations, 10 for each band in any ENTER MEM order. PRESET –, + On the remote 1 Press BAND until the band you want appears in 1 Press BAND to select the display. the band. 2 Press TUNE TIME SET + or – to set the frequency 2 Press TUNE + or – to set the frequency to to the station you want. the station you want. 3 Press and hold ENTER MEM for 2
ページ20に含まれる内容の要旨
Playing preset PRESET –, + radio stations Once you've preset the stations, use the number buttons on the remote or PRESET +, – on the player to tune in your favorite stations. BAND On the remote 1 Press BAND to select the band. 1 Press BAND to select 2 Press PRESET + or – to display the preset number the band. of the station you want. 2 Press the number button to display the preset number of the station you want. Preset number GB 20 The Radio
